|
|
PDF TAVE150 Data sheet ( Hoja de datos )
| Número de pieza | TAVE150 | |
| Descripción | Service Menual | |
| Fabricantes | Sony | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de TAVE150 (archivo pdf) en la parte inferior de esta página. Total 25 Páginas | ||
|
No Preview Available !
SERVICE MANUAL
TA-VE150
AEP Model
UK Model
This amplifier has the Dolby Surround system.
Manufactured under license from Dolby Laborato-
ries Licensing Corporation.
“Dolby”, the double-D symbol a and “Pro Logic” are
trademarks of Dolby Laboratories Licensing Corpo-
ration.
Amplifier section
Power output
Stereo mode
Surround mode
(DIN 1 kHz, 8 ohms)
25 W + 25 W
(DIN 1 kHz, 8 ohms)
Front: 25 W/ch
Centre: 25 W
Rear: 25 W/ch
SPECIFICATIONS
Outputs
Muting
BASS BOOST
VIDEO (AUDIO OUT):
Voltage 200 mV,
Inpedance 10 kilohms
WOOFER/AUDIO OUT:
Voltage: 2 V
Impedance: 1 kilohms
Full mute
+9 dB at 70 Hz
5.1 CH
INPUT/DVD mode
(DIN 1 kHz, 8 ohms)
Front: 25 W/ch
Centre: 25 W
Rear: 25 W/ch
Frequency response
TV, VIDEO, DVD-2CH,
5.1 CH INPUT/DVD:
20 Hz-50 kHz ± 1 dB
Inputs
Sensitivity Impedance S/N
(weighting network, input level)
TV, VIDEO, DVD-2CH,
5.1 CH INPUT/DVD
200 mV 50
82 dB*
kilohms (A, 150 mV)
General
Power requirements
230 V AC, 50/60 Hz
Power consumption
115 W
Dimensions
430 × 274 × 64.5 mm
Mass (Approx.)
5.4 kg
Supplied accessories
Remote controller
(remote) (1)
Size AA (R6) batteries (2)
Scart adaptor (1)
Design and specifications are subject to change without notice.
*’78 IHF
Specifications indicated are measured at 230 VAC, 50 HZ.
INTEGRATED AV AMPLIFIER
MICROFILM
www.rtv-horvat-dj.hr
1 page  
SECTION 3
TEST MODE
This equipment is provided with a test mode built in the micro-
computer. The contents are described in the following.
[Initial Mode]
1. Press I/u button while pressing both [VIDEO] and
[5.1CH INPUT, DVD] buttons simultaneously.
2. “INITIAL” is displayed on the fluorescent indicator tube, and
the status of the unit is set in the following.
• All Memory is clear.
• Center, rear level set to 0.
• Center mode set to Phantom.
• DBFB clear.
• Muting clear.
• Volume level set to min.
[Factory Mode]
1. Press I/u button while pressing three buttons of [TV],
[DVD, 2CH], and [5.1CH INPUT, DVD] simultaneously.
2. Factory setting same as initial except center mode set to nor-
mal using jog can set to volume max or min directly.
[FL Check Mode]
1. Press I/u button while both [CENTER MODE] and [VIDEO]
buttons simultaneously.
2. Fluorescent indicator tube and LED are checked, “FINISH” is
displayed and the status of the unit is set back in normal con-
dition.
[Gain Up Mode]
1. Press I/u button while pressing [SURROUND MODE] but-
ton.
2. “GAIN UP” is displayed on the fluorescent indicator tube and
the rear is gained up 3 dB.
3. To exit from this mode, press two buttons in the same manner
as step1.
“NORMAL” is displayed on the fluorescent indicator tube and
the status of the unit is set back in normal condition.
[Version Mode]
1. Press I/u button while pressing both [CENTER MODE] and
[SURROUND MODE] buttons simultaneously.
2. Version of its destination is displayed on the fluorescent indi-
cator tube.
www.rtv-horvat-dj.hr
–5–
5 Page 
TA-VE150
4-3. SCHEMATIC DIAGRAM – MAIN Section (1/2) – • See page 8 for Waveform. • See page 9 for IC Block Diagrams.
The components identified by mark ! or dotted
line with mark ! are critical for safety.
Replace only with part number specified.
(Page 15)
– 13 –
– 14 –
(Page 19)
(Page 15)
11 Page | ||
| Páginas | Total 25 Páginas | |
| PDF Descargar | [ Datasheet TAVE150.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| TAVE150 | Service Menual | Sony |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |