DataSheet.es    


PDF V23839-R36-L55 Data sheet ( Hoja de datos )

Número de pieza V23839-R36-L55
Descripción iSFF - Intelligent Small Form Factor 1.25 Gigabit Ethernet 4.25/2.125/1.0625 Gbit/s Fibre Channel Multimode 850 nm Transceiver with LC Connector
Fabricantes Infineon Technologies 
Logotipo Infineon Technologies Logotipo



Hay una vista previa y un enlace de descarga de V23839-R36-L55 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! V23839-R36-L55 Hoja de datos, Descripción, Manual

Fiber Optics
iSFF - Intelligent Small Form Factor
V23839-R3x-L55
1.25 Gigabit Ethernet (1000 Base-SX)
4.25/2.125/1.0625 Gbit/s Fibre Channel (400/200/100-M5/M6-SN-I)
Multimode 850 nm Transceiver with LC™ Connector
Preliminary Data Sheet
Features
• Based on Small Form Factor (SFF) MSA1)
• Fully SFF-8472 compatible
• Incorporating Intelligent – Digital Diagnostic
Monitoring Interface
• Internal calibration implementation
• Excellent EMI performance
• Separate and common chassis/signal ground
module concepts available
• 2x7 footprint
• RJ-45 style LC™ connector system
• Single power supply (3.3 V)
• Extremely low power consumption of 530 mW typical
• Small size for high port density
• UL-94 V-0 certified
• ESD Class 1C per JESD22-A114-B (MIL-STD 883D Method 3015.7)
• According to FCC (Class B) and EN 55022
• For distances of up to 860 m (50 µm fiber)
• Laser safety according to Class 1 FDA and IEC
• Internally AC/AC coupled
• Operating temperature range of –20°C to 85°C
• iSFF evaluation kit available upon request
File: 1145
1) MSA documentation can be found at www.infineon.com/fiberoptics under Transceivers, SFF Transceivers.
LC™ is a trademark of Lucent.
Part Number
V23839-R35-L55
V23839-R36-L55
Chassis/Signal Grounding Concept
Common
Separated
Preliminary Product Information
1
2004-06-25

1 page




V23839-R36-L55 pdf
V23839-R3x-L55
Description
Link Length as Defined by IEEE and Fibre Channel Standards
Fiber Type
Reach
min.1)
max.2)
Unit
at 1.0625 Gbit/s
50 µm, 2000 MHz*km
0.5 860 meters
50 µm, 500 MHz*km
0.5 500
50 µm, 400 MHz*km
0.5 450
62.5 µm, 200 MHz*km
0.5 300
62.5 µm, 160 MHz*km
0.5 250
at 1.25 Gbit/s
50 µm, 500 MHz*km
2 550 meters
50 µm, 400 MHz*km
2 500
62.5 µm, 200 MHz*km
2 275
62.5 µm, 160 MHz*km
2 220
at 2.125 Gbit/s
50 µm, 2000 MHz*km
0.5 500 meters
50 µm, 500 MHz*km
0.5 300
50 µm, 400 MHz*km
0.5 260
62.5 µm, 200 MHz*km
0.5 150
62.5 µm, 160 MHz*km
0.5 120
at 4.25 Gbit/s
50 µm, 2000 MHz*km
0.5 270 meters
50 µm, 500 MHz*km
0.5 150
50 µm, 400 MHz*km
62.5 µm, 200 MHz*km
0.5 130
0.5 70
62.5 µm, 160 MHz*km
0.5 55
1) Minimum reach as defined by IEEE and Fibre Channel Standards. A 0 m link length (loop-back connector) is
supported.
2) Maximum reach as defined by IEEE and Fibre Channel Standards. Longer reach possible depending upon link
implementation.
Preliminary Product Information
5
2004-06-25

5 Page





V23839-R36-L55 arduino
V23839-R3x-L55
Technical Data
Electrical Characteristics (VCC = 2.97 V to 3.63 V, TC = –20°C to 85°C)
Parameter
Symbol
Values
Unit
min.
typ.
max.
Common
Supply Voltage
In-rush Current1)
Power Dissipation
VCCVEE
IIR max
P
2.97
400
3.3
3.63 V
30 mA
900 mW
Transmitter
Differential Data Input Voltage VIDpk-pk 500
Swing2)
3200
mV
Tx Disable Voltage
Tx Enable Voltage
Tx Fault High Voltage
Tx Fault Low Voltage
Supply Current3)
Receiver
TxDis
2
VCC V
TxEn
VEE
0.8 V
TxFH
2.4
VCC V
TxFL
VEE
0.5 V
ITx 100 150 mA
Differential Data Output Voltage VODpk-pk 500
Swing 4)
1000
mV
Signal Detect High
SDH
2.4
VCC V
Signal Detect Low
SDL
VEE
0.5 V
Rate Select 1 / 2 Gbit/s5) 6)
RSLOW
2
VCC V
Rate Select 2 / 4 Gbit/s5) 6)
RSHIGH
VEE
0.8 V
Contributed Deterministic Jitter DJ-CRx
23.5 ps
Contributed Total Jitter
TJ-CRx
61.8 ps
Jitter (pk-pk)7)
JRx
45 ps
Power Supply Noise Rejection8) PSNR
100
mVpp
Supply Current3) 9)
IRx
80 90 mA
1) Measured with MSA recommended supply filter network (Figure 8). Maximum value above that of the steady
state value.
2) Internally AC coupled. Typical 100 differential input impedance.
3) MSA defines maximum current at 300 mA.
4) Internally AC coupled. Load 50 to GND or 100 differential. For dynamic measurement a tolerance of
50 mV should be added.
5) In accordance to SFF Committee SFF-8079 Draft.
6) Not implemented.
7) Jitter (pk-pk) is measured using a 27–1 NRZ PRBS and a Digital Communications Analyzer.
Preliminary Product Information
11
2004-06-25

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet V23839-R36-L55.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
V23839-R36-L55iSFF - Intelligent Small Form Factor 1.25 Gigabit Ethernet 4.25/2.125/1.0625 Gbit/s Fibre Channel Multimode 850 nm Transceiver with LC ConnectorInfineon Technologies
Infineon Technologies

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar