DataSheet.es    


PDF DS1302 Data sheet ( Hoja de datos )

Número de pieza DS1302
Descripción Trickle Charge Timekeeping Chip
Fabricantes Dallas 
Logotipo Dallas Logotipo



Hay una vista previa y un enlace de descarga de DS1302 (archivo pdf) en la parte inferior de esta página.


Total 16 Páginas

No Preview Available ! DS1302 Hoja de datos, Descripción, Manual

DS1302
Trickle-Charge Timekeeping Chip
www.maxim-ic.com
FEATURES
Real-Time Clock Counts Seconds, Minutes,
Hours, Date of the Month, Month, Day of the
Week, and Year with Leap-Year
Compensation Valid Up to 2100
31 x 8 RAM for Scratchpad Data Storage
Serial I/O for Minimum Pin Count
2.0V to 5.5V Full Operation
Uses Less than 300nA at 2.0V
Single-Byte or Multiple-Byte (Burst Mode)
Data Transfer for Read or Write of Clock or
RAM Data
8-Pin DIP or Optional 8-Pin SO for Surface
Mount
Simple 3-Wire Interface
TTL-Compatible (VCC = 5V)
Optional Industrial Temperature Range:
-40°C to +85°C
DS1202 Compatible
Underwriters Laboratory (UL) Recognized
ORDERING INFORMATION
PART
TEMP RANGE PIN-PACKAGE
DS1302
DS1302+
0°C to +70°C
0°C to +70°C
8 PDIP (300 mils)
8 PDIP (300 mils)
DS1302N
-40°C to +85°C 8 PDIP (300 mils)
DS1302N+
DS1302S
-40°C to +85°C 8 PDIP (300 mils)
0°C to +70°C 8 SO (208 mils)
DS1302S+
0°C to +70°C 8 SO (208 mils)
DS1302SN
DS1302SN+
-40°C to +85°C 8 SO (208 mils)
-40°C to +85°C 8 SO (208 mils)
DS1302Z
0°C to +70°C 8 SO (150 mils)
DS1302Z+
DS1302ZN
0°C to +70°C 8 SO (150 mils)
-40°C to +85°C 8 SO (150 mils)
DS1302ZN+
-40°C to +85°C 8 SO (150 mils)
DS1302S-16
0°C to +70°C 16 SO (300 mils)
DS1302SN-16 -40°C to +85°C 16 SO (300 mils)
TOP MARK*
DS1302
DS1302
DS1302
DS1302
DS1302S
DS1302S
DS1302S
DS1302S
DS1302Z
DS1302Z
DS1302ZN
DS1302ZN
DS1302S16
DS1302SN16
+ Denotes a lead-free/RoHS-compliant device.
*An N anywhere on the top mark indicates an industrial temperature grade
device. A + anywhere on the top mark indicates a lead-free device.
PIN CONFIGURATIONS
TOP VIEW
VCC2
X1
X2
GND
1
2
3
4
8 VCC1
7 SCLK
6 I/O
5 CE
DIP (300mils)
VCC2
X1
X2
GND
1
2
3
4
8 VCC1
7 SCLK
6 I/O
5 CE
SO (208 mils/150 mils)
VCC2
N.C.
X1
N.C.
X2
N.C.
N.C.
GND
1
2
3
4
5
6
7
8
16 VCC1
15 N.C.
14 SCLK
13 N.C.
12 I/O
11 N.C.
10 N.C.
9 CE
SO (300 mils)
Note: Some revisions of this device may incorporate deviations from published specifications known as errata. Multiple revisions of any device
may be simultaneously available through various sales channels. For information about device errata, click here: www.maxim-ic.com/errata.
1 of 16
REV: 110805

1 page




DS1302 pdf
DS1302 Trickle-Charge Timekeeping Chip
OSCILLATOR CIRCUIT
The DS1302 uses an external 32.768kHz crystal. The oscillator circuit does not require any external resistors or
capacitors to operate. Table 1 specifies several crystal parameters for the external crystal. Figure 2 shows a
functional schematic of the oscillator circuit. If using a crystal with the specified characteristics, the startup time is
usually less than one second.
CLOCK ACCURACY
The accuracy of the clock is dependent upon the accuracy of the crystal and the accuracy of the match between
the capacitive load of the oscillator circuit and the capacitive load for which the crystal was trimmed. Additional
error will be added by crystal frequency drift caused by temperature shifts. External circuit noise coupled into the
oscillator circuit may result in the clock running fast. Figure 3 shows a typical PC board layout for isolating the
crystal and oscillator from noise. Refer to Application Note 58: Crystal Considerations for Dallas Real-Time Clocks
for detailed information.
Table 1. Crystal Specifications*
PARAMETER
SYMBOL MIN
Nominal Frequency
fO
Series Resistance
ESR
Load Capacitance
CL
TYP
32.768
6
MAX
45
UNITS
kHz
k
pF
*The crystal, traces, and crystal input pins should be isolated from RF generating signals. Refer to
Application Note 58: Crystal Considerations for Dallas Real-Time Clocks for additional specifications.
Figure 2. Oscillator Circuit Showing Internal Bias Network
RTC
COUNTDOWN
CHAIN
CL1 CL2 RTC
REGISTERS
X1 X2
CRYSTAL
Figure 3. Typical PC Board Layout for Crystal
LOCAL GROUND PLANE (LAYER 2)
CRYSTAL
X1
X2
NOTE: AVOID ROUTING SIGNALS IN THE
CROSSHATCHED AREA (UPPER LEFT-
HAND QUADRANT) OF THE PACKAGE
UNLESS THERE IS A GROUND PLANE
BETWEEN THE SIGNAL LINE AND THE
PACKAGE.
GND
5 of 16

5 Page





DS1302 arduino
CAPACITANCE
(TA = +25°C)
PARAMETER
Input Capacitance
I/O Capacitance
DS1302 Trickle-Charge Timekeeping Chip
SYMBOL MIN TYP MAX UNITS
CI 10 pF
CI/O 15 pF
AC ELECTRICAL CHARACTERISTICS
(TA = 0°C to +70°C or TA = -40°C to +85°C.) (Note 1)
PARAMETER
SYMBOL
Data to CLK Setup
CLK to Data Hold
CLK to Data Delay
CLK Low Time
CLK High Time
CLK Frequency
CLK Rise and Fall
CE to CLK Setup
CLK to CE Hold
CE Inactive Time
CE to I/O High Impedance
SCLK to I/O High Impedance
tDC
tCDH
tCDD
tCL
tCH
tCLK
tR, tF
tCC
tCCH
tCWH
tCDZ
tCCZ
VCC = 2.0V
VCC = 5V
VCC = 2.0V
VCC = 5V
VCC = 2.0V
VCC = 5V
VCC = 2.0V
VCC = 5V
VCC = 2.0V
VCC = 5V
VCC = 2.0V
VCC = 5V
VCC = 2.0V
VCC = 5V
VCC = 2.0V
VCC = 5V
VCC = 2.0V
VCC = 5V
VCC = 2.0V
VCC = 5V
VCC = 2.0V
VCC = 5V
VCC = 2.0V
VCC = 5V
CONDITIONS
(Note 6)
(Note 6)
(Notes 6, 7, 8)
(Note 6)
(Note 6)
(Note 6)
(Note 6)
(Note 6)
(Note 6)
(Note 6)
(Note 6)
MIN
200
50
280
70
1000
250
1000
250
DC
4
1
240
60
4
1
TYP
MAX
800
200
0.5
2.0
2000
500
280
70
280
70
UNITS
ns
ns
ns
ns
ns
MHz
ns
µs
ns
µs
ns
ns
Note 1:
Note 2:
Note 3:
Note 4:
Note 5:
Note 6:
Note 7:
Note 8:
Note 9:
Note 10:
Note 11:
Note 12:
Note 13:
Limits at -40°C are guaranteed by design and are not production tested.
All voltages are referenced to ground.
ICC1T and ICC2T are specified with I/O open, CE and SCLK set to a logic 0.
ICC1A and ICC2A are specified with the I/O pin open, CE high, SCLK = 2MHz at VCC = 5V; SCLK = 500kHz, VCC = 2.0V.
CE, SCLK, and I/O all have 40kpulldown resistors to ground.
Measured at VIH = 2.0V or VIL = 0.8V and 10ns maximum rise and fall time.
Measured at VOH = 2.4V or VOL = 0.4V.
Load capacitance = 50pF.
ICC1S and ICC2S are specified with CE, I/O, and SCLK open.
VCC = VCC2, when VCC2 > VCC1 + 0.2V; VCC = VCC1, when VCC1 > VCC2.
VCC2 = 0V.
VCC1 = 0V.
Typical values are at +25°C.
11 of 16

11 Page







PáginasTotal 16 Páginas
PDF Descargar[ Datasheet DS1302.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
DS1300-3AC-DC / Distributed Power Front-End 2UEmerson
Emerson
DS1302Trickle-Charge Timekeeping ChipMaxim Integrated
Maxim Integrated
DS1302Trickle Charge Timekeeping ChipDallas
Dallas
DS1302Trickle Charge Timekeeping ChipTGS
TGS

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar