DataSheet.es    


PDF UDN2585 Data sheet ( Hoja de datos )

Número de pieza UDN2585
Descripción 8-CHANNEL SOURCE DRIVERS
Fabricantes Allegro MicroSystems 
Logotipo Allegro MicroSystems Logotipo



Hay una vista previa y un enlace de descarga de UDN2585 (archivo pdf) en la parte inferior de esta página.


Total 12 Páginas

No Preview Available ! UDN2585 Hoja de datos, Descripción, Manual

2580, 2585,
AND 2588
UDN2580A and UDN2585A
ABSOLUTE MAXIMUM RATINGS
See next page.
8-CHANNEL SOURCE DRIVERS
This versatile family of integrated circuits will work with many combina-
tions of logic- and load-voltage levels, meeting interface requirements beyond
the capabilities of standard logic buffers. Series UDN2580A and A2580SLW
source drivers can drive incandescent, LED, or vacuum fluorescent displays.
Internal transient-suppression diodes permit the drivers to be used with
inductive loads such as relays, solenoids, dc and stepping motors, and mag-
netic print hammers.
The Types UDN2580A and A2580SLW are high-current source drivers
used to switch the ground ends of loads that are directly connected to a -50 V
supply. Typical loads are telephone relays, PIN diodes, and LEDs.
The UDN2585A and A2585SLW are drivers designed for applications
requiring low output saturation voltages. Typical loads are low-voltage LEDs
and incandescent displays. The eight non-Darlington, 25 V outputs will
simultaneously sustain continuous load currents of -120 mA at ambient
temperatures to +70°C.
The UDN2588A and A2588SLW have separate logic and driver supply
lines. Their eight drivers can serve as an interface between positive logic
(TTL, CMOS, PMOS) or negative logic (NMOS) and either negative or split-
load supplies to -80 V.
These drivers are packaged in plastic DlPs (suffix A) or surface-mount-
able wide-body SOlCs (suffix LW), and are rated for operation over the
temperature range of -20°C to +85°C.
FEATURES
I TTL, CMOS, PMOS, NMOS Compatible
I High Output-Current Rating
I Internal Transient Suppression
I Efficient Input /Output Structure
I Through-Hole and Surface-Mount Packages
Always order by complete part number, e.g., UDN2580A .

1 page




UDN2585 pdf
2580, 2585, AND 2588
8-CHANNEL
SOURCE DRIVERS
UDN2585A and A2585SLW
ELECTRICAL CHARACTERISTICS at TA = +25°C, VS = 0 V, VEE = -20 V (unless otherwise noted).
Characteristic
Output Leakage
Current
Output Sustaining
Voltage
Output Saturation
Voltage
Input Current
Input Voltage
Clamp Diode
Leakage Current
Symbol
ICEX
VCE(SUS)
VCE(SAT)
IIN(ON)
VIN(ON)
VIN(OFF)
IR
Test Conditions
VlN = -0.5 V, VOUT = VEE = -25 V
VlN = -0.4 V, VOUT = VEE = -25 V, TA = 70°C
VlN = -0.4 V, IOUT = -25 mA, Note 1
VlN = -4.6 V, IOUT = -60 mA
VlN = -4.6 V, IOUT = -120 mA
VlN = -4.6 V, IOUT = -120 mA
VlN = -14.6 V, IOUT = -120 mA
IOUT = -120 mA, VCE 1.2 V, Note 3
IOUT = -100 µA, TA = 70°C
VR = 25 V, TA = 70°C
Min.
15
-0.4
Limits
Max.
50
100
1.1
1.2
-1.6
-5.0
-4.6
50
Units
µA
µA
V
V
V
mA
mA
V
V
µA
Clamp Diode
VF IF = 120 mA
Forward Voltage
2.0
V
Input Capacitance
Turn-On Delay
Turn-Off Delay
CIN
tPHL
tPLH
0.5 EIN to 0.5 EOUT
0.5 EIN to 0.5 EOUT
25 pF
5.0 µs
5.0 µs
NOTES: 1. Pulsed test, tp 300 µs, duty cycle 2%.
2. Negative current is defined as coming out of the specified device pin.
3. The VIN(ON) voltage limit guarantees a minimum output source current per the specified conditions.
4. The substrate must always be tied to the most negative point and must be at least 4.0 V below VS.
PARTIAL SCHEMATIC
UDN2585A
A2585SLW
www.allegromicro.com
Dwg. No. A-11,360
1
2
3
4
5
6
7
8
+VS 9
10 NC
Dwg. No. A-11,359
20
19
18
17
16
15
14
13
SUB
12
NC 11
SUB/VEE
Dwg. PP-064
5

5 Page





UDN2585 arduino
2580, 2585, AND 2588
8-CHANNEL
SOURCE DRIVERS
20
0.280
0.240
1
0.070
0.045
0.210
MAX
0.015
MIN
0.022
0.014
20
7.11
6.10
1
1.77
1.15
5.33
MAX
0.39
MIN
0.558
0.356
UDN2588A
Dimensions in Inches
(controlling dimensions)
11
0.014
0.008
0.430
MAX
0.300
BSC
1.060
0.980
10
0.100
0.005
BSC
MIN
0.150
0.115
Dimensions in Millimeters
(for reference only)
11
26.92
24.89
10
2.54
0.13
BSC
MIN
Dwg. MA-001-20 in
0.355
0.204
10.92
MAX
7.62
BSC
3.81
2.93
Dwg. MA-001-20 mm
NOTES: 1. Exact body and lead configuration at vendors option within limits shown.
2. Lead spacing tolerance is non-cumulative.
3. Lead thickness is measured at seating plane or below..
4. Supplied in standard sticks/tubes of 18 devices.
www.allegromicro.com
11

11 Page







PáginasTotal 12 Páginas
PDF Descargar[ Datasheet UDN2585.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
UDN25808-CHANNEL SOURCE DRIVERSAllegro MicroSystems
Allegro MicroSystems
UDN2580A8-CHANNEL SOURCE DRIVERSAllegro MicroSystems
Allegro MicroSystems
UDN25858-CHANNEL SOURCE DRIVERSAllegro MicroSystems
Allegro MicroSystems
UDN25888-CHANNEL SOURCE DRIVERSAllegro MicroSystems
Allegro MicroSystems

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar