DataSheet.es    


PDF FOD2200TV Data sheet ( Hoja de datos )

Número de pieza FOD2200TV
Descripción LOW INPUT CURRENT LOGIC GATE OPTOCOUPLERS
Fabricantes Fairchild Semiconductor 
Logotipo Fairchild Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de FOD2200TV (archivo pdf) en la parte inferior de esta página.


Total 14 Páginas

No Preview Available ! FOD2200TV Hoja de datos, Descripción, Manual

LOW INPUT CURRENT
LOGIC GATE OPTOCOUPLERS
FOD2200
DESCRIPTION
The FOD2200 is an optically coupled logic gate that combine an AlGaAs LED
and an integrated high gain photo detector. The detector has a three state
output stage and has a detector threshold with hysteresis. The three state
output eliminates the need for a pullup resistor and allows for direct drive of
data busses. The hysteresis provides differential mode noise immunity and
eliminates the potential for output signal chatter.
The Electrical and Switching Characteristics of the FOD2200 are guaranteed
over the temperature range of 0°C to 85°C and a VCC range of 4.5 volts to 20
volts. Low IF and wide VCC range allow compatibility with TTL, LSTTL, and
CMOS logic and result in lower power consumption compared to other high
speed optocouplers. Logic signals are transmitted with a maximum propaga-
tion delay of 300 nsec. The FOD2200 is useful for isolating high speed logic
interfaces, buffering of input and output lines, and implementing isolated line
receivers in high noise environments.
8
1
8
1
8
1
FEATURES
• 1 kV/µs Minimum Common Mode
Rejection
• Compatible with LSTTL, TTL, and CMOS
Logic
• Wide VCC Range (4.5 to 20 V)
• 2.5 Mbd Guaranteed over Temperature
• Low Input Current (1.6 mA)
• Three State Output (No Pullup Resistor
Required)
• Guaranteed Performance from 0°C to 85°C
• Hysteresis
• Safety Approvals Pending – UL, CSA, VDE
• VISO = 5kVRMS
APPLICATION
• Isolation of High Speed Logic Systems
• Computer-Peripheral Interfaces
• Microprocessor System Interfaces
• Ground Loop Elimination
• Pulse Transformer Replacement
• Isolated Buss Driver
• High Speed Line Receiver
NC 1
ANODE 2
CATHODE 3
NC 4
Schematic
IF
+
2
VF
3
SHIELD
SHIELD
8 VCC
7 VO
6 VE
5 GND
ICC
VCC
8
IO
7 VO
IE
6 VE
GND
5
TRUTH TABLE (Positive Logic)
LED
On
Off
On
Off
Enable
H
H
L
L
© 2004 Fairchild Semiconductor Corporation
Page 1 of 14
Output
Z
Z
H
L
7/7/04

1 page




FOD2200TV pdf
LOW INPUT CURRENT
LOGIC GATE OPTOCOUPLERS
FOD2200
NOTES
1. The VCC supply to each optoisolator must be bypassed by a 0.1µF capacitor or larger. This can be either a ceramic or solid
tantalum capacitor with good high frequency characteristic and should be connected as close as possible to the package VCC
and GND pins of each device.
2. tPLH - Propagation delay is measured from the 50% level on the LOW to HIGH transition of the input current pulse to the
1.3V level on the LOW to HIGH transition of the output voltage pulse.
3. tPHL - Propagation delay is measured from the 50% level on the HIGH to LOW transition of the input current pulse to the 1.3V
level on the HIGH to LOW transition of the output voltage pulse.
4. When the peaking capacitor is omitted, propagation delay times may increase by 100 ns.
5. tr - Rise time is measured from the 10% to the 90% levels on the LOW to HIGH transition of the output pulse.
6. tf - Fall time is measured from the 90% to the 10% levels on the HIGH to LOW transition of the output pulse.
7. CMH - The maximum tolerable rate of fall of the common mode voltage to ensure the output will remain in the high state (i.e.,
VOUT > 2.0 V).
8. CML - The maximum tolerable rate of rise of the common mode voltage to ensure the output will remain in the low state (i.e.,
VOUT < 0.8 V).
9. Device considered a two-terminal device: Pins 1,2,3 and 4 shorted together, and Pins 5,6,7 and 8 shorted together.
10. Duration of output short circuit time should not exceed 10 ms.
© 2004 Fairchild Semiconductor Corporation
Page 5 of 14
7/7/04

5 Page





FOD2200TV arduino
LOW INPUT CURRENT
LOGIC GATE OPTOCOUPLERS
Carrier Tape Specifications
K0 t
W1
P0 P2
A0
B0
d User Direction of Feed
P
Description
Tape Width
Tape Thickness
Sprocket Hole Pitch
Sprocket Hole Diameter
Sprocket Hole Location
Pocket Location
Pocket Pitch
Pocket Dimensions
Cover Tape Width
Cover Tape Thickness
Max. Component Rotation or Tilt
Min. Bending Radius
Symbol
W
t
P0
D0
E
F
P2
P
A0
B0
K0
W1
d
R
FOD2200
D0
E
F
W
D1
Dimension in mm
16.0 ± 0.3
0.30 ± 0.05
4.0 ± 0.1
1.55 ± 0.05
1.75 ± 0.10
7.5 ± 0.1
4.0 ± 0.1
12.0 ± 0.1
10.30 ±0.20
10.30 ±0.20
4.90 ±0.20
1.6 ± 0.1
0.1 max
10°
30
© 2004 Fairchild Semiconductor Corporation
Page 11 of 14
7/7/04

11 Page







PáginasTotal 14 Páginas
PDF Descargar[ Datasheet FOD2200TV.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
FOD2200TLOW INPUT CURRENT LOGIC GATE OPTOCOUPLERSFairchild Semiconductor
Fairchild Semiconductor
FOD2200TVLOW INPUT CURRENT LOGIC GATE OPTOCOUPLERSFairchild Semiconductor
Fairchild Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar