|
|
PDF TC7W53FU Data sheet ( Hoja de datos )
| Número de pieza | TC7W53FU | |
| Descripción | 2-CHANNEL MULTIPLEXER/DEMULTIPLEXER | |
| Fabricantes | Toshiba | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de TC7W53FU (archivo pdf) en la parte inferior de esta página. Total 11 Páginas | ||
|
No Preview Available !
www.DataSheet4U.net
TC7W53F/FU/FK
TOSHIBA CMOS Digital Integrated Circuit Silicon Monolithic
TC7W53F,TC7W53FU,TC7W53FK
2-Channel Multiplexer/Demultiplexer
The TC7W53 is a high speed CMOS Analog Multiplexer/
Demultiplexer fabricated with silicon gate CMOS technology.
It achieves the high speed operation similar to equivalent
LSTTL while maintaining the CMOS low power dissipation.
The TC7W53 has a 2 channel configuration.
The digital signal to the control terminal turns “ON” the
corresponding switch of each channel a large amplitude signal
(VCC – VEE) can then be switched by the small logical amplitude
(VCC – GND) control signal.
For example, in the case of VCC = 5 V, GND = 0 V, VEE = 5 V,
signals between −5 V and +5 V can be switched from the logical
circuit with a signal power supply of 5 V. As the ON-resistance of
each switch is low, they can be connected to circuit with low input
impedance.
All inputs are equipped with protection circuits against static
discharge or transient excess voltage.
Features
• High speed: tpd = 15 ns (typ.) at VCC = 5 V, VEE = 0 V
• Low power dissipation: ICC = 1 μA (max) at Ta = 25°C
• High noise immunity: VNIH = VNIL = 28% VCC (min)
• Low ON resistance: RON = 50 Ω (typ.) at VCC – VEE = 9 V
• High degree of linearity: THD = 0.02 (typ.) at VCC – VEE = 9 V
• Pin and function compatible with TC4W53
TC7W53F
TC7W53FU
TC7W53FK
Marking
FM8
7W53F
Part No.
Lot No.
Weight
SOP8-P-1.27: 0.05 g (typ.)
SSOP8-P-0.65: 0.02 g (typ.)
SSOP8-P-0.50A: 0.01 g (typ.)
SM8
7W53
Part No.
Lot No.
US8
W
53
Part No.
1 2009-09-30
1 page  
www.DataSheet4U.net
TC7W53F/FU/FK
Analog Switch Characteristics (GND = 0 V, Ta = 25°C)
Characteristics
Sine wave distortion
(T.H.D)
Frequency response
(switch ON)
Feedthrough attenuation
(switch OFF)
Crosstalk
(control input to signal
output)
Crosstalk
(between any switches)
Symbol
Test Condition
Typ.
VEE (V) VCC (V)
⎯
RL = 10 kΩ, CL = 50 pF
fIN = 1 kHz
VIN = 4.0 Vp-p
VIN = 8.0 Vp-p
VIN = 11 Vp-p
−2.25
−4.5
−6.0
−2.25
4.5
6.0
0.025
0.02
0.018
tMAX
Adjust FIN voltage to obtain 0dBm at VOS
Increase FIN until dB Meter reads −3dB
RL = 50 Ω, CL = 10 pF
fIN = 1 MHz, sine wave
(Note1)
−2.25
(Note2)
−2.5
120
95
(Note1)
190
−4.5 4.5
(Note2)
150
(Note1)
200
−6.0 6.0
(Note2)
190
VIN is centered at (VCC−VEE)/2. Adjust input for 0dBm −2.25
2.25
⎯ RL = 600 Ω, CL = 50 pF
−4.5 −4.5
fIN = 1 MHz, sine wave
−6.0 6.0
−50
−50
−50
⎯
RL = 600 Ω, CL = 50 pF
fIN = 1 MHz, square wave (tr = tf = 6 ns)
−2.25
−4.5
−6.0
2.25
−4.5
6.0
60
140
200
Adjust VIN to obtain 0dBm at input
⎯ RL = 600 Ω, CL = 50 pF
fIN = 1 MHz, sine wave
2.25
−4.5
6.0
2.25
−4.5
6.0
−50
−50
−50
Unit
%
MHz
dB
mV
dB
Note: These characteristics are determined by design of device.
Note 1: Input COMMON terminal, and measure at SWITCH terminal.
Note 2: Input SWITCH terminal, and measure at COMMON terminal.
COMMON terminal
SWITCH terminal
5 2009-09-30
5 Page 
www.DataSheet4U.net
TC7W53F/FU/FK
RESTRICTIONS ON PRODUCT USE
• Toshiba Corporation, and its subsidiaries and affiliates (collectively “TOSHIBA”), reserve the right to make changes to the information
in this document, and related hardware, software and systems (collectively “Product”) without notice.
• This document and any information herein may not be reproduced without prior written permission from TOSHIBA. Even with
TOSHIBA’s written permission, reproduction is permissible only if reproduction is without alteration/omission.
• Though TOSHIBA works continually to improve Product’s quality and reliability, Product can malfunction or fail. Customers are
responsible for complying with safety standards and for providing adequate designs and safeguards for their hardware, software and
systems which minimize risk and avoid situations in which a malfunction or failure of Product could cause loss of human life, bodily
injury or damage to property, including data loss or corruption. Before customers use the Product, create designs including the Product,
or incorporate the Product into their own applications, customers must also refer to and comply with (a) the latest versions of all
relevant TOSHIBA information, including without limitation, this document, the specifications, the data sheets and application notes for
Product and the precautions and conditions set forth in the “TOSHIBA Semiconductor Reliability Handbook” and (b) the instructions for
the application with which the Product will be used with or for. Customers are solely responsible for all aspects of their own product
design or applications, including but not limited to (a) determining the appropriateness of the use of this Product in such design or
applications; (b) evaluating and determining the applicability of any information contained in this document, or in charts, diagrams,
programs, algorithms, sample application circuits, or any other referenced documents; and (c) validating all operating parameters for
such designs and applications. TOSHIBA ASSUMES NO LIABILITY FOR CUSTOMERS’ PRODUCT DESIGN OR APPLICATIONS.
• Product is intended for use in general electronics applications (e.g., computers, personal equipment, office equipment, measuring
equipment, industrial robots and home electronics appliances) or for specific applications as expressly stated in this document.
Product is neither intended nor warranted for use in equipment or systems that require extraordinarily high levels of quality and/or
reliability and/or a malfunction or failure of which may cause loss of human life, bodily injury, serious property damage or serious public
impact (“Unintended Use”). Unintended Use includes, without limitation, equipment used in nuclear facilities, equipment used in the
aerospace industry, medical equipment, equipment used for automobiles, trains, ships and other transportation, traffic signaling
equipment, equipment used to control combustions or explosions, safety devices, elevators and escalators, devices related to electric
power, and equipment used in finance-related fields. Do not use Product for Unintended Use unless specifically permitted in this
document.
• Do not disassemble, analyze, reverse-engineer, alter, modify, translate or copy Product, whether in whole or in part.
• Product shall not be used for or incorporated into any products or systems whose manufacture, use, or sale is prohibited under any
applicable laws or regulations.
• The information contained herein is presented only as guidance for Product use. No responsibility is assumed by TOSHIBA for any
infringement of patents or any other intellectual property rights of third parties that may result from the use of Product. No license to
any intellectual property right is granted by this document, whether express or implied, by estoppel or otherwise.
• ABSENT A WRITTEN SIGNED AGREEMENT, EXCEPT AS PROVIDED IN THE RELEVANT TERMS AND CONDITIONS OF SALE
FOR PRODUCT, AND TO THE MAXIMUM EXTENT ALLOWABLE BY LAW, TOSHIBA (1) ASSUMES NO LIABILITY
WHATSOEVER, INCLUDING WITHOUT LIMITATION, INDIRECT, CONSEQUENTIAL, SPECIAL, OR INCIDENTAL DAMAGES OR
LOSS, INCLUDING WITHOUT LIMITATION, LOSS OF PROFITS, LOSS OF OPPORTUNITIES, BUSINESS INTERRUPTION AND
LOSS OF DATA, AND (2) DISCLAIMS ANY AND ALL EXPRESS OR IMPLIED WARRANTIES AND CONDITIONS RELATED TO
SALE, USE OF PRODUCT, OR INFORMATION, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY, FITNESS
FOR A PARTICULAR PURPOSE, ACCURACY OF INFORMATION, OR NONINFRINGEMENT.
• Do not use or otherwise make available Product or related software or technology for any military purposes, including without limitation,
for the design, development, use, stockpiling or manufacturing of nuclear, chemical, or biological weapons or missile technology
products (mass destruction weapons). Product and related software and technology may be controlled under the Japanese Foreign
Exchange and Foreign Trade Law and the U.S. Export Administration Regulations. Export and re-export of Product or related software
or technology are strictly prohibited except in compliance with all applicable export laws and regulations.
• Please contact your TOSHIBA sales representative for details as to environmental matters such as the RoHS compatibility of Product.
Please use Product in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances,
including without limitation, the EU RoHS Directive. TOSHIBA assumes no liability for damages or losses occurring as a result of
noncompliance with applicable laws and regulations.
11 2009-09-30
11 Page | ||
| Páginas | Total 11 Páginas | |
| PDF Descargar | [ Datasheet TC7W53FU.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| TC7W53F | 2-CHANNEL MULTIPLEXER/DEMULTIPLEXER | Toshiba |
| TC7W53FK | 2-CHANNEL MULTIPLEXER/DEMULTIPLEXER | Toshiba |
| TC7W53FU | 2-CHANNEL MULTIPLEXER/DEMULTIPLEXER | Toshiba |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |