DataSheet.es    


PDF TCG104VGLAAANN-AN00 Data sheet ( Hoja de datos )

Número de pieza TCG104VGLAAANN-AN00
Descripción Display Module
Fabricantes Kyocera 
Logotipo Kyocera Logotipo



Hay una vista previa y un enlace de descarga de TCG104VGLAAANN-AN00 (archivo pdf) en la parte inferior de esta página.


Total 22 Páginas

No Preview Available ! TCG104VGLAAANN-AN00 Hoja de datos, Descripción, Manual

SPEC
Spec No. TQ3C-8EAF0-E1YAG23-00
Date
June 7, 2012
TYPE : TCG104VGLAAANN-AN00
< 10.4 inch VGA transmissive color TFT with LED backlight>
CONTENTS
1. Application
2. Construction and outline
3. Mechanical specifications
4. Absolute maximum ratings
5. Electrical characteristics
6. Optical characteristics
7. Interface signals
8. Input timing characteristics
9. Backlight characteristics
10. Lot number identification
11. Warranty
12. Precautions for use
13. Reliability test data
14. Outline drawing
Original
Issue Date
KYOCERA CORPORATION
LCD DIVISION
This specification is subject to change without notice.
Consult Kyocera before ordering.
Designed by: Engineering dept.
Confirmed by: QA dept.
Prepared
Checked
Approved
Checked
Approved
June 7, 2012

1 page




TCG104VGLAAANN-AN00 pdf
Spec No.
Part No.
TQ3C-8EAF0-E1YAG23-00 TCG104VGLAAANN-AN00
4. Absolute maximum ratings
Page
2
4-1. Electrical absolute maximum ratings
Item
Supply voltage
Input signal voltage
LED forward current
1)
2) 3)
Symbol
VDD
VIN
IF
Min.
0
-0.3
-
Max.
4.0
6.0
100
Unit
V
V
mA
1) Input signal : CK, R0 R5, G0 G5, B0 B5, HSYNC, VSYNC, ENAB, R/L, U/D
2) For each “AN-CA”
3) Do not apply reversed voltage.
4-2. Environmental absolute maximum ratings
Item
Operating temperature
Storage temperature
Operating humidity
Storage humidity
Vibration
Shock
Symbol
1) TOP
2) TSTO
3) HOP
3) HSTO
-
-
Min.
-20
-30
10
10
5)
6)
Max.
70
80
4)
4)
5)
6)
Unit
°C
°C
%RH
%RH
-
-
1) Operating temperature means a temperature which operation shall be guaranteed. Since display
performance is evaluated at 25°C, another temperature range should be confirmed.
2) Temp. = -30°C 48h , Temp. = 80°C 168h
Store LCD at normal temperature/humidity. Keep them free from vibration and shock.
An LCD that is kept at a low or a high temperature for a long time can be defective due to
other conditions, even if the low or high temperature satisfies the standard.
(Please refer to “Precautions for Use” for details.)
3) Non-condensing
4) Temp. 40°C, 85%RH Max.
Temp. 40°C, Absolute humidity shall be less than 85%RH at 40°C.
5)
Frequency
Vibration width
10 55 Hz
0.15mm
Acceleration value
(0.3 9 m/s2)
Interval
10-55-10 Hz
minutes
2 hours in each direction X, Y, Z (6 hours total)
EIAJ ED-2531
6) Acceleration: 490 m/s2, Pulse width: 11 ms
3 times in each direction: ±X, ±Y, ±Z
EIAJ ED-2531
M407011

5 Page





TCG104VGLAAANN-AN00 arduino
Spec No.
Part No.
TQ3C-8EAF0-E1YAG23-00 TCG104VGLAAANN-AN00
8. Input timing characteristics
Page
8
8-1. Timing characteristics
Clock
Data
Item
Frequency
Duty ratio
Set up time
Hold time
Horizontal sync. Cycle
signal
Pulse width
Vertical sync.
signal
Cycle
Pulse width
Horizontal display period
Hsync,-Clock phase difference
Hsync-Vsync. phase difference
Vertical sync. signal start position
Vertical display period
Symbol
1/Tc
Tch/Tc
Tds
Tdh
TH
THp
TV
TVp
THd
THc
TVh
TVs
TVd
Min
22.66
40
5
10
30.0
770
2
515
2
10
2Tc
Typ
25.18
50
31.8
800
96
525
640
34
480
Max
27.69
60
850
200
560
34
Tc-10
TH-THp-1
Unit
MHz
%
ns
ns
s
clock
clock
line
line
clock
ns
ns
line
line
Note
1) In case of lower frequency, the deterioration of the display quality, flicker etc., may occur.
2) CK count of each Horizontal Scanning Time should be always the same. Vertical invalid data
period should be "n" "Horizontal Scanning Time". (n: integer)
Frame period should be always the same.
8-2. Horizontal display position
Item
Enable signal
Set up time
Pulse width
HSYNC – Enable signal phase difference
Symbol
Tes
Tep
The
Min
5
2
44
Typ
Max
Unit Note
Tc-10
ns
640
TH-10
clock
TH-664 clock
1) When ENAB is fixed at "Low", the display starts from the data of C104(clock) as shown in 8-5.
2) The horizontal display position is determined by ENAB signal.
8-3. Vertical display position
1) The vertical display position (TVs) is 34th line.
2) ENAB signal is independent of vertical display position.
M407011

11 Page







PáginasTotal 22 Páginas
PDF Descargar[ Datasheet TCG104VGLAAANN-AN00.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
TCG104VGLAAANN-AN00Display ModuleKyocera
Kyocera

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar