DataSheet.es    


PDF IMAGELINK-50-USB20 Data sheet ( Hoja de datos )

Número de pieza IMAGELINK-50-USB20
Descripción IMAGELINK-50-USB2.0
Fabricantes ETC 
Logotipo ETC Logotipo



Hay una vista previa y un enlace de descarga de IMAGELINK-50-USB20 (archivo pdf) en la parte inferior de esta página.


Total 28 Páginas

No Preview Available ! IMAGELINK-50-USB20 Hoja de datos, Descripción, Manual

SPECIFICATION
IMAGELINK-50 PAGE 1 OF 5
DISTEC GMBH
IMAGELINK-50-USB2.0
5” TFT Display with USB 2.0 HighSpeed
Interface
The information given in this document has been carefully checked and is correct to the best of our knowledge. Distec
GmbH reserves the right to make changes in products or specifications at any time and without further notice. Distec
GmbH products are not intended for use in systems in which product failures could result in personal injury. All
mentioned trademarks are registered trademarks of their owner.
DISTEC GMBH
Industriestrasse 1 D-82110
Germering
30.3.2004/sw1
http://www.distec.de
Tel.: +49-89-89 43 63-0
Fax: +49-89-89 43 63-39

1 page




IMAGELINK-50-USB20 pdf
2.2 USB Descriptors
2.2.1 HIGH-SPEED
ImageLink-50-USB2.0 V01.26
Manufacturer: Data Display Group
Serial Number: xxxxxx
Speed: 480Mb/s (high)
USB Version: 2.00
Device Class: 00(>ifc )
Device Subclass: 00
Device Protocol: 00
Maximum Default Endpoint Size: 64
Number of Configurations: 1
Vendor Id: ????
Product Id: ????
Revision Number: 1.26
Config Number: 1
Number of Interfaces: 1
Attributes: c0
MaxPower Needed: 0mA
Interface Number: 0
Name: dd_lou
Alternate Number: 0
Class: ff(vend.)
Sub Class: 0
Protocol: 0
Number of Endpoints: 2
Endpoint Address: 81
Direction: in
Attribute: 3
Type: Int.
Max Packet Size: 64
Interval: 16ms
Endpoint Address: 02
Direction: out
Attribute: 2
Type: Bulk
Max Packet Size: 512
Interval: 0ms
SPECIFICATION
IMAGELINK-50 PAGE 5 OF 5
DISTEC GMBH
Industriestrasse 1 D-82110
Germering
30.3.2004/sw1
http://www.distec.de
Tel.: +49-89-89 43 63-0
Fax: +49-89-89 43 63-39

5 Page





IMAGELINK-50-USB20 arduino
SPECIFICATION
IMAGELINK-50 PAGE 11 OF 5
3.2.2 SET_ DISPLAY_POWER
The SET_DISPLAY_POWER request is intended to switch the display power ON/OFF. A
return bitmap announces success or failure of power up or down.
Request
SET_
DISPLAY
_POWER
Bm
Request
Type
0xC0
B wValue
Request
wIndex wLength Data
0xB5
1. 2.
Byte Byte
bitmap value 0x0000 0x0002
1. Byte
return
bitmap
2.
Byte
0xB5
bitmap:
b7 b6 b5 b4
reserved reserved reserved reserved
0000
each bit can be set individually or together.
b3
reserved
0
b2
reserved
0
b1
reserved
0
b0
set actual
value
value:
0=OFF
1=ON
return bitmap:
b7 b6
reserved reserved
00
b5
reserved
0
b4
reserved
0
b3
reserved
0
b2
0= no
power
1= power
good
b1
reserved
0
b0
actual
state
0= OFF
1= ON
DISTEC GMBH
Industriestrasse 1 D-82110
Germering
30.3.2004/sw1
http://www.distec.de
Tel.: +49-89-89 43 63-0
Fax: +49-89-89 43 63-39

11 Page







PáginasTotal 28 Páginas
PDF Descargar[ Datasheet IMAGELINK-50-USB20.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
IMAGELINK-50-USB20IMAGELINK-50-USB2.0ETC
ETC

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar