|
|
Número de pieza | TLP1004A | |
Descripción | INFRARED LED + PHOTO IC | |
Fabricantes | Toshiba Semiconductor | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de TLP1004A (archivo pdf) en la parte inferior de esta página. Total 10 Páginas | ||
No Preview Available ! TLP1004A(F),TLP1005A(F)
TOSHIBA Photointerrupter Infrared LED + Photo IC
TLP1004A(F), TLP1005A(F)
Lead Free Product
Home Electric Equipment Such As VCR,
CD Player
OA Equipment Such As Copying
Machine, Printer, Facsimile, Etc.
Automatic service Equipment Such As
Vending Machine,
Various Position Detection
Unit in mm
TLP1004A(F) and TLP1005A(F) are digital output
photo−interrupters combining GaAs infrared LED
with high sensitive and high gain Si photo IC.
Directly connectable to TTL, LSTTL and CMOS.
• Printed wiring board direct mounting type
• Gap: 3mm
• Resolution: Slit width 0.5mm
• Digital output (with a pull−up resistor)
TLP1004A(F): Low level output at shielding
TLP1005A(F): High level output at shielding
• Built−in schmitt circuit
• Threshold input current: 4mA (max.) at Ta = 25°C
• Operating supply voltage: VCC = 4.5V~17V
• High speed response
• Detector side is of visible light cut type
TOSHIBA
Weight: 0.8g (typ.)
11−13G1
Pin Connection
TLP1004A(F)
1
2
VOL. REG.
AMP
TLP1005A(F)
1
2
VOL. REG.
AMP
1. Anode
2. Cathode
3. VCC
4. OUT
5. GND
3
4
5
3
4
5
1 2004-02-13
1 page TLP1004A(F),TLP1005A(F)
Precaution
Please be careful of the followings.
1. Soldering should be performed after lead forming.
2. If chemicals are used for cleaning, the soldered surface only shall be cleaned with chemicals avoiding the whole
cleaning of the package.
3. The container is made of polycarbonate. polycarbonate is usually stable with acid, alcohol, and aliphatic
hydrocarbons however, with petrochemicals (such as benzene, toluene, and acetone), alkali, aromatic
hydrocarbons, or chloric hydrocarbons, polycarbonate becomes cracked, swollen, or melted. Please take care
when choosing a packaging material by referencing the table below.
<Chemicals To Avoid With Polycarbonate>
Phenomenon
A
Little deterioration
but staining
B
Cracked, crazed, or
swollen
C
Melted
( ) : Used as solvent.
D Decomposed
Chemicals
・Nitric acid (low concentration), hydrogen peroxide, chlorine
・Acetic acid (70% or more)
・Gasoline
・Methyl ethyl ketone, ethyl acetate, butyl acetate
・Ethyl methacrylate, ethyl ether, MEK
・Acetone, m−amino alcohol, carbon tetrachloride
・Carbon disulfide, trichloroethylene, cresol
・Thinners, oil of turpentine
・Triethanolamine, TCP, TBP
・Concentrated sulfuric acid
・Benzene
・Styrene, acrylonitrile, vinyl acetate
・Ethylenediamine, diethylenediamine
・(Chloroform, methyl chloride, tetrachloromethane, dioxane,
1, 2−dichloroethane)
・Ammonia water
・Other alkali
4. During 100µs after turning on VCC, output voltage changes for stabilizing the inner circuit.
5. Supply the by−pass condenser up to 0.01µF between VCC and GND near device to stabilize the power supply
line.
5 2004-02-13
5 Page |
Páginas | Total 10 Páginas | |
PDF Descargar | [ Datasheet TLP1004A.PDF ] |
Número de pieza | Descripción | Fabricantes |
TLP1004A | INFRARED LED + PHOTO IC | Toshiba Semiconductor |
TLP1004AF | INFRARED LED + PHOTO IC | Toshiba Semiconductor |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |