|
|
Número de pieza | AH201 | |
Descripción | Medium Power/ High Linearity Amplifier | |
Fabricantes | ETC | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de AH201 (archivo pdf) en la parte inferior de esta página. Total 4 Páginas | ||
No Preview Available ! AH201
Medium Power, High Linearity Amplifier
The Communications Edge TM
Preliminary Product Information
Product Features
Product Description
• 400 – 2200 MHz
• +30 dBm P1dB
• +47 dBm Output IP3
• 17 dB Gain @ 900 MHz
•zMTBF >100 Years
• Single Positive Supply (9-12V)
• Internally Matched
• 24dBm IS-95 Channel Power
@ -45dBc ACPR
The AH201 is a 1W driver amplifier that offers
excellent dynamic range in a low cost, 6x6mm
surface mount package. This device can be biased as
low as +9V for lower power applications and as high
as +12V for improved P1dB and OIP3 performance.
The backside metalization allows excellent thermal
dissipation while allowing visible evidence of solder
reflow throughout the bottom of the package on a
SMT board. Superior thermal design allows the
product an MTBF of over 100 years at a mounting
temperature of +85ºC. All devices are 100% RF &
DC tested.
Actual Size
The product is targeted for use as driver amplifiers for
wireless infrastructure where high linearity and
medium power is required.
Functional Diagram
1 10
56
Top View
Function
Input
Output/Bias
Ground
Ground
Not Connected
Pin No.
2
9
1, 2, 3, 5
6, 7, 8, 10
4
Specifications
Typical Specifications
Parameters
Units Min Typ. Max
Frequency Range
MHz
400-2200
S 21 - Gain
S11 - Input Return Loss
dB
dB
15
-9.5
S22 - Output Return Loss dB
-10
Noise Figure
dB
4
Output P1dB
dBm
+30
Output IP3
dBm +47
Operating Current Range mA
310
330
370
Supply Voltage
V
11
Thermal Resistance
Rth
14
Test conditions unless otherwise noted.
1. T = 25ºC, Vdd = 11V, Frequency = 800 MHz, 50 Ohm system.
2. 3OIP measured with two tones at an output power of 10 dBm/tone separated by 10 MHz.
The suppression on the largest IM3 product is used to calculate the 3OIP using a 2:1 rule.
Parameters
Units
Typical
Frequency
S21 - Gain
S11 - Input R.L.
S22 - Output R.L.
Noise Figure
Output P1dB
Output IP3
IS-95 Channel Power
@ -45dBc ACPR
MHz
dB
dB
dB
dB
dBm
dBm
dBm
900
17
-13
-15
3.8
+30.0
+47
+24
1900
15
-9.5
-9.5
4.3
+29.5
+47
+23.6
2200
14
-9.3
-9.0
4.4
+29.3
+47
+23.5
Typical parameters reflect performance in an application circuit.
1. T = 25ºC, Vdd = 11V
2. 3OIP measured with two tones at an output power of 10 dBm/tone separated by 10 MHz.
The suppression on the largest IM3 product is used to calculate the 3OIP using a 2:1 rule.
Recommended Maximum Rating
Parameters
Rating
Operating Case Temperature
Storage Temperature
DC Voltage
RF Input Power (continuous)
Junction Temperature
-40 to +85 °C
-40 to +125 °C
+15 V
+20 dBm
+155° C
Ordering Information
Part No.
Description
AH201
AH201-PCB-900
AH201-PCB-1900
Med. Power High Linearity Amp.
(Available in Tape & Reel)
400-1000 MHz Evaluation Board
1600-2200 MHz Evaluation Board
This document contains information on a new product.
Specifications and information are subject to change without notice
WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: 408-577-6620 • e-mail: [email protected] • Web site: www.wj.com
May 2002
1 page |
Páginas | Total 4 Páginas | |
PDF Descargar | [ Datasheet AH201.PDF ] |
Número de pieza | Descripción | Fabricantes |
AH20 | Hub Installation Instructions | Aperio |
AH200 | Rectifier | Marconi |
AH201 | Medium Power/ High Linearity Amplifier | ETC |
AH201 | Rectifier | Marconi |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |