DataSheet.es    


PDF VTO-8090 Data sheet ( Hoja de datos )

Número de pieza VTO-8090
Descripción Varactor-Tuned Oscillators
Fabricantes Agilent(Hewlett-Packard) 
Logotipo Agilent(Hewlett-Packard) Logotipo



Hay una vista previa y un enlace de descarga de VTO-8090 (archivo pdf) en la parte inferior de esta página.


Total 7 Páginas

No Preview Available ! VTO-8090 Hoja de datos, Descripción, Manual

Varactor-Tuned Oscillators
Technical Data
VTO-8000 Series
Features
• 600 MHz to 10.5 GHz
Coverage
• Fast Tuning
• +7 to +13 dBm Output
Power
± 1.5 dB Output Flatness
• Hermetic Thin-film
Construction
Description
HP VTO-8000 Series oscillators
use a silicon transistor chip as a
negative resistance oscillator. The
oscillation frequency is deter-
mined by a silicon abrupt varactor
diode acting as a voltage-variable
capacitor in a thin-film micro-
stripline resonator. This provides
extremely fast tuning speed,
limited primarily by the internal
impedance of the user-supplied
voltage driver. Fast settling is
another feature of the HP
VTO-8000 Series oscillators.
Typical settling times for the
VTO-8090 are <200␣ kHz within one
microsecond while the VTO-8950
settles to <2␣ MHz within two
microseconds referenced to ten
milliseconds. The VTO-8850
combines a bipolar transistor
oscillator with a GaAs FET buffer
stage. This GaAs FET buffer
isolates the oscillator from
variations in load impedance for
low frequency pulling, allows the
oscillator to run lighty-loaded for
low phase noise content and
provides +10 dBm of minimum
output power over the full tuning
range. The VTO-8000 Series
varactor-tuned oscillators are
packaged in TO-8 transistor cans
for simple installation in a
conventional 50-ohm micro-
stripline PC board. They are ideal
for most compact, lightweight
commercial and military equip-
ment designs. Test fixturing is
also available for lab bench test
applications. See the “Test
Fixtures for TO-8 Packages”
section for additional information
and outlines.
Applications
Frequency agile systems, such as
digitally controlled receivers and
active jamming transmitters often
use externally linearized
varactor-tuned oscillators. HP
oscillators are monotonic making
external linearization easy using
analog (opamp) or digital
(EPROM) linearizing techniques.
The HP VTO Series has been
designed with a tuning input
bypass capacitance which is
sufficient to provide the neces-
sary RF filtering action yet as low
Pin Configuration
TO-8V
GROUND
+V TUNE
3
24
1
RFOUT
+DC
VOLTAGE
CASE GROUND
as possible to maximize V/T
characteristics for excellent
tuning speeds. Used in a phase
locked loop PLL circuit, a VTO
provides a receiver LO with
stability equivalent to the refer-
ence oscillator (usually crystal
controlled), yet variable in
discrete steps or continuously
depending on the PLL
configuration.
Another important aspect of VTOs
used in an LO application is their
power vs. frequency flatness
(± 1.5␣ dB). This assures that once a
receiver mixer is biased for best
dynamic range the local oscillator
drive will remain constant
throughout the tuning range
without complex leveling
circuitry.
9-23
5964-9815E

1 page




VTO-8090 pdf
9-27

5 Page










PáginasTotal 7 Páginas
PDF Descargar[ Datasheet VTO-8090.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
VTO-8090Varactor-Tuned OscillatorsAgilent(Hewlett-Packard)
Agilent(Hewlett-Packard)

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar