|
|
Número de pieza | LB1669 | |
Descripción | 2-Phase Unipolar Brushless Motor Driver | |
Fabricantes | Sanyo | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de LB1669 (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
No Preview Available ! Ordering number: EN3513A
Monolithic Digital IC
LB1669, 1669M
2-Phase Unipolar Brushless Motor Driver
Overview
The LB1669, 1669M are 2-phase uniploar brushless motor
drivers. They make it possible to configure motor lock
protection and automatic recovery circuits with few extenal
components.
Package Dimensions
unit : mm
3098A-DIP10S
[LB1669]
Features and Functions
. Hall element direct connection possible
. Output transistor with 1.5 A output current built in
. Rotation detect function (Drive mode: ‘‘L’’, Stop mode:
. ‘‘H’’) built in
Motor lock protection and automatic recovery functions built
in
. Thermal shutdown circuit built in
. DIP-10S and MFP-10S packages mean small mounting
. surfaces.
Pin compatible with LB1663, so can replace 12 V types.
SANYO : DIP10S
unit : mm
3086A-MFP10S
[LB1669M]
SANYO : MFP10S
SANYO Electric Co.,Ltd. Semiconductor Bussiness Headquarters
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110 JAPAN
D3096HA(II)/7120TA(GTPS) No.3513-1/5
1 page LB1669, 1669M
(4) Output protection function (C pin)
Capacitor pin used in forming an automatic recovery circuit. If rotation is stopped due to overload, the pin voltage level
increases and then forces the output to become inactive. In this case, after proper load adjustment, the output returns to the
‘drive’ mode from the ‘stop’ mode automatically. By changing the capacitor value, the lock detect time period can be set.
For 1 µF lock detection time about 2 seconds
lock protection time (output ON) about 1 second
(output OFF) about 6 seconds
Rotation Output on
Lock
Output off
Output on
Output off
Lock released
Automatic Recovery Circuit C Pin Voltage
Rotation
1 When a fan is rotating, the capacitor is charged at 3 µA (typ) and discharged through the C with pulses according to the
rotational speed.
2 When a fan is locked, no discharge occurs through the C and the C voltage rises, turning OFF the output at 0.8 × VIN.
3 When the output is turned OFF, discharge occurs through the C at 0.44 µA (typ). If the lock is not released when the C
voltage drops to VTH2, the capacitor is charged to VTH1 again. (At this moment, the output is turned ON.)
These operations 2 and 3 are repeated at a cycle of approximately ton : toff = 1 : 6 to protect the motor.
4 If the lock is released when the C voltage drops to VTH2, the output is turned ON, starting rotation.
(5) Rotation detect signal (RD pin)
Open collector output (Drive mode: ‘‘L’’, Stop mode: ‘‘H’’)
(6) Radio noise reducing (pins B1 and B2)
These are the base pins for Darlington connected output transistors.
If radio noise is a problem, add a capacitor of 0.01 to 0.1µF or less.
(7) Thermal shutdown function
Shutdown the driver output in case of coil short-circuiting and abnormal IC heating.
No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment,
nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of which may directly or
indirectly cause injury, death or property loss.
Anyone purchasing any products described or contained herein for an above-mentioned use shall:
1 Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors
and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and
expenses associated with such use:
2 Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on SANYO
ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees jointly or severally.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for volume
production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use
or any infringements of intellectual property rights or other rights of third parties.
This catalog provides information as of December, 1996. Specifications and information herein are subject to change without notice.
No.3513-5/5
5 Page |
Páginas | Total 5 Páginas | |
PDF Descargar | [ Datasheet LB1669.PDF ] |
Número de pieza | Descripción | Fabricantes |
LB1660 | 2-Phase Unipolar Brushless Motor Drivers | Sanyo |
LB1660N | 2-Phase Unipolar Brushless Motor Drivers | Sanyo |
LB1661 | 2-Phase Unipolar Brushless Motor Drivers | Sanyo |
LB1662D | DC Fan Motor Drivers | Sanyo |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |