|
|
PDF ICS507-xx Data sheet ( Hoja de datos )
| Número de pieza | ICS507-xx | |
| Descripción | PECL Clock Synthesizer | |
| Fabricantes | Integrated Circuit Systems | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de ICS507-xx (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
|
No Preview Available !
ICS507-01/02
PECL Clock Synthesizer
Description
The ICS507-01 and ICS507-02 are inexpensive
ways to generate a low jitter 155.52 MHz (or other
high speed) differential PECL clock output from a
low frequency crystal input. Using Phase-Locked-
Loop (PLL) techniques, the devices use a standard
fundamental mode crystal to produce output
clocks up to 200 MHz.
Stored in each chip’s ROM is the ability to
generate a selection of different multiples of the
input reference frequency, including an exact
155.52 MHz clock from common crystals. For
lowest jitter and phase noise on a 155.52 MHz
clock, a 19.44 MHz crystal and the x8 selection
can be used.
Features
• Packaged as 16 pin narrow SOIC or die
• Input crystal frequency of 5 - 27 MHz
• Input clock frequency of 5 - 52 MHz
• Uses low-cost crystal
• Differential PECL output clock frequencies up
to 200 MHz
• Duty cycle of 49/51
• 3.3 V or 5.0 V±10% operating supply
• Ideal for SONET applications and oscillator
manufacturers
• Advanced, low power CMOS process
• Industrial temperature versions available
Block Diagram
GND
VDD 1.1kΩ
RES
S0:1 2
Crystal
or
clock
X1
X2
Clock
Buffer/
Crystal
Oscillator
Clock Synthesis
and Control
Circuitry
Output
Buffer
Output
Buffer
Output resistor values shown are for unterminated lines.
Refer to MAN09 for additional information.
Output Enable
(both outputs)
270Ω
PECL
62Ω
VDD
62Ω
PECL
270Ω
MDS 507 C
1
Revision 042600
Printed 11/13/00
Integrated Circuit Systems, Inc. • 525 Race Street • San Jose •CA •95126• (408)295-9800tel • www.icst.com
1 page  
ICS507-01/02
PECL Clock Synthesizer
Package Outline and Package Dimensions
(For current dimensional specifications, see JEDEC Publication No. 95.)
INDEX
AREA
12
D
EH
h x 45°
16 pin SOIC narrow
Symbol
A
A1
B
C
D
E
e
H
h
L
Inches
Min Max
0.0532 0.0688
0.0040 0.0098
0.0130 0.0200
0.0075 0.0098
0.3859 0.3937
0.1497 0.1574
.050 BSC
0.2284 0.2440
0.0099 0.0195
0.0160 0.0500
Millimeters
Min Max
1.35 1.75
0.10 0.24
0.33 0.51
0.19 0.24
9.80 10.00
3.80 4.00
1.27 BSC
5.80 6.20
0.25 0.50
0.41 1.27
A1
e
C
B
A
L
Ordering Information
Part/Order Number
ICS507M-01
ICS507M-01T
ICS507M-01I
ICS507M-01IT
ICS507-01-DSW
ICS507-01-DPK
ICS507-01-DWF
ICS507M-02I
ICS507M-02IT
Marking
Package
Temperature
ICS507M-01
16 pin narrow SOIC
0 to 70°C
ICS507M-01 16 pin SOIC on tape and reel 0 to 70°C
ICS507M-01I
16 pin narrow SOIC
-40 to 85°C
ICS507M-01I 16 pin SOIC on tape and reel -40 to 85°C
- Probed wafers, cut, on sticky tape 0 to 70°C
-
Tested die in waffle pack
0 to 70°C
- Die on uncut, probed wafers 0 to 70°C
ICS507M-02I
16 pin narrow SOIC
-40 to 85°C
ICS507M-02I 16 pin SOIC on tape and reel -40 to 85°C
Minimum
Quantities
-
2500 pieces
-
2500 pieces
1 wafer
1000 pieces
1 wafer
-
2500 pieces
While the information presented herein has been checked for both accuracy and reliability, Integrated Circuit Systems, Incorporated (ICS) assumes no responsibility for either its
use or for the infringement of any patents or other rights of third parties, which would result from its use. No other circuits, patents, or licenses are implied. This product is
intended for use in normal commercial applications. Any other applications such as those requiring extended temperature range, high reliability, or other extraordinary
environmental requirements are not recommended without additional processing by ICS. ICS reserves the right to change any circuitry or specifications without notice. ICS does
not authorize or warrant any ICS product for use in life support devices or critical medical instruments.
MDS 507 C
5
Revision 042600
Printed 11/13/00
Integrated Circuit Systems, Inc. • 525 Race Street • San Jose •CA •95126• (408)295-9800tel • www.icst.com
5 Page | ||
| Páginas | Total 5 Páginas | |
| PDF Descargar | [ Datasheet ICS507-xx.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| ICS507-xx | PECL Clock Synthesizer | Integrated Circuit Systems |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |