|
|
Número de pieza | EL4332 | |
Descripción | Triple 2:1 300 MHz Mux-Amp AV =2 | |
Fabricantes | Elantec Semiconductor | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de EL4332 (archivo pdf) en la parte inferior de esta página. Total 17 Páginas | ||
No Preview Available ! EL4332C
Triple 2:1 300 MHz Mux-Amp AV =2
Features
• 3 ns A-B switching
• 300 MHz bandwidth
• Fixed gain of 2, for cable driving
• > 650V/µs slew rate
• TTL/CMOS compatible switch
Applications
• RGB multiplexing
• Picture-in-picture
• Cable driving
• HDTV processing
• Switched gain amplifiers
• ADC input multiplexer
Ordering Information
Part No.
EL4332CS
Temp. Range
-40°C to 85°C
Package
SO16
Outline #
MDP0027
General Description
The EL4332C is a triple very high speed 2:1 Multiplexer-Amplifier. It
is intended primarily for component video multiplexing and is espe-
cially suited for pixel switching. The amplifiers have their gain set to 2
internally, which reduces the need for many external components. The
gain-of-2 facilitates driving back terminated cables. All three amplifi-
ers are switched simultaneously from their A to B inputs by the
TTL/CMOS compatible, common A/B control pin.
A -3 dB bandwidth of 300 MHz together with 3 ns multiplexing time
enable the full performance of the fastest component video systems to
be realized.
The EL4332C runs from standard ±5V supplies, and is available in the
narrow 16-pin small outline package.
Connection Diagrams
Demo Board
A demo PCB is available for this prod-
uct. Request “EL4332/1 Demo Board.”
© 1995 Elantec, Inc.
1 page Typical Performance Curves
Small Signal Transient Response
EL4332C
Triple 2:1 300 MHz Mux-Amp AV =2
Large Signal Transient Response
Switching to Ground from a Large
Signal Uncorrelated Sine Wave
Switching from Ground to a Large
Signal Uncorrelated Sine Wave
Switching to Ground from a Small
Signal Uncorrelated Sine Wave
Switching from Ground to a Small
Signal Uncorrelated Sine Wave
5
5 Page EL4332C
Triple 2:1 300 MHz Mux-Amp AV =2
used, a 220Ω to 330Ω resistor to the -5.2V rail would
have the same effect.
Expanding the Multiplexer
In Figure 4, a 3:1 multiplexer circuit is shown. The
expansion to more inputs is very straight forward. Since
the EL4332C has a fixed gain of 2, interstage attenuators
may be required as shown in Figure 3. The truth table for
the 3:1 multiplexer select lines is:
XY
00
01
1X
Mux Output
R3, G3, B3
R2, G2, B2
R1, G1, B1
When interstage attenuators are used, the values should
be kept down in the region of 50Ω–300Ω. This is to pre-
vent a combination of circuit board stray capacitance
and the EL4332C’s input capacitance forming a signifi-
cant pole. For example, if instead of 100Ω as shown,
resistors of 1 kΩ had been used, and assuming 3 pF of
stray and 3 pF of input capacitance, a pole would be
formed at about 53 MHz.
Figure 4. Typical Connection for a 3:1 Component Video Multiplexer
11
11 Page |
Páginas | Total 17 Páginas | |
PDF Descargar | [ Datasheet EL4332.PDF ] |
Número de pieza | Descripción | Fabricantes |
EL4331 | Triple 2:1 Mux-Amp AV = 1 | Intersil Corporation |
EL4331C | Triple 2:1 Mux-Amp AV = 1 | Elantec Semiconductor |
EL4331CS | Triple 2:1 Mux-Amp AV = 1 | Elantec Semiconductor |
EL4331CS | Triple 2:1 Mux-Amp AV = 1 | Intersil Corporation |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |