|
|
Número de pieza | CLAA154WA04 | |
Descripción | TFT LCD | |
Fabricantes | CHUNGHWA PICTURE TUBES | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de CLAA154WA04 (archivo pdf) en la parte inferior de esta página. Total 24 Páginas | ||
No Preview Available ! CHUNGHWA PICTURES TUBES, LTD.,
Chunghwa Picture Tubes, Ltd.
Technical Specification
To :
Date : 2005/1/10
TFT LCD
CLAA154WA04
ACCEPTED BY :
APPROVED BY
CHECKED BY
PREPARED BY
CPT TFT-PPM
Neptune
1/10’05
Prepared by : TFT-LCD Product Planning Management Division
CHUNGHWA PICTUER TUBES, LTD.
1127 Hopin Rd., Padeh, Taoyuan, Taiwan 334, R.O.C.
Doc.No:
Issue Date: 2005/01/10
CPT Confidential
0/23 CLAA154WA04-Dell-Ver:2-2005/01/10
1 page CHUNGHWA PICTURES TUBES, LTD.,
2. ABSOLUTE MAXIMUM RATINGS
The following are maximum value, which if exceeded, may cause faulty operation or damage to the
unit.
ITEM
SYMBOL MIN. MAX. UNIT REMARK
Power Supply Voltage for LCD
VCC
0 4.0
V
Lamp voltage
VL 710 960 Vrms
*1)
Lamp current
West
IL
2 6.5 mArms
*2) *3)
Lamp frequency
FL 50 80 kHz
Operation Temperature
Top 0 50
*4)*5)*6)*7)
Storage Temperature
Tstg -25 65
*4)*5)*6)
Delayed Discharge Time
TD -- 1 sec
*8)
Note
*1) Min value is at IL 6.5mA and Max value is at IL 2.0mA.
*2) Product life-time relate to the lamp current, please operate following statement “(B)Back light
system” at page 8.
*3) When lamp current over the definition of absolute max. value , life-time of the product will
decay rapidly or operate unusual.
*4) The relative temperature and humidity range are as below sketch, 90%RH Max. (Ta 40 )
*5) The maximum wet bulb temperature 39 (Ta 40 ) and without dewing.
*6) If users use the product out off the environment operation range (temperature and humidity) ,
it will concern for visual quality.
*7) The product must work at operation temperature range and the surface temperature of the
panel’s center point must be lower then 60 .
*8) Delay discharge time(TD) test condition : starting lamp voltage=1650Vrms.(please follow
statement”(B)Back light system” at page 8.
Before TD test, lamp should be start at least 1 min at the typical value of lamp current and
then place the panel at room temp.( 25 2 ) exceed 24hrs. Measuring the TD value at the
same condition (starting lamp voltage) in dark room.
Relative Humidity (%RH)
90
(40,90)
Operating Range
80
60 Storage
(50,50.4)
40 (60,27.7)
20
5
-20
0 20 40 50 60
Temperature (°C)
CPT Confidential
5 Page CHUNGHWA PICTURES TUBES, LTD.,
(B) CN2 (Back light) *1)*2)
Backlight-side connector: BHSR-02VS-1 (JST)
Inverter-side connector: SM02B-BHSS-1 (JST)
Pin No.
1
2
Symbol
CTH
CTL
Function
VBLH (High voltage)
VBLL (Low voltage)
CPT Confidential
11 Page |
Páginas | Total 24 Páginas | |
PDF Descargar | [ Datasheet CLAA154WA04.PDF ] |
Número de pieza | Descripción | Fabricantes |
CLAA154WA01AQ | Display Module | CHUNGHWA PICTURE TUBES |
CLAA154WA01D | Display Module | CHUNGHWA PICTURE TUBES |
CLAA154WA01Q | Display Module | CHUNGHWA PICTURE TUBES |
CLAA154WA01Y | Display Module | CHUNGHWA PICTURE TUBES |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |