DataSheet.es    


PDF NL10276BC20-18D Data sheet ( Hoja de datos )

Número de pieza NL10276BC20-18D
Descripción LCD Module
Fabricantes NEC 
Logotipo NEC Logotipo



Hay una vista previa y un enlace de descarga de NL10276BC20-18D (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! NL10276BC20-18D Hoja de datos, Descripción, Manual

TFT COLOR LCD MODULE
NL10276BC20-18D
26cm (10.4 Type)
XGA
LVDS interface (1port)
DATA SHEET
DOD-PP-1014 (1st edition)
This DATA SHEET is updated document from
PRELIMINARY DATA SHEET DOD-PP-0997(1).
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.

1 page




NL10276BC20-18D pdf
2. GENERAL SPECIFICATIONS
Display area
210.432 (H) 157.824 (V) mm
Diagonal size of display 26cm (10.4 inches)
Drive system
a-Si TFT active matrix
Display color
16,777,216 colors (At 8-bit input, FRC terminal= High)
262,144 colors (At 6-bit input, FRC terminal= Low or Open)
Pixel
1,024 (H) 768 (V) pixels
Pixel arrangement
RGB (Red dot, Green dot, Blue dot) vertical stripe
Dot pitch
0.0685 (H) 0.2055 (V) mm
Pixel pitch
0.2055 (H) 0.2055 (V) mm
Module size
228.0 (W) 178.5 (H) 8.7 (D) mm (typ.)
Weight
380 g (typ.)
Contrast ratio
900: 1 (typ.)
Viewing angle
At the contrast ratio 10:1
Horizontal: Right side 80 (typ.), Left side 80 (typ.)
Vertical: Up side 80 (typ.), Down side 80 (typ.)
Designed viewing direction
At DPS= Low or Open: Normal scan
Viewing direction without image reversal: Up side (12 o'clock)
Viewing direction with contrast peak: Down side (6 o'clock)
Viewing angle with optimum grayscale ( 2.2): Normal axis
(perpendicular)
Polarizer surface
Antiglare
Polarizer pencil-hardness 3H (min.) [by JIS K5400]
Color gamut
Response time
Luminance
At LCD panel center
40 % (typ.) [against NTSC color space]
Ton+Toff (10%
18 ms (typ.)
90%)
At IL= 60mA/ one circuit
400 cd/m2 (typ.)
Signal system
Power supply voltage
Backlight
Power consumption
LVDS 1port
(Receiver: THC63LVDF84B, THine Electronics Inc. or equivalent)
8bit/6bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)
LCD panel signal processing board: 3.3V
LED backlight type:
Replaceable part
Lamp holder set: Type No. 104LHS55
Recommended LED driver board (Option)
LED driver board :Type No. 104PW02F
At IL= 60mA/ one circuit, Checkered flag pattern
4.8 W (typ.)

5 Page





NL10276BC20-18D arduino
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
0V
ON
3.0V
10 s Tr < 50ms
Display signals*,
Function signals
Note2
0V
0ms < t < 35ms
VALID period
OFF
ON
0.3V
Toff 50ms
0ms < t < 35ms
* These signals should be measured at the terminal of 100 resistance.
Note1: If there is a voltage variation (voltage drop) at the rising edge of VCC below 3.0V, there is a
possibility that a product does not work due to a protection circuit.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/-, CLK+/-) and function signals (DPS, FRC, MSL)
must be set to Low or High-impedance, except the VALID period (See above sequence
diagram), in order to avoid the circuitry damage.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. If a customer stops the
display and function signals, VCC also must be shut down.
4.4.2 LED Driver board (Option)
Display signals,
Function signals
Note1
Note2
VALID period
LED backlight: ON
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet NL10276BC20-18D.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
NL10276BC20-18Display ModuleNEC
NEC
NL10276BC20-18CTFT Color LCD ModuleNLT
NLT
NL10276BC20-18DLCD ModuleNEC
NEC
NL10276BC20-18FTFT Color LCD ModuleNLT
NLT

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar