DataSheet.es    


PDF S5F333SZ03-LBB0 Data sheet ( Hoja de datos )

Número de pieza S5F333SZ03-LBB0
Descripción 1/3 INCH CCD IMAGE SENSOR FOR VGA COMPATIBILITY
Fabricantes Samsung semiconductor 
Logotipo Samsung semiconductor Logotipo



Hay una vista previa y un enlace de descarga de S5F333SZ03-LBB0 (archivo pdf) en la parte inferior de esta página.


Total 19 Páginas

No Preview Available ! S5F333SZ03-LBB0 Hoja de datos, Descripción, Manual

1/3 INCH CCD IMAGE SENSOR FOR VGA COMPATIBILITY
S5F333SZ03
INTRODUCTION
The S5F333SZ03 is an interline transfer progressive scan
type square pixel CCD area image sensor of 1/3 inch optical
format developed for VGA. The electron accumulation time
can be changed by the electronic shutter function and it is
possible to obtain a frame still image without a mechanical
shutter. High resolution and good color reproduction are
accomplished by using mosaic R, G, B primary color filters. It
is suitable for still cameras and PC input cameras.
16Pin Cer - DIP
FEATURES
• 330K Pixel Progressive-scan CCD
• High Vertical Resolution (480 TV lines)
• Square Unit Pixel for VGA Format
• No Substrate Voltage Adjustment
• No DC bias on Reset Clock
• R, G, B Mosaic On-Chip Color Filter
• Optical Size 1/3 inch Format
• Variable Speed Electronic Shutter
• Low Smear
• High Antiblooming
• Horizontal Register 5V Drive
ORDERING INFORMATION
Device
S5F333SZ03-LBB0
Package
16Pin Cer - DIP
Operating
-10 °C +60 °C
STRUCTURE
• Number of Total Pixels:
• Number of Effective Pixels:
• Chip Size:
• Unit Pixel Size:
• Optical Blacks & Dummies:
692(H) × 504(V)
659(H) × 494(V)
6.00mm(H) × 4.95mm(V)
7.40 µm(H) × 7.40 µm(V)
Refer to Figure Below
16 2
659
Effective
Imaging
Area
(Top view)
31
Dummy Pixels
Optical Black Pixels
Effective Pixels
OUTPUT
H-CCD
1

1 page




S5F333SZ03-LBB0 pdf
1/3 INCH CCD IMAGE SENSOR FOR VGA COMPATIBILITY
DRIVE CLOCK WAVEFORM CONDITIONS
Read Out Clock Waveform
100%
90%
S5F333SZ03
10%
0%
VVH 2, VVH3
tr twh
tf
0V
Vertical Transfer Clock Waveform
¥Õ V 1
V VHH
V VHL
V VH3
V VHL
V VHH
V VH
V VL3
¥Õ V 2
V VHH
V VHH
V VH2
V VHL
V VH
V VHL
V VL
V VLL
V VLH
¥Õ V 3 V VH
V VHH
V VHH
V VHL
V VH4 V VHL
V VL2 V VLH
V VL
V VLL
VVH = VVH 2
V V L = (V VL 1 + V V L 3)/ 2
V ¥Õ V = V V H n - V V L n (n =1~3)
V VLH
V VLL
V VL 4
VVH H = VVH + 0.3V
VVH L = VVH - 0.3V
VVLH = VVL + 0.3V
VVLL = VVL - 0.3V
V VL
5

5 Page





S5F333SZ03-LBB0 arduino
1/3 INCH CCD IMAGE SENSOR FOR VGA COMPATIBILITY
S5F333SZ03
TEST METHODS
1. Measure the light intensities(L) when the average illuminance output value(Y) of green pixels Gr is equal to the
standard illuminance output value of 150mV (YA), and when it is equal to half of 150mV, 1/2 ×YA. repeat for Gb.
and calculate Sgr, Sgb, and Sg.
Sgr
=
YA 12--- YA
L-----Y---A----–----L-----12------Y---A-
,
Sgb
=
YA 12--- YA
L-----Y---A----–----L-----12------Y---A-
,
Sg = Sgr + Sgb
The sensitivities for red and blue pixels, Sr and Sb, are also measured in the same way.
Rr = S-S---g-r-, Rb = SS----bg--
2. Adjust the light intensity to 15 times of the value with which Y is YA, then measure the averaged illuminance
output value (Y = YSAT).
3. When the Gr pixel signal value, Ygr is 150mV, measure the Gb, R, B pixel signal values, Ygb, Yr, and Yb
respectively. Adjust the light intensity until 500 times of the illumination under which 150 mV of Gr pixels value
is obtained, is reached. Remove the read-out clock and drain the signal in photosensors by electronic shutter
operation during the horizontal blanking time without changing other clocks. Measure the maximum output value
YSM regardless of the pixel type..
SM = YSM ÷ -Y----g---r----+----Y-----g---b-4---+-----Y----r----+-----Y----b- × 5----01----0-- × 1--1--0-- × 100(%)
4. Measure the light intensity(LBM) on which the Y signal output value of the optical black pixels (OBP) is rapidly
increased with the increasing light intensity.
BM = L-L---B-Y---M-A--
5. Measure the maximum and minimum illuminance output value (YMAX, YMIN) when the light intensity is adjusted
to make Y to be YA.
U = -Y----M-----A---X--Y---–-A---Y-----M----I--N-- × 100(%)
6. Measure YD with the horizontal idling time transfer level as reference, when the device ambient temperature is
60 °C and all of the light sources are shielded.
11

11 Page







PáginasTotal 19 Páginas
PDF Descargar[ Datasheet S5F333SZ03-LBB0.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
S5F333SZ03-LBB01/3 INCH CCD IMAGE SENSOR FOR VGA COMPATIBILITYSamsung semiconductor
Samsung semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar