DataSheet.es    


PDF Z86C71 Data sheet ( Hoja de datos )

Número de pieza Z86C71
Descripción IR/Low-Voltage Microcontroller
Fabricantes Zilog. 
Logotipo Zilog. Logotipo



Hay una vista previa y un enlace de descarga de Z86C71 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! Z86C71 Hoja de datos, Descripción, Manual

PRELIMINARY PRODUCT SPECIFICATION
1
Z86L70/71/75/C71
1
IR/LOW-VOLTAGE MICROCONTROLLER
FEATURES
ROM
RAM*
Voltage
Part
(KB) (Bytes) I/O
Ranges
Z86L70
2
125 14 2.0V to 3.9V
Z86L71
8
237 16 2.0V to 3.9V
Z86L75
4
237 14 2.0V to 3.9V
Z86C71
8
237 16 4.5V to 5.5V
Note: *General-Purpose
s Two Standby Modes (Typical)
– STOP - 2 µA
– HALT - 0.8 mA
s Special Architecture to Automate Both Generation and
Reception of Complex Pulses or Signals:
– One Programmable 8-Bit Counter/Timer with Two
Capture Registers
– One Programmable 16-Bit Counter/Timer with
One Capture Register
– Programmable Input Glitch Filter for Pulse
Reception
s Five Priority Interrupts
s Low Voltage Detection and Protection
s Programmable Watch-Dog/Power-On Reset Circuits
s Two Independent Comparators with Programmable
Interrupt Polarity
s On-Chip Oscillator that Accepts a Crystal, Ceramic
Resonator, LC, RC (mask option), or External Clock
Drive
s Mask Selectable 200 KOhm Pull-Ups on Ports 0, 2, 3
GENERAL DESCRIPTION
The Z86L7X family of IR (Infrared)/Low-Voltage Microcon-
trollers are ROM/ROMless-based members of the Z8®
MCU single-chip family with 237/125 bytes of internal
RAM. The differentiating factor between these devices is
the availability of RAM, ROM and package options. Offer-
ing the 3V versions (Z86LXX) with the Z86C71 gives opti-
mum performance in both the low and high voltage ranges.
Zilog's CMOS Low-Voltage Microcontrollers offer fast exe-
cution, efficient use of memory, sophisticated interrupts, in-
put/output bit manipulation capabilities, automated pulse
generation/reception, and internal key-scan pull-up resis-
tors. The Z86L7X product line offers easy hardware/soft-
ware system expansion with cost-effective and low power
consumption.
The Z86L7X architecture is based on Zilog's 8-bit micro-
controller core with an Expanded Register File to allow ac-
cess to register mapped peripherals, I/O circuits, and pow-
erful counter/timer circuitry. The Z8® MCU offers a flexible
I/O scheme, an efficient register and address space struc-
ture, and a number of ancillary features that are useful in
many consumer, automotive, computer peripheral, and
battery operated hand-held applications.
There are three basic address spaces available to support
a wide range of configurations: Program Memory, Register
File, and Expanded Register File. The register file is com-
posed of 256/144 bytes of RAM. It includes four I/O port
registers, 15 control and status registers and the rest are
General-Purpose registers. The Expanded Register File
consists of two additional register groups (F and D). Exter-
nal Memory is not available on 18 and 20-pin versions.
DS97LVO0500
PRELIMINARY
1-1

1 page




Z86C71 pdf
Zilog
ABSOLUTE MAXIMUM RATINGS
Symbol Description Min
VCC
TSTG
TA
Supply Voltage (*)
Storage Temp.
Oper. Ambient
Temp.
-0.3
-65°
Notes:
* Voltage on all pins with respect to GND.
† See Ordering Information
Max
+7.0
+150°
Units
V
C
C
Z86L70/71/75/C71
IR/Low-Voltage Microcontroller
Stresses greater than those listed under Absolute Maxi-
mum Ratings may cause permanent damage to the de-
vice. This is a stress rating only; operation of the device at
any condition above those indicated in the operational sec-
tions of these specifications is not implied. Exposure to ab-
solute maximum rating conditions for an extended period
may affect device reliability.
1
STANDARD TEST CONDITIONS
The characteristics listed below apply for standard test
conditions as noted. All voltages are referenced to GND.
Positive current flows into the referenced pin (Figure 5).
From Output
Under Test
I 150 pF
Figure 5. Test Load Diagram
CAPACITANCE
TA = 25°C, VCC = GND = 0V, f = 1.0 MHz, unmeasured pins returned to GND.
Parameter
Input capacitance
Output capacitance
I/O capacitance
Max
12 pF
12 pF
12 pF
DS97LVO0500
PRELIMINARY
1-5

5 Page





Z86C71 arduino
Zilog
AC CHARACTERISTICS
External I/O or Memory Read and Write Timing Table
No Symbol
Parameter
VCC
1 TdA(AS)
2 TdAS(A)
3 TdAS(DR)
4 TwAS
Address Valid to /AS
Rising Delay
/AS Rising to Address
Float Delay
/AS Rising to Read
Data Required Valid
/AS Low Width
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
5 Td
6 TwDSR
Address Float to /DS
Falling
/DS (Read) Low Width
7 TwDSW
/DS (Write) Low Width
8 TdDSR(DR) /DS Falling to Read
Data Required Valid
9 ThDR(DS)
Read Data to
/DS Rising Hold Time
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
10 TdDS(A)
11 TdDS(AS)
/DS Rising to Address
Active Delay
/DS Rising to /AS
12 TdR/W(AS) R//W Valid to /AS
Rising Delay
13 TdDS(R/W) /DS Rising to
R//W Not Valid
14 TdDW(DSW) Write Data Valid to
/DS Falling (Write)
Delay
15 TdDS(DW)
/DS Rising to Write
Data Not Valid Delay
16 TdA(DR)
Address Valid to Read
Data Required Valid
17 TdAS(DS)
/AS Rising to /DS
Falling Delay
18 TdM(AS)
/DM Valid to /AS
Falling Delay
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
2.0V
3.9V
19 TdDS(DM)
20 ThDS(A)
/DS Rise to /DM Valid
Delay
/DS Rise to Address
Valid Hold Time
2.0V
3.9V
2.0V
3.9V
Notes:
1. When using extended memory timing add 2 TpC.
2. Timing numbers given are for minimum TpC.
Standard Test Load
All timing references use 0.9 VCC for a logic 1 and 0.1 VCC for a logic 0.
Z86L70/71/75/C71
IR/Low-Voltage Microcontroller
TA = 0°C to +70°C
8.0 MHz
Min Max
55
55
70
70
400
400
80
80
0
0
300
300
165
165
260
260
0
0
85
85
60
70
70
70
70
70
80
80
70
80
475
475
100
100
55
55
70
70
70
70
Units
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
Notes
2
2
1,2
2
1,2
1,2
1,2
2
2
2
2
2
2
2
1,2
2
2
1
DS97LVO0500
PRELIMINARY
1-11

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet Z86C71.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
Z86C71IR/Low-Voltage MicrocontrollerZilog.
Zilog.
Z86C72IR MICROCONTROLLERZilog.
Zilog.

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar