DataSheet.es    


PDF EN1CS1 Data sheet ( Hoja de datos )

Número de pieza EN1CS1
Descripción ENMods Component Power Front End System for EN Compliance
Fabricantes Vicor Corporation 
Logotipo Vicor Corporation Logotipo



Hay una vista previa y un enlace de descarga de EN1CS1 (archivo pdf) en la parte inferior de esta página.


Total 12 Páginas

No Preview Available ! EN1CS1 Hoja de datos, Descripción, Manual

PRELIMINARY
45
Features
Harmonic Current Attenuation to
EN61000-3-2
EMI Filtering to
EN55022, Level B
Transient Immunity to
EN61000-4-5
575W Rated Power Output
Autoranging 115/230Vac Input
Microprocessor Control
Inrush Current Limiting
Product Highlights
The ENMods system is a new AC front end
solution for compliance to electromagnetic
compatibility (EMC) standards. It consists of
the MiniHAM — a passive harmonic
attenuation module and the FARM3 — an
auto ranging AC-DC front end module.
Combined with the filtering and hold-up
capacitors as specified herein, the ENMods
system provides full compliance to:
EN61000-3-2 Harmonic Current
EN55022, Level B Conducted Emissions
EN61000-4-5 Surge Immunity
EN61000-4-11 Line Disturbances
Data Sheet
ENModsTM
Component Power
Front End System
for EN Compliance
Each module:
2.28 x 2.2 x 0.5 in
57,9 x 55,9 x 12,7 mm
Absolute Maximum Ratings
Parameter
L to N voltage (FARM3)
L to N voltage (FARM3)
+Out to –Out voltage (FARM3)
BOK to –Out voltage (FARM3)
EN to –Out voltage (FARM3)
Mounting torque
Pin soldering temperature
Pin soldering temperature
Output current
Rating
264
280
400
16
16
4-6(0.45 -0.68)
500 (260)
750 (390)
3.5
Unit
Vrms
Vrms
Vdc
Vdc
Vdc
in-lbs (N-m)
°F (°C)
°F (°C)
A
Notes
Continuous
100ms
6 each, 4-40 screw
<5 sec; wave solder
<7 sec; hand solder
The MiniHAM is the first passive product
specifically designed for compliance to EN
harmonic current limits. Unlike active PFC
solutions, the MiniHAM generates no EMI,
greatly simplifying and reducing system
noise filtering requirements. It is also
considerably smaller and more efficient than
active alternatives and improves MTBF by
an order of magnitude. Optimized for
operation on the DC bus (provided by the
FARM3) rather than directly on the AC line,
it will provide harmonic current compliance
up to 600W of input power at 230Vac.
The 115/230Vac input FARM3 is a new
member of Vicor’s Filter and Autoranging
Module product line that has been optimized
for use as the front end for the MiniHAM.
Both modules are in Vicor’s standard Mini
half-brick package. Together with Vicor’s
1st or 2nd Generation 300V input DC-DC
converters, they form the basis of a low
noise, high efficiency, rugged, simple and
reliable EN compliant power system.
Thermal Resistance
Parameter
Baseplate to sink; flat, greased surface
Baseplate to sink; with thermal pad (P/N 20264)
Baseplate to ambient
Baseplate to ambient; 1000 LFM
Typ
0.16
0.14
8.0
1.9
Unit
°C/Watt
°C/Watt
°C/Watt
°C/Watt
Part Numbering
EN1
C
1
Product
Type*
Product Grade
C = –20°C to +100°C
T = –40°C to +100°C
H = –40°C to +100°C
M = –55°C to +100°C
Pin Style**
1 = Short Pin
2 = Long Pin
S = Short ModuMate
N = Long ModuMate
1
Baseplate
1 = Slotted
2 = Threaded
3 = Thru-hole
*EN1 product includes one each MiniHAM and FARM3 with same product grade, pin and baseplate style.
**Pin styles S & N are compatible with the ModuMate interconnect system for socketing and surface mounting.
Vicor Corp. Tel: 800-735-6200, 978-470-2900 Fax: 978-475-6715
ENMods System: FARM3 and MiniHAM
Set your site on VICOR at www.vicorpower.com
Rev. 1.3
Page 1 of 12

1 page




EN1CS1 pdf
Operating Characteristics (FARM3)
PRELIMINARY
Vdc output
Strap
Engaged
Enable
B OK
Figure 3—Start-up at 120Vac input
Vdc output
Iac input @2A / mV
Enable
B OK
Figure 5—Power-down from 120Vac
Vdc output
Enable
B OK
Figure 4—Start-up at 240Vac input
Vdc output
Iac input @2A / mV
Enable
B OK
Figure 6—Power-down from 240Vac
Vdc output
Enable
B OK
Figure 7—Output overvoltage protection 240Vac range
Vicor Corp. Tel: 800-735-6200, 978-470-2900 Fax: 978-475-6715
ENMods System: FARM3 and MiniHAM
Set your site on VICOR at www.vicorpower.com
Rev. 1.3
Page 5 of 12

5 Page





EN1CS1 arduino
Mechanical Diagram
PRELIMINARY
0.50 ±0.02
12,7 ±0,5
0.23
5,8
(REF)
0.300 ±0.015
7,62 ±0,38
2.20
55,9
1.74
44,2
0.300 ±0.015
7,62 ±0,38
12
34
9 876 5
Slotted (Style 1)
or
Threaded (Style 2)
4-40 UNC-2B (6X)
or
Thru Hole (Style 3)
#30 Drill Thru (6X)
(0.1285)
0.400
10,16
0.700
17,78
1.000
25,40
1.400
35,56
PCB Mounting Specifications
1.900
48,26
0.12
3,1
0.01
0.49
12,4
0.35 (2X)
8,8
0.65
2.28
16,5
1.30
57,9 33,0
0.150
3,81
DIA,(2X)
0.080 DIA,(7X)
2,03
0.42
10,6
R 0.06 (3X)
1,5
0.54
13,7
(9X)
Pin
Style
(Short
1&S
)
0.62
15,7
(9X)
Pin
Style 2
(Long)
&N
2.000
50,80
2.20
55,9
(REF.)
0.10
2,5
0.10
2,5
X
45˚
CHAMFER
FULL R (6X)
0.130 (6X)
3,30
Use a 4-40 Screw (6X)
Torque to:
5 in-lbs
0.57 N-m
Pin No.
1
2
3
4
5
6
7
8
9
FARM3
Function
Label
Neutral
N
EMI GND
Signal Return SR
Line L
Out
Enable
EN
Strap
ST
BUS OK
BOK
+Out
+
MiniHAM
Function
Label
Neutral /+ In N /+
NC NC
NC NC
Line /In
L /
Line /Out
L /
NC NC
NC NC
NC NC
Neutral /+ Out N /+
PCB
THICKNESS
0.062
1,57
±0.010
±0,25
R 0.06 (4X)
1,5
1.790
45,47
PLATED
THRU HOLE
DIA
0.158
4,01
12
34
INBOARD
SOLDER
MOUNT
PIN STYLE 1
(7X) 0.094 ±0.003
2,39 ±0,08
(2X) 0.164 ±0.003
4,16 ±0,08
ONBOARD
SOLDER
MOUNT
PIN STYLE 2
0.094 ±0.003
2,39 ±0,08
0.164 ±0.003
4,16 ±0,08
ALL MARKINGS
THIS SURFACE
ALUMINUM
BASEPLATE
1.900*
48.,26
1.584*
40,23
9 87 6 5
0.400*
10,16
0.195
4,95
0.700*
17,78
1.000*
25,40
1.400*
35,56
* DENOTES
TOL = ±0.003
±0,08
0.43 0.53
10,9 13,5
Note: Pin styles S & N require use of ModuMate interconnection socketing systems.
See SurfMate or InMate Design guides for PCB specifications.
Vicor Corp. Tel: 800-735-6200, 978-470-2900 Fax: 978-475-6715
ENMods System: FARM3 and MiniHAM
Set your site on VICOR at www.vicorpower.com
Rev. 1.3
Page 11 of 12

11 Page







PáginasTotal 12 Páginas
PDF Descargar[ Datasheet EN1CS1.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
EN1CS1ENMods Component Power Front End System for EN ComplianceVicor Corporation
Vicor Corporation
EN1CS2ENMods Component Power Front End System for EN ComplianceVicor Corporation
Vicor Corporation
EN1CS3ENMods Component Power Front End System for EN ComplianceVicor Corporation
Vicor Corporation

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar