DataSheet.es R0487YS14E Hoja de datos PDF


PDF R0487YS14E Datasheet ( Hoja de datos )

Número de pieza R0487YS14E
Descripción Distributed Gate Thyristor
Fabricantes IXYS 
Logotipo IXYS Logotipo
Vista previa
Total 12 Páginas
		
R0487YS14E datasheet

1 Page

R0487YS14E pdf
WESTCODE An IXYS Company
Distributed Gate Thyristor types R0487YS10# to R0487YS14#
15.0 Reverse Recovery Loss
15.1 Determination by Measurement
From waveforms of recovery current obtained from a high frequency shunt (see Note 1, Page 5) and
reverse voltage present during recovery, an instantaneous reverse recovery loss waveform must be
constructed. Let the area under this waveform be E joules per pulse. A new heat sink temperature can
then be evaluated from the following:
( )TK (new) = TK (original ) E k + f Rth(JK )
Where k=0.227 (°C/W)/s
E = Area under reverse loss waveform per pulse in joules (W.s.)
f = rated frequency Hz at the original heat sink temperature.
Rth(JK) = d.c. thermal resistance (°C/W).
The total dissipation is now given by:
W (TOT) = W (original) + E f
15.2 Determination without Measurement
In circumstances where it is not possible to measure voltage and current conditions, or for design
purposes, the additional losses E in joules may be estimated as follows.
Let E be the value of energy per reverse cycle in joules (curves in Figure 9).
Let f be the operating frequency in Hz
( )TK (new) = TK (original ) E Rth f
Where TK (new) is the required maximum heat sink temperature and
TK (original) is the heat sink temperature given with the frequency ratings.
A suitable R-C snubber network is connected across the thyristor to restrict the transient reverse voltage
to a peak value (Vrm) of 67% of the maximum grade. If a different grade is being used or Vrm is other than
67% of Grade, the reverse loss may be approximated by a pro rata adjustment of the maximum value
obtained from the curves.
NOTE 1- Reverse Recovery Loss by Measurement
This thyristor has a low reverse recovered charge and peak reverse recovery current. When measuring
the charge, care must be taken to ensure that:
(a) a.c. coupled devices such as current transformers are not affected by prior passage of high
amplitude forward current.
(b) A suitable, polarised, clipping circuit must be connected to the input of the measuring oscilloscope
to avoid overloading the internal amplifiers by the relatively high amplitude forward current signal
(c) Measurement of reverse recovery waveform should be carried out with an appropriate critically
damped snubber, connected across diode anode to cathode. The formula used for the calculation
of this snubber is shown below:
R2 = 4 Vr
CS
di
dt
Vr = Commutating source voltage
Where: CS = Snubber capacitance
R = Snubber resistance
Data Sheet. Type R0487YS10# to R0487YS14# Issue 3
Page 5 of 12
October, 2004

5 Page

R0487YS14E arduino
WESTCODE An IXYS Company
Figure 13 - Sine wave frequency ratings
1.00E+05
250A
R0487YS10#-14#
Issue 3
Tk=55°C
100% Duty Cycle
500A
1.00E+04
1kA
1.00E+03
2kA
3kA
1.00E+02
Distributed Gate Thyristor types R0487YS10# to R0487YS14#
Figure 14 - Sine wave frequency ratings
1.00E+05
250A
R0487YS10#-14#
Issue 3
Tk=85°C
1.00E+04
500A
100% Duty Cycle
1.00E+03
1kA
2kA
1.00E+02 3kA
1.00E+01
1.00E+01
1.00E-05
1.00E-04
1.00E-03
Pulse Width (s)
1.00E-02
1.00E+00
1.00E-05
1.00E-04
1.00E-03
Pulse width (s)
1.00E-02
Figure 15 - Square wave frequency ratings
1.00E+05
1.00E+04
250A
500A
1kA
R0487YS10#-14#
Issue 3
di/dt=100A/µs
Tk=55°C
100% Duty Cycle
Figure 16 - Square wave frequency ratings
1.00E+05
R0487YS10#-14#
Issue 3
di/dt=500A/µs
Tk=55°C
1.00E+04 250A
500A
100% Duty Cycle
1.00E+03
2kA
3kA
1.00E+03 1kA
1.00E+02
1.00E+02
2kA
1.00E+01
1.00E+01
1.00E+00
1.00E-05
1.00E-04
1.00E-03
Pulse width (s)
1.00E-02
3kA
1.00E+00
1.00E-05
1.00E-04
1.00E-03
Pulse width (s)
1.00E-02
Data Sheet. Type R0487YS10# to R0487YS14# Issue 3
Page 10 of 12
October, 2004

10 Page





PáginasTotal 12 Páginas
PDF Descargar[ R0487YS14E.PDF ]

Enlace url


Hoja de datos destacado

Número de piezaDescripciónFabricantes
R0487YS14DDistributed Gate ThyristorIXYS
IXYS
R0487YS14EDistributed Gate ThyristorIXYS
IXYS
R0487YS14FDistributed Gate ThyristorIXYS
IXYS

Número de piezaDescripciónFabricantes
SSM2604

Low Power Audio Codec.

Analog Devices
Analog Devices
SLG3NB3331

32.768 kHz and MHz GreenCLK.

Silego
Silego
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices
SDC1741

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


Index : 0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z


www.DataSheet.es    |   2018   |  Contacto  |  Buscar