DataSheet.es    


PDF OPA357 Data sheet ( Hoja de datos )

Número de pieza OPA357
Descripción 3V Video Amplifier with 6dB Gain and Filter in SC70
Fabricantes Burr-Brown 
Logotipo Burr-Brown Logotipo



Hay una vista previa y un enlace de descarga de OPA357 (archivo pdf) en la parte inferior de esta página.


Total 23 Páginas

No Preview Available ! OPA357 Hoja de datos, Descripción, Manual

www.DataSheet4U.com
OPA357
OPA2357
SBOS235C − MARCH 2002− REVISED MAY 2004
250MHz, Rail-to-Rail I/O, CMOS
Operational Amplifier with Shutdown
FEATURES
DESCRIPTION
D UNITY-GAIN BANDWIDTH: 250MHz
D WIDE BANDWIDTH: 100MHz GBW
The OPA357 series of high-speed, voltage-feedback
CMOS operational amplifiers are designed for video and
other applications requiring wide bandwidth. They are
D HIGH SLEW RATE: 150V/ms
unity-gain stable and can drive large output currents.
D LOW NOISE: 6.5nV/Hz
D RAIL-TO-RAIL I/O
D HIGH OUTPUT CURRENT: > 100mA
D EXCELLENT VIDEO PERFORMANCE:
Diff Gain: 0.02%, Diff Phase: 0.095
Differential gain is 0.02% and differential phase is 0.09°.
Quiescent current is only 4.9mA per channel.
The OPA357 series op amps are optimized for operation
on single or dual supplies as low as 2.5V (±1.25V) and up
to 5.5V (±2.75V). Common-mode input range extends
beyond the supplies. The output swing is within 100mV of
0.1dB Gain Flatness: 40MHz
the rails, supporting wide dynamic range.
D LOW INPUT BIAS CURRENT: 3pA
For applications requiring the full 100mA continuous
D QUIESCENT CURRENT: 4.9mA
output current, the single SO-8 PowerPAD version is
D THERMAL SHUTDOWN
available.
D SUPPLY RANGE: 2.5V to 5.5V
The single version (OPA357), comes in the miniature
D SHUTDOWN IQ < 6mA
SOT23-6 and SO-8 PowerPAD packages. The dual
version (OPA2357) is offered in the MSOP-10 package. DataShee
D
MicroSIZE
AND
PowerPAD
PACKAGDESataSheet4U.Tcciohrcmeuitdryuafolr
version features completely independent
lowest crosstalk and freedom from interaction.
All are specified over the extended −40°C to +125°C
temperature range.
APPLICATIONS
D VIDEO PROCESSING
D ULTRASOUND
D OPTICAL NETWORKING, TUNABLE LASERS
D PHOTODIODE TRANSIMPEDANCE AMPS
D ACTIVE FILTERS
D HIGH-SPEED INTEGRATORS
D ANALOG-TO-DIGITAL (A/D) CONVERTER
INPUT BUFFERS
D DIGITAL-TO-ANALOG (D/A) CONVERTER
OUTPUT AMPLIFIERS
D BARCODE SCANNERS
D COMMUNICATIONS
OPAx357 RELATED PRODUCTS
FEATURES
PRODUCT
Non-Shutdown Version of OPA357 Family
OPAx354
200MHz GBW, Rail-to-Rail Output, CMOS, Shutdown OPAx355
200MHz GBW, Rail-to-Rail Output, CMOS
OPAx356
38MHz GBW, Rail-to-Rail Input/Output, CMOS
OPAx350/3
75MHz BW G = 2, Rail-to-Rail Output
OPAx631
150MHz BW G = 2, Rail-to-Rail Output
OPAx634
100MHz BW, Differential Input/Output, 3.3V Supply THS412x
VIN
+VIN
V+
OPA357
VOUT
VEnable
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments
semiconductor products and disclaimers thereto appears at the end of this data sheet.
DataSheet4U.coAlml trademarks are the property of their respective owners.
PRODUCTION DATA information is current as of publication date. Products
conform to specifications per the terms of Texas Instruments standard warranty.
Production processing does not necessarily include testing of all parameters.
Copyright 2002-2004, Texas Instruments Incorporated
DataSheet4 U .com
www.ti.com

1 page




OPA357 pdf
www.DataSheet4U.com
www.ti.com
OPA357
OPA2357
SBOS235C − MARCH 2002− REVISED MAY 2004
TYPICAL CHARACTERISTICS
At TA = +25°C, VS = 5V, G = +1, RF = 0, RL = 1k, and connected to VS/2, unless otherwise noted.
et4U.com
NONINVERTING SMALL−SIGNAL
FREQUENCY RESPONSE
3
VO = 0.1VPP
0
G = +1
RF = 25
G = +2, RF = 604
3
G = +5, RF = 604
6
G = +10, RF = 604
9
12
15
100k
1M
10M
100M
Frequency (Hz)
1G
NONINVERTING SMALL−SIGNAL STEP RESPONSE
INVERTING SMALL−SIGNAL
FREQUENCY RESPONSE
3
VO = 0.1VPP, RF = 604
0
3
G = 1
6
G = 5
G = 2
9
G = 10
12
15
100k
1M
10M
100M
Frequency (Hz)
1G
NONINVERTING LARGE−SIGNAL STEP RESPONSE
DataSheet4U.com
DataShee
Time (20ns/div)
LARGE−SIGNAL DISABLE/ENABLE RESPONSE
Enabled
Disabled
VOUT
fIN = 5MHz
Time (200ns/div)
4.5
3.5
2.5
1.5
0.5
Time (20ns/div)
0.5
VO = 0.1VPP
0.4
0.1dB GAIN FLATNESS
0.3
G = +1
0.2 RF = 25
0.1
0
0.1
0.2
0.3
0.4
G = +2
RF = 604
0.5
100k
1M
10M
100M
Frequency (Hz)
1G
DataSheet4U.com
DataSheet4 U .com
5

5 Page





OPA357 arduino
www.DataSheet4U.com
www.ti.com
OPA357
OPA2357
SBOS235C − MARCH 2002− REVISED MAY 2004
et4U.com
APPLICATIONS INFORMATION
The OPA357 is a CMOS, rail-to-rail I/O, high-speed,
voltage-feedback operational amplifier designed for video,
high-speed, and other applications. It is available as a
single or dual op amp.
The amplifier features a 100MHz gain bandwidth, and
150V/µs slew rate, but it is unity-gain stable and can be
operated as a +1V/V voltage follower.
The Enable input can be modeled as a CMOS input gate
with a 100kpull-up resistor to V+. This pin should be
connected to a valid high or low voltage or driven, not left
open circuit.
The enable time is 100ns and the disable time is only 30ns.
This allows the OPA357 to be operated as a gated
amplifier, or to have its output multiplexed onto a common
output bus. When disabled, the output assumes a
high-impedance state.
OPERATING VOLTAGE
The OPA357 is specified over a power-supply range of
+2.7V to +5.5V (±1.35V to ±2.75V). However, the supply
voltage may range from +2.5V to +5.5V (±1.25V to
±2.75V). Supply voltages higher than 7.5V (absolute
maximum) can permanently damage the amplifier.
RAIL-TO-RAIL INPUT
The specified input common-mode voltage range of the
OPA357 extends 100mV beyond the supply rails. This is
achieved with a complementary input stagean
N-channel input differential pair in parallel with a
P-channel differential pair, as shown in Figure 1. The
Parameters that vary over supply voltage or temperature
are shown in the Typical Characteristics section of this
data sheet.
N-channel pair is active for input voltages close to the
positive rail, typically (V+) − 1.2V to 100mV above the
positive supply, while the P-channel pair is on for inputs
from 100mV below the negative supply to approximately
ENABLE FUNCTION
(V+) − 1.2V. There is a small transition region, typically
(V+) − 1.5V to (V+) − 0.9V, in which both pairs are on. This
The OPA357’s Enable function is implemented using a
600mV transition region can vary ±500mV with process
Schmitt trigger. The amplifier is enabled by applying a TTL
variation. Thus, the transition region (both input stages on)
HIGH voltage level (referenced to V−) to the Enable pin.
can range from (V+) − 2.0V to (V+) − 1.5V on the low end,
Conversely, a TTL LOW voltage level (referenced to V−)
will disable the amplifier, reducing its supply current from
up to (V+) − 0.9V to (V+) − 0.4V on the high end.
DataShee
4.9mA to only 3.4µA per amplifier. Independent Enable
A double-folded cascode adds the signal from the two
pins are available for each channel (dual DvaertasiSohn)e,et4U.icnopmut pairs and presents a differential signal to the class AB
providing maximum design flexibility. For portable
output stage.
battery-operated applications, this feature can be used to
greatly reduce the average current and thereby extend
battery life.
V+
Reference
Current
VIN+
VIN
VBIAS1
VBIAS2
Class AB
Control
Circuitry
VO
DataSheet4U.com
V
(Ground)
DataSheet4 U .com
Figure 1. Simplified Schematic
11

11 Page







PáginasTotal 23 Páginas
PDF Descargar[ Datasheet OPA357.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
OPA350OPAx350 High-Speed Single-Supply Rail-to-Rail Operational Amplifiers MicroAmplifier Series (Rev. D)Texas Instruments
Texas Instruments
OPA350High-Speed / Single-Supply / Rail-to-Rail OPERATIONAL AMPLIFIERS MicroAmplifier SeriesBurr-Brown
Burr-Brown
OPA353High-Speed Single-Supply Rail-to-Rail Op Amps MicroAmplifierTexas Instruments
Texas Instruments
OPA353High-Speed / Single-Supply / Rail-to-Rail OPERATIONAL AMPLIFIERS MicroAmplifier SeriesBurr-Brown
Burr-Brown

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar