DataSheet.es    


PDF EL2003CM Data sheet ( Hoja de datos )

Número de pieza EL2003CM
Descripción 100MHz Video Line Driver
Fabricantes Elantec 
Logotipo Elantec Logotipo



Hay una vista previa y un enlace de descarga de EL2003CM (archivo pdf) en la parte inferior de esta página.


Total 17 Páginas

No Preview Available ! EL2003CM Hoja de datos, Descripción, Manual

EL2003C, EL2033C
100MHz Video Line Driver
Features
• Differential gain 0.1%
• Differential phase 0.1°
• 100mA continuous output current
guaranteed
• Short circuit protected
• Wide bandwidth - 100MHz
• High slew rate - 1200V/µs
• High input impedance - 2M
• Low quiescent current drain
Applications
• Co-ax cable driver
• Flash converter driver
• Video DAC buffer
• Op amp booster
Ordering Information
Part No.
EL2003CN
EL2003CM
EL2033CN
Package
8-Pin PDIP
20-Lead SOL
8-Pin PDIP
Tape & Reel
Outline#
MDP0031
MDP0027
MDP0031
General Description
The EL2003C and EL2033C are general purpose monolithic unity
gain buffers featuring 100MHz, -3dB bandwidth and 4ns small signal
rise time. These buffers are capable of delivering a ±100mA current to
a resistive load and are oscillation free into capacitive loads. In addi-
tion, the EL2003C and EL2033C have internal output short circuit
current limiting which will protect the devices under both a DC fault
condition and AC operation with reactive loads. The extremely fast
slew rate of 1200V/µs, wide bandwidth, and high output drive make
the EL2003C and EL2033C ideal choices for closed loop buffer appli-
cations with wide band op amps. These same characteristics and
excellent DC performance make the EL2003C and EL2033C excellent
choices for open loop applications such as driving coaxial and twisted
pair cables.
The EL2003C and EL2033C are constructed using Elantec's propri-
etary dielectric isolation process that produces PNP and NPN
transistors with essentially identical AC and DC characteristics.
Connection Diagrams
EL2003CN
EL2033CN
EL2003CM
Note: All information contained in this data sheet has been carefully checked and is believed to be accurate as of the date of publication; however, this data sheet cannot be a “controlled document”. Current revisions, if any, to these
specifications are maintained at the factory and are available upon your request. We recommend checking the revision level before finalization of your design documentation.
© 2001 Elantec Semiconductor, Inc.

1 page




EL2003CM pdf
Maximum Undistorted
Output Voltage
vs Frequency
EL2003C, EL2033C
100MHz Video Line Driver
Power Supply Rejection
Ratio vs Frequency
Rise Time
vs Temperature
Slew Rate
vs Supply Voltage
Slew Rate
vs Temperature
Slew Rate
vs Capacitive Load
Output Resistance
vs Supply Voltage
Small Signal
Output Resistance
vs DC Output Current
Output Impedance
vs Frequency
5

5 Page





EL2003CM arduino
EL2003C, EL2033C
100MHz Video Line Driver
impedance of the EL2003C or EL2033C is less than
10from DC to about 10MHz, but a capacitive load of
1000pF will generate about 45° phase shift at 10MHz
and make high speed op amps unstable. Obviously more
capacitance will cause the same problem but at lower
frequencies, and slower op amps as well would become
unstable.
The easiest way to drive capacitive loads is to isolate
them from the feedback with a series resistor. Ten to
twenty ohms is usually enough but the final value
depends on the op amp used and the range of load
capacitance.
If the system requirements will not tolerate the isolation
resistor, then additional high frequency feedback from
the op amp output (the buffer input) and an isolating
resistor from the buffer output is required. This requires
that the op amp be unity gain stable.
Complex Feedback with the Buffer to Drive Capacitive Loads
This works with any unity gain stable OA.
Snubber Circuit (51470 pF) is optional.
Op Amp Booster with Capacitive Load
10is enough isolation and speed
is determined by the isolation
resistor and capacitive load time
constant.
CL
10pF
470pF
tr
17ns
20ns
0.001µF
30ns
0.005µF
80ns
0.01µF
220ns
0.05µF
1.1µs
0.1µF
2.2µs
OS
10%
50%
35%
0
0
0
0
11

11 Page







PáginasTotal 17 Páginas
PDF Descargar[ Datasheet EL2003CM.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
EL2003C100MHz Video Line DriverElantec
Elantec
EL2003CM100MHz Video Line DriverElantec
Elantec
EL2003CN100MHz Video Line DriverElantec
Elantec

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar