DataSheet.es    


PDF TDA1597 Data sheet ( Hoja de datos )

Número de pieza TDA1597
Descripción IF amplifier/demodulator for FM radio receivers
Fabricantes NXP Semiconductors 
Logotipo NXP Semiconductors Logotipo



Hay una vista previa y un enlace de descarga de TDA1597 (archivo pdf) en la parte inferior de esta página.


Total 24 Páginas

No Preview Available ! TDA1597 Hoja de datos, Descripción, Manual

INTEGRATED CIRCUITS
DATA SHEET
TDA1597
IF amplifier/demodulator for FM
radio receivers
Product specification
Supersedes data of May 1994
File under Integrated Circuits, IC01
1997 Feb 27

1 page




TDA1597 pdf
Philips Semiconductors
IF amplifier/demodulator for FM radio receivers
Product specification
TDA1597
FUNCTIONAL DESCRIPTION
The limiter amplifier has five stages of IF amplification
using balanced differential limiter amplifiers with emitter
follower coupling.
Decoupling of the stages from the supply voltage line and
an internal high-ohmic DC feedback loop gives a very
stable IF performance. The amplifier gain is virtually
independent of changes in temperature.
The FM demodulator is fully balanced and contains two
cross-coupled differential amplifiers.
The quadrature detection of the FM signal is performed by
direct feeding of one differential amplifier from the limiter
amplifier output and the other via an external 90 degrees
phase shifting network. The demodulator has a good
stability and a small zero cross-over shift. The bandwidth
of the demodulator output is restricted by an internal
low-pass filter to approximately 1 MHz. Non-linearities,
which are introduced by demodulation, are compensated
for by the THD compensation circuit. For this reason, the
demodulator resonance circuit (between pins 10 and 11)
must have a loaded Q-factor of 19.
Consequently, there is no need for the demodulator tuned
circuit to be adjusted for minimum distortion. Adjustment
criterion is a symmetrical stop pulse. The control voltage
for the mute attenuator (pin 16) is derived from the values
of the level detector and the detuning detector output
signals. The mute attenuator has a fast attack and a slow
decay, determined by the capacitor connected to pin 16.
The AF signal is fed via the mute attenuator to the output
(pin 4). A weighted control voltage (pin 6) is obtained from
the mute attenuator control voltage via a buffer amplifier
that introduces an additional voltage shift and gain.
The level detector generates a voltage output signal
proportional to the amplitude of the input signal.
The unweighted level detector output signal is available in
the FM-MUTE-ON condition (mode switch).
The open-collector tuning stop output voltages STOP-0
and STOP-1 (pins 15 and 14) are derived from the
detuning and the input signal level. Pins 14 and 15 may be
tied together if only one tuning-stop output is required.
LIMITING VALUES
In accordance with the Absolute Maximum Rating System (IEC 134).
SYMBOL
VP
Vn
V13
I14, 15
Ptot
Tstg
Tamb
Ves
PARAMETER
CONDITIONS
supply voltage
voltage at pins 2, 4, 5, 6, 10, 11 and 16
voltage at pins 3, 7, 8, 14, 15, 18,
19 and 20
voltage on pin 13
current at pins 14 and 15
total power dissipation
storage temperature
operating ambient temperature
electrostatic handling
all pins except pins 5 and 7
note 1
pin 5
note 1
pin 7
note 1
MIN.
0.3
0.3
0.3
55
40
2 000
2 000
2 000
Note
1. Equivalent to discharging a 100 pF capacitor through a 1.5 kseries resistor.
MAX.
+13
+10
VP
6
2
360
+150
+85
+2 000
+800
+1 000
UNIT
V
V
V
V
mA
mW
°C
°C
V
V
V
1997 Feb 27
5

5 Page





TDA1597 arduino
Philips Semiconductors
IF amplifier/demodulator for FM radio receivers
Product specification
TDA1597
0
V4
(dB)
20
40
60
(1)
(2)
MBE519
80
100
106
(1) Audio signal.
(2) Noise.
105
104
103
102
101 Vi20 (rms) (V) 1
Fig.5 FM-MUTE-ON: Audio signal and noise as functions of the input signal ViIF (pin 20) with f = ±22.5 kHz;
fm = 1 kHz; de-emphasis 50 µs.
20
handbook, full pagewidth
V4
(dB)
0
20
40
(1)
(2)
MEH071
60
80
106
(1) Audio signal.
(2) Noise.
105
104
103
102
101 Vi20 (rms) (V) 1
Fig.6 FM-MUTE-OFF: Audio signal and noise as functions of the input signal ViIF (pin 20) with f = ±22.5 kHz;
fm = 1 kHz; de-emphasis 50 µs.
1997 Feb 27
11

11 Page







PáginasTotal 24 Páginas
PDF Descargar[ Datasheet TDA1597.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
TDA1591PLL stereo decoder and noise blankerNXP Semiconductors
NXP Semiconductors
TDA1591TPLL stereo decoder and noise blankerNXP Semiconductors
NXP Semiconductors
TDA1592PLL stereo decoder and noise blankerNXP Semiconductors
NXP Semiconductors
TDA1592TPLL stereo decoder and noise blankerNXP Semiconductors
NXP Semiconductors

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar