DataSheet.es    


PDF TD6308AP Data sheet ( Hoja de datos )

Número de pieza TD6308AP
Descripción AUTO REVERSE & AUTO EJECT PLUNGER DRIVER
Fabricantes Toshiba 
Logotipo Toshiba Logotipo



Hay una vista previa y un enlace de descarga de TD6308AP (archivo pdf) en la parte inferior de esta página.


Total 11 Páginas

No Preview Available ! TD6308AP Hoja de datos, Descripción, Manual

TD6304,08AP
TOSHIBA Bipolar Digital Integrated Circuit Silicon Monolithic
TD6304AP,TD6308AP
Auto Reverse & Auto Eject
Plunger Driver
TD6304AP, TD6308AP are IC developed for auto reverse / auto
eject on a car stereo.
There are two methods for driving the plunger; one is to drive it
after motor rotation detecting signal is stopped and the other is to
drive it optionally by program switch.
Further, this IC can be used as a solenoid driver in the control
circuit of a stereo, remote control system and other electric
accessories.
Features
· Plunger driving output transistor is built in.
No.6 pin output IOUT = 200mA (VCE (sat) = 0.7V (max.))
· Manual operation by program switch is possible.
· Time for output pulse generation after rotation detecting
signal is stopped and output pulse width are variable by
external mounted capacitor and resistor. (Duty cycle of
output pulse is set inside IC)
· A load dump circuit is built in for protection from
overvoltage.
· Operating supply voltage VCC (opr) = 8~16 V
(7 pin voltage)
· TD6304AP is 1 / 4 duty cycle.
· TD6308AP is 1 / 8 duty cycle.
Weight: 0.7g (typ.)
Pin Connection (side view)
1 2002-10-30

1 page




TD6308AP pdf
Maximum Ratings (Ta = 25°C)
Characteristic
Supply voltage
Output voltage
Output current
Power dissipation
Operating temperature
Storege temperature
Symbol
VCC
VOUT
IOUT
PD
Topr
Tstg
Rating
30
30
400
400
-30~75
-55~150
Unit
V
V
mA
mW
°C
°C
TD6304,08AP
Electrical Characteristics (unless otherwise specified, VCC = 13.2V, Ta = 25°C)
Characteristic
Operating supply voltage
Supply current
Plunger output current
Saturation voltage
between collector and
emitter
Input current
"L" level
"H" level
Rotary detecting
input voltage
"H" level
"L" level
Oscillator frequency
Plunger
response time
TD6304AP
TD6308AP
Symbol
VCC
ICC1
ICC2
IOUT
VCE (sat)
IIL
IIH
VIH
VIL
fOSC
T1
Test
Cir-
cuit
Test Condition
Ta = -30~75°C
3 Plunger on
4 Plunger off
5 VCE (sat) = 0.7V
Test for pins no.6 & no.5
IOUT = 400mA
1 Test for pins VIL = 0
2 no.1 & no.2
VIH = 13.2V
6
Input signals of no. 2 pins
6
C = 0.22µF, R = 30k
fOSC = 500Hz
Min. Typ. Max.
8.0 16.0
7.5 13.0 20.0
3.6 5.0 8.0
200
― ― 1.5
60 130
― ― 5.0
2.5 VCC
― ― 0.8
500
0.75
0.88
Plunger
driving time
TD6304AP
TD6308AP
T2 fOSC = 500Hz
0.25
0.12
Unit
V
mA
mA
mA
V
µA
µA
V
V
Hz
s
s
5 2002-10-30

5 Page





TD6308AP arduino
TD6304,08AP
RESTRICTIONS ON PRODUCT USE
000707EBA
· TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor
devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical
stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of
safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of
such TOSHIBA products could cause loss of human life, bodily injury or damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as
set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and
conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability
Handbook” etc..
· The TOSHIBA products listed in this document are intended for usage in general electronics applications
(computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances,
etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires
extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or
bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or
spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments,
medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this
document shall be made at the customer’s own risk.
· The products described in this document are subject to the foreign exchange and foreign trade laws.
· The information contained herein is presented only as a guide for the applications of our products. No
responsibility is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other
rights of the third parties which may result from its use. No license is granted by implication or otherwise under
any intellectual property or other rights of TOSHIBA CORPORATION or others.
· The information contained herein is subject to change without notice.
11 2002-10-30

11 Page







PáginasTotal 11 Páginas
PDF Descargar[ Datasheet TD6308AP.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
TD6308APAUTO REVERSE & AUTO EJECT PLUNGER DRIVERToshiba
Toshiba

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar