DataSheet.es    


PDF KC75118 Data sheet ( Hoja de datos )

Número de pieza KC75118
Descripción 1/5 INCH CCD IMAGE SENSOR FOR NTSC CAMERA
Fabricantes Samsung semiconductor 
Logotipo Samsung semiconductor Logotipo



Hay una vista previa y un enlace de descarga de KC75118 (archivo pdf) en la parte inferior de esta página.


Total 20 Páginas

No Preview Available ! KC75118 Hoja de datos, Descripción, Manual

KC75118C
1/5 INCH CCD IMAGE SENSOR FOR NTSC CAMERA
INTRODUCTION
The KC75118C is an interline transfer CCD area image
sensor developed for NTSC 1/5 inch optical format PC
cameras, object detector and image pattern recognizer. High
sensitivity is achieved through the adoption of Ye, Cy, Mg and
G complementary color mosaic filter, on-chip micro lenses.
This chip features a field integration read out system and an
electronic shutter with variable charge storage time.
14Pin Cer DIP
FEATURES
• Optical Size 1/5 inch Format
• Ye, Cy, Mg, G On-chip Complementary
Color Mosaic Filter
• Variable Speed Electronic Shutter
(1/60, 1/100 ~ 1/10, 000sec)
• Horizontal Register 3.3V ~ 5V Drive
• 14pin Ceramic DIP Package
• No Adjust Substrate Bias
• Field Integration Read Out System
• No DC Bias on Reset Gate
ORDERING INFORMATION
Device
KC75118C
Package
Operating
14Pin Cer DIP -10 °C ~ +60 °C
STRUCTURE
• Number of Total Pixels:
• Number of Effective Pixels:
• Chip Size:
• Unit Pixel Size:
• Optical Blacks & Dummies:
381(H) × 506(V)
362(H) × 492(V)
3.75mm(H) × 3.30mm(V)
8.10µm(H) × 4.45µm(V)
Refer to Figure Below
Vertical 1 Line (Even Field Only)
14 2
362
Effective
Imaging
Area
17
Dummy Pixels
Optical Black Pixels
Effective Pixels
OUTPUT
H-CCD
1

1 page




KC75118 pdf
KC75118C
1/5 INCH CCD IMAGE SENSOR FOR NTSC CAMERA
DRIVE CLOCK WAVEFORM CONDITIONS
Read Out Clock Waveform
100%
90%
10%
0%
VVH 1, VVH3
tr twh
tf
0V
Vertical Transfer Clock Waveform
¥Õ V 1
V VH1
V VH
V VH H
V VH H
VVHL
VVHL
V VL 1
V VLH
V VL
V VLL
¥Õ V 2
V VHH
V VHH
V VH2
V VHL
V VH
V VHL
¥Õ V 3
V VHH
V VHL
V VH3
V VHL
V VHH
V VH
V VL3
V VL
V VLL
V VLH
¥Õ V 4 V VH
V VHH
V VHH
V VHL
V VH4 V VHL
V VL2 V VLH
V VL
V VLL
V VH = (V VH 1 + V VH 2)/ 2
V VL = (V VL 3 + V VL 4)/ 2
V ¥Õ V = V V H n - V V L n (n =1~4)
V VLH
V VL L
V VL4
VVH H = VVH + 0.3V
VVH L = VVH - 0.3V
VVL H = VVL + 0.3V
VVL L = VVL - 0.3V
V VL
5

5 Page





KC75118 arduino
KC75118C
1/5 INCH CCD IMAGE SENSOR FOR NTSC CAMERA
RY = [(Mg + Ye) (G + Cy)] = (2R G)
Next, the signals through H-CCD at line A2 are [Mg+Cy], [G+Ye], [Mg+Cy], [G+Ye]. Simmilary, Y and C signals are
composed at line A2 as follows
Y = 12---[(G + Ye) + (Mg + Cy)] = 12---(2B + 3G + 2R )
(B Y) = [(G + Ye) (Mg + Cy)] = –(2B G)
Accordingly, Y signal is balanced in relation to scanning lines, and C signal takes the form of R-Y and -(B-Y) on
alternate lines.
It is same for B field.
TEST METHODS
1. Measure the light intensities (L) when the averaged illuminance output value (Y) is the standard illuminance
output value, 150mV (YA) and when half of 150mV (1/2 YA).
S
=
YA 12---YA
-L----Y---A------–----L----12-------Y---A--
2. Adjust the light intensity to 10 times that of Y signal output average value (YA = 150mV) , then test Y signal
minimum value (Y = YSAT).
3. Adjust the light intensity to 500 times that of Y signal output average value (YA = 150mV), then remove the read-
out clock and drain the signal in photosensors by the electronic shutter operation in all the respective horizontal
blanking times with the other clocks unchanged. Measure the maximum illuminance output value (YSM).
SM = Y---Y--S--A-M--- × 5----10----0-- × 1---1--0-- × 100(%)
4. Adjust the light intensity to 1,000 times of the value with which Y is YA, then inspect whether there is blooming
phenomenon or not.
11

11 Page







PáginasTotal 20 Páginas
PDF Descargar[ Datasheet KC75118.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
KC751181/5 INCH CCD IMAGE SENSOR FOR NTSC CAMERASamsung semiconductor
Samsung semiconductor
KC75118C1/5 INCH CCD IMAGE SENSOR FOR NTSC CAMERASamsung semiconductor
Samsung semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar