DataSheet.es    


PDF NL6448BC26-27D Data sheet ( Hoja de datos )

Número de pieza NL6448BC26-27D
Descripción LCD Module
Fabricantes NLT 
Logotipo NLT Logotipo



Hay una vista previa y un enlace de descarga de NL6448BC26-27D (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! NL6448BC26-27D Hoja de datos, Descripción, Manual

TFT COLOR LCD MODULE
NL6448BC26-27D
21cm (8.4 Type)
VGA
LVDS interface (1port)
DATA SHEET
DOD-PP-1409 (2nd edition)
This DATA SHEET is updated document from
DOD-PP-1401(1).
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-1409(2nd edition)
Published date: April 2012 CP (N)
1
© NLT Technologies, Ltd.
2012 All rights reserved.

1 page




NL6448BC26-27D pdf
NL6448BC26-27D
2. GENERAL SPECIFICATIONS
Display area
Diagonal size of display
Drive system
Display color
Pixel
Pixel arrangement
Dot pitch
Pixel pitch
Module size
Weight
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
Polarizer pencil-hardness
Color gamut
Response time
Luminance
Signal system
Power supply voltage
170.88 (H) × 128.16 (V) mm
21cm (8.4inches)
a-Si TFT active matrix
16,777,216 colors (At 8-bit input, FRC terminal= High)
262,144 colors (At 6-bit input, FRC terminal= Low or Open)
640 (H) × 480 (V) pixels
RGB(Red dot, Green dot, Blue dot) vertical stripe
0.089 (H) × 0.267 (V) mm
0.267 (H) × 0.267 (V) mm
200.0 (W) × 152.0 (H) × 8.2 (D) mm (typ.)
260 g (typ.)
1,000:1 (typ.)
At the contrast ratio 10:1
Horizontal: Right side 80° (typ.), Left side 80° (typ.)
Vertical: Up side 80° (typ.), Down side 80° (typ.)
At DPS= Low or Open: Normal scan
Viewing direction without image reversal: Up side (12 o'clock)
Viewing direction with contrast peak: Down side (6 o'clock)
Viewing angle with optimum grayscale (γ2.2): Normal axis
(perpendicular)
Antiglare
3H (min.) [by JIS K5600]
At LCD panel center
40% (typ.) [against NTSC color space]
Ton + Toff (10%←→ 90%)
18ms (typ.)
At IL= 50mA/One circuit
500 cd/m2 (typ.)
LVDS 1port
(Receiver: THC63LVDF84B, THine Electronics Inc. or equivalent)
[8bit/6bit digital signals for data of RGB colors,
Dot clock (CLK), Data enable (DE)]
LCD panel signal processing board: 3.3V
LED backlight type:
Backlight
Power consumption
Replaceable part
Lamp holder set: Type No. 84LHS16
Recommended LED driver board (Option)
LED driver board :Type No. 104PW03F
Corresponding wiring harness: Type No. 121CBL02
At IL= 50mA/One circuit, Checkered flag pattern
3.1 W (typ.)
DATA SHEET DOD-PP-1409 (2nd edition)
5

5 Page





NL6448BC26-27D arduino
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
0V
ON
3.0V
10μs Tr < 50ms
Display signals *
Function signals
Note2
0V
0ms < t < 35ms
VALID period
NL6448BC26-27D
OFF ON
0.3V
Toff 50ms
0ms < t < 35ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: If there is a voltage variation (voltage drop) at the rising edge of VCC below 3.0V, there is a
possibility that a product does not work due to a protection circuit.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/- and CLK+/-) and function signals (DPS, FRC,
and MSL) must be set to Low or High-impedance, except the VALID period (See above
sequence diagram), in order to avoid the circuitry damage.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. If a customer stops the
display and function signals, VCC also must be shut down.
4.4.2 LED driver board
Display signals
Function signals
Note1
Note2
VALID period
LED backlight: ON
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
DATA SHEET DOD-PP-1409 (2nd edition)
11

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet NL6448BC26-27D.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
NL6448BC26-27LCD ModuleNLT
NLT
NL6448BC26-27CLCD ModuleNLT
NLT
NL6448BC26-27DLCD ModuleNLT
NLT
NL6448BC26-27FLCD ModuleNLT
NLT

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar