|
|
PDF KA3504 Data sheet ( Hoja de datos )
| Número de pieza | KA3504 | |
| Descripción | PC SMPS Supervisory IC | |
| Fabricantes | Fairchild | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de KA3504 (archivo pdf) en la parte inferior de esta página. Total 12 Páginas | ||
|
No Preview Available !
KA3504
PC SMPS Supervisory IC
www.fairchildsemi.com
Features
• PC Power Supply Output Monitor Circuitry
• Few External Components
• Over Voltage Protection for 3.3V/5V/12V Output
• Over Current Protection for 3.3V/5V/12V Output With
Delay Time
• Fault Protection Output With Open Collector Output
• Power Supply on/off Delay Time Control (PSON)
• Power Good Signal Generator With Hysteresis
• Open Collector PG Output
• 300ms Power Good Delay
• Current Sense Setting Function With RI
• Latch Function Controlled by PSON and Protection Input
• 16-Pin Dual In-line Package
FPO (Fault Protection Output)
Fault Protection Output indicates the fault condition as
protection signal. When fault state occurs, the main power is
to be turned-off and the PGO signal goes LOW.
NORMAL = "LOW", FAULT = "HIGH"
PGO (Power Good Output)
Power Good Signal Generator is to monitor the voltage level
of power supply for safe operation of a microprocessor
having some delay time at turn-on. The delay time is
prorammed by a timing capacitor connected to TPG pin of
KA3504. The power good output should be low state before
the output voltage is out of regulation at turn-off.
NORMAL = "HIGH", FAULT = "LOW"
Description
The KA3504 is complete output supervisory circuitry
intended for use in the secondary side of the switched mode
power supply. It provides all the functions necessary to
monitor and control the output of the power supply system.
Power good signal generator, Remote on and off control,
some precision protection features against over-voltage and
over-current are implemented. It directly senses all the
output rails for OVP without any external dividers. As for
output control, power good output (PGO) and Fault
Protection output (FPO) are also included. Utilizing a
minimum number of external components, the KA3504
offers a simple and cost effective solution, greatly reducing
PCB board space for power supply system.
OCP (Over Current Protection)
It has precision OCP functions for +3.3V, +5V, +12V
outputs. The block is made up of three comparators with
current source setting function. Two inputs of each OCP
comparator are connected to both sides of output inductor
that is located in the secondary output of SMPS.
OVP (Over Voltage Protection)
It has OVP functions for +3.3V, +5V, +12V outputs.
The circuit is made up of a comparator with three detecting
inputs.
Remote ON/OFF
Remote on/off section is used to control SMPS externally.
If a high signal is supplied to the remote on/off input, FPO
signal becomes a high state and all secondary outputs are
grounded. The remote on/off signal is transferred with some
on-delay and off-delay time of 8ms, 24ms respectively with
0.1µF external capacitor.
16-DIP
1
©2002 Fairchild Semiconductor Corporation
Rev. 1.0.1
1 page  
KA3504
Electrical Characteristics
(VCC = 20V, -25°C < Ta < 85°C, unless otherwise specified)
Characteristic
Symbol
PROTECTION SECTION
Over Voltage Protection for 3.3V
VOVP33
Over Voltage Protection for 5V
VOVP5
Over Voltage Protection for 12V
VOVP12
Offset Voltage of OCP Comparator
Voffset
Charging Current for OCP Delay
ICHG(PROT)
3.3, 5, 12V Over Current Delay Time
TD(OCP)
POWER SUPPLU ON/OFF SECTION (PSON) Note
PSON Input Threshold Voltage
VTH(PSON)
PSON Open Voltage
VOPEN(PSON)
PSON Input Low Current
ILOW(PSON)
ON Delay Time
TON(PSON)
OFF Delay Time
TOFF(PSON)
FPO SECTION
FPO Saturation Voltage
VSAT(FPO)
FPO Leakage Current
VLKG(FPO)
Test Conditions
VPSON = 0V
VPSON = 0V
VPSON = 0V
VPSON = 0V
-
C = 0.47µF
PSON: "H" → "L"
PSON: Open
VPSON = 0V
C = 0.1µF
C = 0.1µF
IFPO = 10mA
VFPO = 20V
Min.
3.9
5.7
13.6
-3
-15
24
1
4
-
4
16
-
-
Typ. Max. Unit
4.1 4.3
V
6.1 6.5
V
14.3 15.0
V
- 3 mV
-21 -30
µA
38 57 msec
1.4 1.8
V
- 5.25 V
- -1.6 mA
8 14 msec
24 34 msec
0.2 0.4
0.01 1
V
µA
Electrical Characteristics
(VCC = 20V, -25°C < Ta < 85°C, unless otherwise specified)
Characteristic
POWER GOOD SECTION
PG Input Threshold Voltage
Hysteresis Voltage 1
Hysteresis Voltage 2
Charging Current for PG Delay
PG Delay Time
PG Output Saturation Voltage
TOTAL DEVICE
Stand-by Supply Current
Symbol
Test Conditions Min. Typ. Max. Unit
VIN(PG1)
HY1
HY2
ICHG(PG)
TD(PG)
VSAT(PG)
PG: "H"→"L"
COMP7
COMP4, 6, 8
-
C = 2.2µF
IPG = 10mA
1.20 1.25 1.30
V
10 40 80 mV
0.6 1.2
-
V
-9 -14 -22 µA
150 270 450 msec
- 0.2 0.4 V
ICC - - 5 10 mA
Note:
1. It does TTL operation and its threshold voltage is 1.4V.
2. Power Supply ON Delay Time (Ton) is measured as PSON input goes "Low" to "High".
3. Power Supply OFF Delay Time (Toff) is measured as PSON input goes "High" to "Low".
5
5 Page 
Mechanical Dimensions
Package
6.40 ±0.20
0.252 ±0.008
16-DIP
#1 #16
KA3504
Dimensions in millimeters
#8
7.62
0.300
#9
3.25 ±0.20
0.128 ±0.008
5.08
0.200
MAX
0~15°
0.25
+0.10
–0.05
0.010
+0.004
–0.002
0.38
0.014
MIN
3.30 ±0.30
0.130 ±0.012
11
11 Page | ||
| Páginas | Total 12 Páginas | |
| PDF Descargar | [ Datasheet KA3504.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| KA350 | 3-Terminal 3A Positive Adjustable Voltage Regulator | Fairchild |
| KA3501 | PC SMPS Supervisory IC | Fairchild |
| KA3502 | PC SMPS Supervisory IC | Fairchild |
| KA3504 | PC SMPS Supervisory IC | Fairchild |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |