DataSheet.es    


PDF ILX506 Data sheet ( Hoja de datos )

Número de pieza ILX506
Descripción 5000-pixel CCD Linear Image Sensor (B/W)
Fabricantes Sony Corporation 
Logotipo Sony Corporation Logotipo



Hay una vista previa y un enlace de descarga de ILX506 (archivo pdf) en la parte inferior de esta página.


Total 14 Páginas

No Preview Available ! ILX506 Hoja de datos, Descripción, Manual

ILX506
5000-pixel CCD Linear Image Sensor (B/W)
For the availability of this product, please contact the sales office.
Description
The ILX506 is a reduction type CCD linear sensor
developed for high resolution facsimiles and copiers.
This sensor reads A3-size documents at a density of
400 DPI (Dot Per Inch). A built-in timing generator
and clock-drivers ensure direct drive at 5V logic for
easy use. In addition, reset pulse can be switched
between internal generation and external input.
22 pin DIP (Ceramic)
Features
Number of effective pixels: 5000 pixels
Pixel size: 7µm × 7µm (7µm pitch)
Built-in timing generator and clock-drivers
Ultra low lag/ultra high sensitivity/low dark output
Single output method
Maximum clock frequency: 12.5MHz
Absolute Maximum Ratings
Supply voltage
VDD1
VDD2
Operating temperature
Storage temperature
11
6
–10 to +60
–30 to +80
V
V
°C
°C
Pin Configuration (Top View)
VGG 1
GND 2
VDD1 3
VOUT 4
GND 5
φROG 6
VDD2 7
VDD2 8
RSSW 9
T1 10
GND 11
1
5000
22 φCLK
21 VDD1
20 RS/SH
19 VDD1
18 VDD1
17 GND
16 VDD2
15 GND
14 T4
13 T3
12 T2
Sony reserves the right to change products and specifications without prior notice. This information does not convey any license by
any implication or otherwise under any patents or other right. Application circuits shown, if any, are typical examples illustrating the
operation of the devices. Sony cannot assume responsibility for any problems arising out of the use of these circuits.
–1–
E92239B78-PS

1 page




ILX506 pdf
ILX506
Electro-optical Characteristics (Note 1)
(Ta = 25°C, VDD1 = 9V, VDD2 = 5V, φCLK = 1MHz, Internal φRS mode without S/H,
Light source = 3200K, IR cut filter, CM-500S (t = 1.0mm))
Item Symbol
Sensitivity 1
R1
Sensitivity 2
R2
Sensitivity nonuniformity
PRNU
Saturation output voltage
VSAT
Saturation exposure
SE
Even and odd black level DC difference V
Dark voltage average
VDRK
Dark signal nonuniformity
DSNU
Image lag
IL
9V supply current
IVDD1
5V supply current
IVDD2
Total transfer efficiency
TTE
Output impedance
ZO
Offset level
VOS
Dynamic range
DR
Min.
7.5
1.0
0.072
92
500
Typ.
10.8
24.6
4
1.5
0.139
1.0
0.3
0.6
0.02
16
3
98
600
3.0
5000
Max.
13.9
10
10.0
2
3
32
7
Unit
V/(lx · s)
V/(lx · s)
%
V
lx · s
mV
mV
mV
%
mA
mA
%
V
Remarks
Note 2
Note 3
Note 4
Note 5
Note 6
Note 7
Note 8
Note 9
Note 10
Note 11
Note 12
Notes)
1) In accordance with the given electrooptical characteristics, the even black level is defined as the mean
value of D8, D10, D12 to D14.
The odd black level is defined as the mean value of D7 , D9, D11 and D13.
2) For the sensitivity test light is applied with a uniform intensity of illumination.
3) W lamp (2854K)
4) PRNU is defined as indicated below. Ray incidence conditions are the same as for Note 2.
PRNU = (VMAX – VMIN)/2 × 100 [%]
VAVE
Where the 5000 pixels are divided into blocks of 100, even and odd pixels, respectively. The maximum
output of each block is set to VMAX, the minimum output to VMIN and the average output to VAVE.
5) Use below the minimum value of the saturation output voltage.
6) Saturation exposure is defined as follows.
VSAT
SE = R1
7) Indicates the DC difference in value between odd black level and even black level.
8) Optical signal accumulated time τ int stands at 10ms.
–5–

5 Page





ILX506 arduino
ILX506
Example of Representative Characteristics (VDD1 = 9V, VDD2 = 5V, Ta = 25°C)
Spectral sensitivity characteristics
(Standard characteristics)
1.0
0.8
0.6
0.4
0.2
0
400 500 600 700 800 900 1000
Wavelength [nm]
MTF of main scanning direction (Standard characteristics)
Spatial frequency [cycles/mm]
0
1.0
14.3 28.6 42.9 57.1 71.4
0.8
0.6
0.4
0.2
0
0 0.2 0.4 0.6 0.8 1.0
Normalized spatial frequency
Dark signal output temperature characteristics
(Standard characteristics)
Integration time output voltage characteristics
(Standard characteristics)
10
5
1
1
0.5
0.5
0.1
0
10 20 30 40 50
Ta – Ambient temperature [°C]
60
0.1
1
– 11 –
5
τ int – Integration time [ms]
10

11 Page







PáginasTotal 14 Páginas
PDF Descargar[ Datasheet ILX506.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
ILX5032048-pixel CCD Linear Image Sensor (B/W)Sony Corporation
Sony Corporation
ILX503A2048-pixel CCD Linear Image Sensor (B/W)Sony Corporation
Sony Corporation
ILX505A2592-pixel CCD Linear Image Sensor (B/W)Sony Corporation
Sony Corporation
ILX5065000-pixel CCD Linear Image Sensor (B/W)Sony Corporation
Sony Corporation

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar