DataSheet.es    


PDF XR-C8220 Data sheet ( Hoja de datos )

Número de pieza XR-C8220
Descripción SERVICE MANUAL
Fabricantes Sony 
Logotipo Sony Logotipo



Hay una vista previa y un enlace de descarga de XR-C8220 (archivo pdf) en la parte inferior de esta página.


Total 14 Páginas

No Preview Available ! XR-C8220 Hoja de datos, Descripción, Manual

SERVICE MANUAL
XR-C8220
US Model
E Model
For RM-X4S (Remote Commander),
please refer to RM-X4S Service Manual
(9-925-698-) previously issued.
Dolby noise reduction manufactured under license
from Dolby Laboratories Licensing Corporation.
“DOLBY” and the double-D symbol a are trade-
marks of Dolby Laboratories Licensing Corporation.
Model Name Using Similar Mechanism
Tape Transport Mechanism Type
XR-C9100
MG-25D-136
SPECIFICATIONS
MICROFILM
FM/AM CASSETTE CAR STEREO

1 page




XR-C8220 pdf
6-11. SCHEMATIC DIAGRAM – MAIN Section (4/4) – • See page 49 for IC Block Diagrams.
(Page
34)
(Page
38)
– 39 –
(Page 36)
XR-C8220
– 40 –
(Page 46)
(Page 46)
(Page 46)
(Page 46)

5 Page





XR-C8220 arduino
6-16. IC PIN FUNCTION DESCRIPTION
MAIN BOARD IC600 MB90574PFV-G-182-BND (SYSTEM CONTROLLER)
Pin No. Pin Name I/O
Function
Seek control signal output to the FM/AM tuner unit (TUX10)
1
SEEKOUT
O AM mode: Used for IF count output/SD output request/AGC cut at SEEK or BTM
FM mode: Used for SD speed up at SEEK, BTM, or AF
“L” is output at tuner off
2
AF-SEEK
O PLL low-pass filter time constant selection signal output at AF SEEK
“H” is output when AF SEEK Not used (open)
IF band select signal output to the FM/AM tuner unit (TUX10) “H”: wide mode
3
WIDE
O
In receiving FM signals, interference noise from adjacent stations is removed by narrowing the
IF band automatically in the tuner unit so as to raise the selectivity, but in this case, the distortion
may increase and accordingly, the IF band is widened forcibly
FM stereo broadcasting detection signal input from the FM/AM tuner unit (TUX10), or forced
4 ST-MONO I/O monaural control signal output to the FM/AM tuner unit (TUX10)
“L” is input in the FM stereo mode, or “L” is output in the forced monaural mode
5 TUNMUTE O Muting on/off control signal output of the FM and AM tuner signal “H”: muting on
6
FM-ON
O
FM system power supply on/off control signal output to the BA3918 (IC502)
“L”: AM power on, “H”: FM power on
7
TU-ON
O
Tuner system power supply on/off control signal output to the BA3918 (IC502)
“H”: tuner power on
8
VCC
— Power supply terminal (+5V)
9
CSV-RST
O Reset signal output to the CSV (IC650) “L”: reset
10
BUS-ON
O Bus on/off control signal output to the SONY bus interface (IC602) “L”: bus on
11
SYSRST
O Reset signal output to the SONY bus interface (IC602) “L”: reset
12
DOORSW
I Front panel open/close detection signal input “L” is input when the front panel is closed
13
LCD SO
O Serial data output to the liquid crystal display driver (IC900)
14
LCD CKO
O Serial data transfer clock signal output to the liquid crystal display driver (IC900)
15
BEEP
O Beep sound drive signal output terminal
16
LCD CE
O Chip enable signal output to the liquid crystal display driver (IC900) “H” active
17
UNISI
I Serial data input from the SONY bus interface (IC602)
18
UNISO
O Serial data output to the SONY bus interface (IC602)
19
UNICKO
O Serial data transfer clock signal output to the SONY bus interface (IC602)
20
SD-IN
I
Station detector detect input from the FM/AM tuner unit (TUX10)
Stop level for SEEK, BTM, etc. is determined SD is present at input of “H”
21
CSV-SO
O Serial data output to the CSV (IC650)
22
CSV-CKO
O Serial data transfer clock signal output to the CSV (IC650)
23
CSV-CE
O Chip enable signal output to the CSV (IC650) “L” active
24
SIRCS
I Sircs remote control signal input from the remote control receiver (IC901)
25
PLLSI
I PLL serial data input from the FM/AM PLL (IC10)
26
PLLSO
O PLL serial data output to the FM/AM PLL (IC10)
27
PLLCKO
O PLL serial data transfer clock signal output to the FM/AM PLL (IC10)
28
PLLCE
O PLL chip enable signal output to the FM/AM PLL (IC10) “H” active
Power on/off control signal output of the illumination LED and liquid crystal display driver
29
ILL-ON
(IC900) “H”: power on Depends on initial setting of power select switch (S600)
O Power select switch (S600) on: “H” output at the accessory on
Power select switch (S600) off: “H” output at the power on
Dimmer control in/out terminal
30
DIMMER
I/O At initial mode: The presence of dimmer select function is set (if this status, if “L” is input, the
dimmer select function is present)
At normal mode: LCD back light brightness control signal output
31
TIR-IND
O LED drive signal output of the TIR indicator “H”: LED on Not used (open)
– 50 –

11 Page







PáginasTotal 14 Páginas
PDF Descargar[ Datasheet XR-C8220.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
XR-C8220SERVICE MANUALSony
Sony

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar