|
|
PDF TDA7326D Data sheet ( Hoja de datos )
| Número de pieza | TDA7326D | |
| Descripción | AM-FM RADIO FREQUENCY SYNTHESIZER | |
| Fabricantes | ST Microelectronics | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de TDA7326D (archivo pdf) en la parte inferior de esta página. Total 16 Páginas | ||
|
No Preview Available !
TDA7326
AM-FM RADIO FREQUENCY SYNTHESIZER
FM INPUT AND PRECOUNTER FOR UP TO
140MHz
AM INPUT FOR UP TO 40MHz
6-BIT SWALLOW COUNTER, 8-BIT PRO-
GRAMMABLE COUNTER FOR FM AND SW
14-BIT PROGRAMMABLE COUNTER FOR
LW AND MW
THREE WIRES 8-BIT SERIAL INTERFACE
ON-CHIP REFERENCE OSCILLATOR AND
COUNTER
PROGRAMMABLE SCANNING STEPS FOR
AM AND FM
DIGITAL PHASE DETECTOR AND LOOP FIL-
TER
TWO SEPARATE FREE PROGRAMMABLE
FILTER APPLICATIONS AVAILABLE
TUNING VOLTAGE OUTPUT 0.5 TO 9.5V
PROGRAMMABLE CURRENT SOURCES TO
SET THE LOOP GAIN
ON-CHIP POWER ON RESET
STANDBY MODE
DIP16
SO16W
ORDERING NUMBERS: TDA7326 (DIP16)
TDA7326D (SO16W)
DESCRIPTION
The TDA7326 is a PLL frequency synthesizer in
CMOS technology that performs all the function of
a PLL radio tuning system for FM and AM (LW,
MW, SW)
BLOCK DIAGRAM
July 1994
1/16
1 page  
TDA7326
2.0 GENERAL DESCRIPTION
This circuit contains a frequency synthesizer and
a loop filter for an FM and AM radio tuning sys-
tem. Only a VCO is required to build a complete
PLL system.
For FM and SW application, the counter works in
a two stages configuration.
The first stage is a swallow counter with a four
modulus (:32/33/64/65) precounter.
The second stage is an 8-bit programmable
counter.
For LW and MW application, a 14-bit programma-
ble counter is available.
The circuit receives the scaling factors for the pro-
grammable counters and the values of the refer-
ence frequencies via a three line serial bus inter-
face.
The reference frequency is generated by a 4MHz
XTAL oscillator followed by the reference divider.
An external oscillator (f = 4MHz) can be used in-
stead of the internal one; it must be connected to
OSCIN (pin 7).
The reference step-frequency is 1 or 2.5kHz for
AM. For FM mode a step frequency of 12.5 and
25kHz can be selected.
The circuit checks the format of the received data
words.
Valid data in the interface shift register are stored
automatically in buffer registers at the end of
transmission.
The output signals of the phase detector are
switching the programmable current sources.
Their currents are integrated in the loop filter to a
DC voltage.The values of the current sources are
programmable by two bits also received via the
serial bus.
The loop filter amplifier is supplied by a separate
positive power supply, to minimize the noise in-
duced by the digital part of the system.
The loop gain can be set for different conditions.
After a power on reset, all registers are reset to
zero and the standby mode is activated.
In standby mode, oscillator, reference counter,
AM input and FM input are stopped. The power
consumption is reduced to a minimum.
3.0 DETAILED DESCRIPTION OF THE PLL
FREQUENCY SYNTHESIZER
3.1 INPUT AMPLIFIERS
The signals applied on AM and FM input are am-
plified to get a logic level in order to drive the fre-
quency dividers.
3.1.1 Input Impedance
The typical input impedance: for the FM input
is 200Ω and for AM input is 1.4kΩ.
3.1.2 Input sensitivity
(see Figures 1a and 1b).
3.2 DATA AND CONTROL REGISTER
3.2.1 Register Location
The data registers (bit2...bit7) for the control
register and the data registers PC7...PC0,
SC5...SC0 for the counters are organized in
four words, identified by two address bits (bit 7
and bit 6), bit 7 is the first bit to be sent by the
controller, bit0 is the last one. The order and
the number of the bytes to be transmitted is
free of choice. The modification of the
PC7...PC0 registers is valid for the internal
counters only after transmission of byte 4
(SC5...SC0).
3.2.2 CONTROL AND STATUS REGISTERS
Register Configuration
ADDRESS BITS
DATA BITS
BYTE
Function
byte 1
byte 2
byte 3
byte 4
MSB-BIT 7
adr 0
0
0
1
1
BIT 6
adr 1
0
1
0
1
BIT 5
data 0
test 0
PC7
PC5
SC5
BIT 4
data 1
test 1
PC6
PC4
SC4
BIT 3
data 2
test 2
LPF1/2
PC3
SC3
BIT 2
data 3
SOUT
CURR 1
PC2
SC2
BIT 1
data 4
CURR2
SWM/DIR
PC1
SC1
LSB BIT 0
data 5
fREF
AM/FM
PC0
SC0
REGISTER NAME
SWM/D IR
AM/FM
fREF
CURR1
CURR2
LPF1/LPF2
SOUT
FUNCTION
Swallow direct-mode switch 1 = SWM, 0 = DIR
AM - FM band switch 1=AM, 0 = FM
Selection of reference frequency (see table 3.4)
Current select of change pump
Current select of change pump
Loop filter input select 1= IPF1, 0 = IPF2
Switch output condition 1=output high, 0 = output low
5/16
5 Page 
AM SWALLOW MODE
fREF = 1KHz
FVCO = (64 ⋅ PC + SC + 64) ⋅ fREF
FVCO = (DIV_VAL+ 64) ⋅ fREF
swallow 6bit
TDA7326
fREF = 2.5KHz
FVCO = (32 ⋅ PC + SC + 32) ⋅ fREF
FVCO = (DIV_VAL+ 32) ⋅ fREF
swallow 5bit (bit SC5 = 0)
AM DIRECT MODE
FVCO = (DIV_VAL+ 1) ⋅ fREF
5.2: Examples
a) CONDITIONS:
FM MODE (fRF = 98.1MHz, fREF = 25KHz; IF = 10.7MHz
it follows: that FVCO = 98.1 + 10.7 = 108.8MHz
DIV_VAL
=
FVCO
fref
- 32 =4352 - 32 = 4320 = 10 E 0 Hex
=10000 111000000
PC7 PC6 PC5 PC4 PC3 PC2 PC1 PC0 SC5 SC4 SC3 SC2 SC1 SC0
SC = 0 (*)
binary ⇒
PC = 135
b) CONDITIONS:
FM MODE (fRF = 98.8MHz, fREF = 25KHz; IF = 10.7MHz
it follows: FVCO = 98.8 + 10.7 = 109.5MHz
DIV_VAL = 4380 - 32 = 4348 = 10 FC Hex
10000111011100
=
PC7 PC6 PC5 PC4 PC3 PC2 PC1 PC0 SC5 SC4 SC3 SC2 SC1 SC0
SC = 28 (*)
binary ⇒
PC = 135
NOTE: (*) The bit SC5 is FORCED = 0, and higher weigth bits are left shift ed one position.
11/16
11 Page | ||
| Páginas | Total 16 Páginas | |
| PDF Descargar | [ Datasheet TDA7326D.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| TDA7326 | AM-FM RADIO FREQUENCY SYNTHESIZER | ST Microelectronics |
| TDA7326D | AM-FM RADIO FREQUENCY SYNTHESIZER | ST Microelectronics |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |