|
|
Número de pieza | FTRJ1319P1xTL | |
Descripción | Industrial Temperature 2 Gigabit Long-Wavelength Pluggable SFP Transceiver | |
Fabricantes | Finisar | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de FTRJ1319P1xTL (archivo pdf) en la parte inferior de esta página. Total 11 Páginas | ||
No Preview Available ! F i n i st4aU.crom Product Specification
eIndustrial Temperature 2 Gigabit Long-Wavelength
he Pluggable SFP Transceiver
taS FTRJ1319P1xTL
w.DaPRODUCT FEATURES
ww • Up to 2.125Gb/s bi-directional
mdata links
o• Hot-pluggable SFP footprint
.c• Built-in digital diagnostic functions
• 1310nm Fabry-Perot laser
Utransmitter
t4• Duplex LC connector
• Very low jitter
ee• No Rate Select input required for
Fibre Channel 1x/2x Operation
h• Up to 10 km on 9/125µm SMF
S• Metal enclosure, for lower EMI
ta• Single 3.3V power supply
a• Low power dissipation <700mW
typical
.D• Industrial operating temperature
range: -40°C to 85°C
APPLICATIONS
• 1.25Gb/s 1000Base-LX Ethernet
• Dual Rate 1.06 / 2.125 Gb/s Fibre
Channel
wFinisar’s FTRJ1319P1xTL Small Form Factor Pluggable (SFP) transceivers are
wcompatible with the Small Form Factor Pluggable Multi-Sourcing Agreement (MSA)4.
mThey simultaneously comply with Gigabit Ethernet as specified in IEEE Std 802.31 and
w o1x and 2x Fibre Channel as defined in FC-PI 13.03. Digital diagnostics functions are
.cavailable via the 2-wire serial bus specified in the SFP MSA.
t4UPRODUCT SELECTION
heeFTRJ1319P1xTL
ataSx W
.DB
Wide Extraction Bail
Narrow Extraction Bail
www Finisar Corporation December 16, 2003 RevG
Page 1
1 page FTRJ1319P1xTL Industrial Temp. SFP Product Specification – December 2003
Finisar
V. General Specifications
Parameter
Data Rate
Bit Error Rate
Max. Supported Link Length on
9/125µm SMF @ 2X Fibre Channel
Max. Supported Link Length on
9/125µm SMF @ Gigabit Ethernet
Symbol
BR
BER
LMAX1
LMAX2
Min
1062
Typ
10
10
Max
2125
10-12
Units
Mb/sec
km
Ref.
1
2
3, 4
km 3, 4
Notes:
1. Gigabit Ethernet and 1x/2x Fibre Channel compliant.
2. Tested with a PRBS 27-1 test pattern.
3. Dispersion limited per FC-PI Rev. 13
4. Attenuation of 0.55 dB/km is used for the link length calculations. Distances are indicative only.
Please refer to the Optical Specifications in Table IV to calculate a more accurate link budget based on
specific conditions in your application.
VI. Environmental Specifications
Finisar 1310nm Industrial Temperature SFP transceivers have an operating temperature
range from –40°C to +85°C case temperature.
Parameter
Case Operating Temperature
Storage Temperature
Symbol
Min
Typ
Max Units Ref.
Top -40
85 °C
Tsto -40
100 °C
VII. Regulatory Compliance
Finisar transceivers are Class 1 Laser Products and comply with US FDA regulations.
These products are certified by TÜV and CSA to meet the Class 1 eye safety
requirements of EN (IEC) 60825 and the electrical safety requirements of EN (IEC)
60950. Copies of certificates are available at Finisar Corporation upon request.
Finisar Corporation December 16, 2003 RevG
Page 5
5 Page FTRJ1319P1xTL Industrial Temp. SFP Product Specification – December 2003
Finisar
XI. References
1. IEEE Std 802.3, 2002 Edition, Clause 38, PMD Type 1000BASE-LX.
IEEE Standards Department, 2002.
2. “Fibre Channel Physical and Signaling Interface (FC-PH, FC-PH2, FC-PH3)”.
American National Standard for Information Systems.
3. “Fibre Channel Draft Physical Interface Specification (FC-PI 13.0)”. American
National Standard for Information Systems.
4. Small Form-factor Pluggable (SFP) Transceiver Multi-source Agreement (MSA),
September 14, 2000.
XII. For More Information
Finisar Corporation
1308 Moffett Park Drive
Sunnyvale, CA 94089-1133
Tel. 1-408-548-1000
Fax 1-408-541-6138
www.finisar.com
Finisar Corporation December 16, 2003 RevG
Page 11
11 Page |
Páginas | Total 11 Páginas | |
PDF Descargar | [ Datasheet FTRJ1319P1xTL.PDF ] |
Número de pieza | Descripción | Fabricantes |
FTRJ1319P1xTL | Industrial Temperature 2 Gigabit Long-Wavelength Pluggable SFP Transceiver | Finisar |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |