|
|
PDF LZ34C10 Data sheet ( Hoja de datos )
| Número de pieza | LZ34C10 | |
| Descripción | 1/4-type Color CMOS Image Sensor with 110 k Pixels | |
| Fabricantes | Sharp Electrionic Components | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de LZ34C10 (archivo pdf) en la parte inferior de esta página. Total 12 Páginas | ||
|
No Preview Available !
LZ34C10
LZ34C10
1/4-type Color CMOS Image Sensor with
110 k Pixels
DESCRIPTION
The LZ34C10 is a 1/4-type (4.5 mm) solid-state
color image sensor that consists of PN photo-
diodes and CMOS (Complementary Metal Oxide
Semi-conductor) devices. The sensor further
includes a timing generator (TG), a correlated
double sampling (CDS) circuit, an auto gain control
(AGC) circuit and an analog-to-digital converter
(ADC) circuit. With approximately 110 000 pixels
(393 horizontal x 299 vertical), the sensor provides
a stable digital color image with extremely low
power consumption.
FEATURES
• Progressive scan
• Square pixel
• Compatible with CIF standard
• Number of effective pixels : 367 (H) x 291 (V)
• Number of optical black pixels
– Horizontal : 13 front and 13 rear
– Vertical : 4 front and 4 rear
• Pixel pitch : 9.4 µm (H) x 9.4 µm (V)
• R, G, and B primary color mosaic filters
• Image inversion function (horizontally and/or
vertically)
• Power save mode
• Analog output and 8-bit digital output
• Variable gain control (3 to 30 dB)
• Variable electronic shutter (1/30 to 1/10 000 s)
• Single +3.0 V power supply
• Package : 36-pin WLCC* (WLCC036-N-R625)
* Window Leadless Chip Carrier
PIN CONNECTIONS
36-PIN WLCC
TOP VIEW
REFIN
AGCSET
BIAS3
AGCOUT
AGND
AVDD
OFS
ADL
DAL
DAH
AGND
DGND
1
2
3
4
5
6
7
8
9
10
11
12
30 BIAS2
29 NC
28 SCLK
27 SDI
26 VD
25 HD
24 CLK
23 D7
22 D6
21 D5
20 D4
19 D3
(WLCC036-N-R625)
PRECAUTIONS
• The exit pupil position of lens should be more
than 15 mm from the top surface of the CMOS
image sensor.
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP devices shown in
catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
1
1 page  
LZ34C10
CHARACTERISTICS (1/30 s progressive scan readout mode)
(TA = 25 ˚C, Operating conditions : The typical values specified in "RECOMMENDED OPERATING CONDITIONS".
Color temperature of light source : 3 200 K, IR cut-off filter (CM-500, 1mmt) is used.)
• Measurement point : Analog image signal output (pin no. 34), before AGC circuit and AD converter.
PARAMETER
SYMBOL
MIN.
TYP.
MAX.
UNIT
NOTE
Standard output voltage
VO
150 mV 1
Photo response non-uniformity
PRNU
14 %
2
Saturation output voltage
VSAT
600 1 000
mV 3
Dark output voltage
Dark signal non-uniformity
VDARK
DSNU
2 6 mV 4
3 10 mV 5
Sensitivity (Green channel)
R 210 350
mV 6
Supply current
IVDD
10 mA 7
Vertical line fixed pattern noise
VFPN
0.4
1.0 mVp-p
8
NOTES :
1. The average output voltage of G signal under uniform
illumination. The standard exposure conditions are
defined as when VO is 150 mV.
2. The image area is divided into 10 x 10 segments under
the standard exposure conditions. Each segment's
voltage is the average output voltage of all pixels within
the segment. PRNU is defined by (Vmax – Vmin)/VO,
where Vmax and Vmin are the maximum and minimum
values of each segment's voltage respectively.
3. The image area is divided into 10 x 10 segments. Each
segment's voltage is the average output voltage of all
pixels within the segment. VSAT is the minimum
segment's voltage under 10 times exposure of the
standard exposure conditions.
4. The difference between average output voltage of the
effective area and that of the OB (A) area, under non-
exposure conditions.
5. The image area is divided into 10 x 10 segments under
non-exposure conditions. DSNU is defined by (Vdmax –
Vdmin), where Vdmax and Vdmin are the maximum and
minimum values of each segment's voltage respectively.
6. The average output voltage of G signal when a 1 000
lux light source with a 90 % reflector is imaged by a lens
of F4, F50 mm.
7. Total current of analog and digital power supplies, in the
dark and at the standard load conditions.
8. One mean horizontal line signal <bi> is obtained by
adding all the horizontal line signals <aij> vertically and
dividing them by the line number. <xi> is the deviation of
the center pixel from the average of successive 5 pixels
in <bi>. VFPN is the maximum absolute value of <xi>.
5
5 Page 
EXAMPLE OF OPERATION CIRCUIT
LZ34C10
D3
D4
D5
D6
D7
CLK
HD
VD
SDI
SCLK
NC
BIAS2
DGND
AGND
DAH
DAL
ADL
OFS
AVDD
AGND
AGCOUT
BIAS3
AGCSET
REFIN
+
11
11 Page | ||
| Páginas | Total 12 Páginas | |
| PDF Descargar | [ Datasheet LZ34C10.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| LZ34C10 | 1/4-type Color CMOS Image Sensor with 110 k Pixels | Sharp Electrionic Components |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |