|
|
PDF OP213 Data sheet ( Hoja de datos )
| Número de pieza | OP213 | |
| Descripción | Low Noise / Low Drift Single-Supply Operational Amplifiers | |
| Fabricantes | Analog Devices | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de OP213 (archivo pdf) en la parte inferior de esta página. Total 24 Páginas | ||
|
No Preview Available !
Low Noise, Low Drift
Single-Supply Operational Amplifiers
OP113/OP213/OP413
FEATURES
Single- or dual-supply operation
Low noise: 4.7 nV/√Hz @ 1 kHz
Wide bandwidth: 3.4 MHz
Low offset voltage: 100 μV
Very low drift: 0.2 μV/°C
Unity gain stable
No phase reversal
APPLICATIONS
Digital scales
Multimedia
Strain gages
Battery-powered instrumentation
Temperature transducer amplifier
GENERAL DESCRIPTION
The OPx13 family of single-supply operational amplifiers
features both low noise and drift. It has been designed for
systems with internal calibration. Often these processor-based
systems are capable of calibrating corrections for offset and
gain, but they cannot correct for temperature drifts and noise.
Optimized for these parameters, the OPx13 family can be used
to take advantage of superior analog performance combined
with digital correction. Many systems using internal calibration
operate from unipolar supplies, usually either 5 V or 12 V. The
OPx13 family is designed to operate from single supplies from
4 V to 36 V and to maintain its low noise and precision
performance.
The OPx13 family is unity gain stable and has a typical gain
bandwidth product of 3.4 MHz. Slew rate is in excess of 1 V/μs.
Noise density is a very low 4.7 nV/√Hz, and noise in the 0.1 Hz
to 10 Hz band is 120 nV p-p. Input offset voltage is guaranteed
and offset drift is guaranteed to be less than 0.8 μV/°C. Input
common-mode range includes the negative supply and to
within 1 V of the positive supply over the full supply range.
Phase reversal protection is designed into the OPx13 family for
cases where input voltage range is exceeded. Output voltage
swings also include the negative supply and go to within 1 V of
the positive rail. The output is capable of sinking and sourcing
current throughout its range and is specified with 600 Ω loads.
PIN CONFIGURATIONS
NULL 1
–IN A 2
+IN A 3
V– 4
OP113
TOP VIEW
(Not to Scale)
8 NC
7 V+
6 OUT A
5 NULL
NC = NO CONNECT
Figure 1. 8-Lead Narrow-Body
SOIC_N
OUT A 1
–IN A 2
+IN A 3
V– 4
OP213
TOP VIEW
(Not to Scale)
8 V+
7 OUT B
6 –IN B
5 +IN B
Figure 2. 8-Lead Narrow-Body
SOIC_N
OUT A 1
–IN A 2
+IN A 3
V– 4
OP213
8 V+
7 OUT B
6 –IN B
5 +IN B
Figure 3. 8-Lead PDIP
OUT A 1
–IN A 2
+IN A 3
V+ 4
+IN B 5
–IN B 6
OUT B 7
NC 8
OP413
TOP VIEW
(Not to Scale)
16 OUT D
15 –IN D
14 +IN D
13 V–
12 +IN C
11 –IN C
10 OUT C
9 NC
NC = NO CONNECT
Figure 4. 16-Lead Wide-Body
SOIC_W
Digital scales and other strain gage applications benefit from
the very low noise and low drift of the OPx13 family. Other
applications include use as a buffer or amplifier for both analog-
to-digital (ADC) and digital-to-analog (DAC) sigma-delta
converters. Often these converters have high resolutions
requiring the lowest noise amplifier to utilize their full
potential. Many of these converters operate in either single-
supply or low-supply voltage systems, and attaining the greater
signal swing possible increases system performance.
The OPx13 family is specified for single 5 V and dual ±15 V
operation over the XIND—extended industrial temperature
range (–40°C to +85°C). They are available in PDIP and SOIC
surface-mount packages.
Rev. F
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarksandregisteredtrademarksarethepropertyoftheirrespectiveowners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
www.analog.com
Fax: 781.461.3113 ©1993–2007 Analog Devices, Inc. All rights reserved.
1 page  
OP113/OP213/OP413
Parameter
OUTPUT CHARACTERISTICS
Output Voltage Swing High
Output Voltage Swing Low
Short-Circuit Limit
POWER SUPPLY
Supply Current
AUDIO PERFORMANCE
THD + Noise
Voltage Noise Density
Current Noise Density
Voltage Noise
DYNAMIC PERFORMANCE
Slew Rate
Gain Bandwidth Product
Settling Time
Symbol
VOH
VOL
ISC
ISY
ISY
en
in
en p-p
SR
GBP
tS
Conditions
RL = 600 kΩ
RL = 100 kΩ,
−40°C ≤ TA ≤ +85°C
RL = 600 Ω,
−40°C ≤ TA ≤ +85°C
RL = 600 Ω,
−40°C ≤ TA ≤ +85°C
RL = 100 kΩ,
−40°C ≤ TA ≤ +85°C
VOUT = 2.0 V, no load
–40°C ≤ TA ≤ +85°C
VOUT = 0 dBu, f = 1 kHz
f = 10 Hz
f = 1 kHz
f = 1 kHz
0.1 Hz to 10 Hz
RL = 2 kΩ
to 0.01%, 2 V step
E Grade
F Grade
Min Typ Max Min Typ Max Unit
4.0 4.0 V
4.1 4.1 V
3.9 3.9 V
8
8
±30
8
8
±30
mV
mV
mA
1.6 2.7
3.0
2.7 mA
3.0 mA
0.001
9
4.7
0.45
120
0.001
9
4.7
0.45
120
%
nV/√Hz
nV/√Hz
pA/√Hz
nV p-p
0.6 0.9
3.5
5.8
0.6
3.5
5.8
V/μs
MHz
μs
1 Long-term offset voltage is guaranteed by a 1000 hour life test performed on three independent lots at 125°C, with an LTPD of 1.3.
2 Guaranteed specifications, based on characterization data.
Rev. F | Page 5 of 24
5 Page 
140
TA = 25°C
VS = ±15V
120
100
+PSRR
80
60
–PSRR
40
20
0
100 1k 10k 100k 1M
FREQUENCY (Hz)
Figure 29. Power Supply Rejection vs. Frequency @ ±15 V
6
VS = 5V
RL = 2kΩ
5
TA = 25°C
AVCL = 1
4
3
2
1
0
1k 10k 100k 1M 10M
FREQUENCY (Hz)
Figure 30. Maximum Output Swing vs. Frequency @ 5 V
50
VS = 5V
45 RL = 2kΩ
VIN = 100mV p-p
40 TA = 25°C
AVCL = 1
35
30
25 NEGATIVE
EDGE
20
15
POSITIVE
EDGE
10
5
0
0 100 200 300 400 500
LOAD CAPACITANCE (pF)
Figure 31. Small-Signal Overshoot vs. Load Capacitance @ 5 V
OP113/OP213/OP413
40
TA = 25°C
VS = ±15V
30
20
AV = 100
10
AV = 10
AV = 1
0
100
1k
10k 100k
1M
FREQUENCY (Hz)
Figure 32. Closed-Loop Output Impedance vs. Frequency @ ±15 V
30
VS = ±15V
RL = 2kΩ
25
TA = 25°C
AVOL = 1
20
15
10
5
0
1k 10k 100k 1M 10M
FREQUENCY (Hz)
Figure 33. Maximum Output Swing vs. Frequency @ ±15 V
20
VS = ±15V
18 RL = 2kΩ
VIN = 100mV p-p
16 TA = 25°C
AVCL = 1
14
12
10
8
POSITIVE
EDGE
NEGATIVE
EDGE
6
4
2
0
0 100 200 300 400 500
LOAD CAPACITANCE (pF)
Figure 34. Small-Signal Overshoot vs. Load Capacitance @ ±15 V
Rev. F | Page 11 of 24
11 Page | ||
| Páginas | Total 24 Páginas | |
| PDF Descargar | [ Datasheet OP213.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| OP21 | Low Power Operational Amplifier | Analog Devices |
| OP213 | Low Noise / Low Drift Single-Supply Operational Amplifiers | Analog Devices |
| OP215 | DUAL PRECISION JFET-INPUT OPERATIONAL AMPLIFIER | Analog Devices |
| OP2177 | Precision Low Noise / Low Input Bias Current Operational Amplifiers | Analog Devices |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |