DataSheet.es    


PDF BH7645KS2 Data sheet ( Hoja de datos )

Número de pieza BH7645KS2
Descripción Silicon Monolithic Integrated Circuit
Fabricantes ROHM Semiconductor 
Logotipo ROHM Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de BH7645KS2 (archivo pdf) en la parte inferior de esta página.


Total 5 Páginas

No Preview Available ! BH7645KS2 Hoja de datos, Descripción, Manual

1/4
Structure
: Silicon Monolithic Integrated Circuit
Product name : Wide Bandwidth Audio-Video SW for TV
Type : BH7645KS2
Outer dimensions :
Fig.1 SQFP-T52
Block diagram : Fig.2
Features
: 1) Video inputs selector : 2-inputs component, 2-inputs Y/C, and 2-inputs composite
2) Component inputs : Correspond to D5 standard
3) Built-in LPF selector(6.75MHz/13.5MHz/30MHz/Through)
4) Built-in Video MUTE function
5) Audio inputs selector : 6-inputs (Lch, Rch)
6) Built-in Power-on MUTE function
7) I2C-BUS control
8) Optional Slave address modifications(90H/92H)
9) I2C-BUS is compatible with fast mode of Version2.0, but not compatible with Hs mode
10) Built-in detector 3ch(S_SW1/S_SW2/S_SW3)
11) Built-in output port 2ch(PORT1_OUT/PORT2_OUT)
Absolute Maximum Ratings (Ta=+25℃)
Parameter
Symbol
Ratings
Supply voltage1 (2pin, 29pin, 33pin, 39pin, 44pin)
Vcc1
7
Supply voltage2 (12pin)
Vcc2
8.8
Power dissipation
Pd 1300 *1
Input voltage range
VIDEO PART, LOGIC PART
AUDIO PART
Storage temperature range
VIN1
VIN2
Tstg
0 ~ Vcc1+0.2
0 ~ Vcc2+0.2
-55 ~ +125
*1 When mounting on a 70mm×70mm×1.6mm PCB board
Reduced by 13mW/℃ at Ta = +25℃ or higher
Operating Range
Parameter
Symbol
Range
Supply voltage1 (2pin, 29pin, 33pin, 39pin, 44pin)
Vcc1
+4.5 ~ +5.5
Supply voltage2 (12pin)
Vcc2
+7.5 ~ +8.5
Operating temperature range
Topr -40 ~ +85
* This product is not designed for protection against radioactive rays.
* Note the power supply sequence.
Unit
V
V
mW
V
V
Unit
V
V
REV. A

1 page




BH7645KS2 pdf
Notice
Notes
No copying or reproduction of this document, in part or in whole, is permitted without the
consent of ROHM Co.,Ltd.
The content specified herein is subject to change for improvement without notice.
The content specified herein is for the purpose of introducing ROHM's products (hereinafter
"Products"). If you wish to use any such Product, please be sure to refer to the specifications,
which can be obtained from ROHM upon request.
Examples of application circuits, circuit constants and any other information contained herein
illustrate the standard usage and operations of the Products. The peripheral conditions must
be taken into account when designing circuits for mass production.
Great care was taken in ensuring the accuracy of the information specified in this document.
However, should you incur any damage arising from any inaccuracy or misprint of such
information, ROHM shall bear no responsibility for such damage.
The technical information specified herein is intended only to show the typical functions of and
examples of application circuits for the Products. ROHM does not grant you, explicitly or
implicitly, any license to use or exercise intellectual property or other rights held by ROHM and
other parties. ROHM shall bear no responsibility whatsoever for any dispute arising from the
use of such technical information.
The Products specified in this document are intended to be used with general-use electronic
equipment or devices (such as audio visual equipment, office-automation equipment, commu-
nication devices, electronic appliances and amusement devices).
The Products specified in this document are not designed to be radiation tolerant.
While ROHM always makes efforts to enhance the quality and reliability of its Products, a
Product may fail or malfunction for a variety of reasons.
Please be sure to implement in your equipment using the Products safety measures to guard
against the possibility of physical injury, fire or any other damage caused in the event of the
failure of any Product, such as derating, redundancy, fire control and fail-safe designs. ROHM
shall bear no responsibility whatsoever for your use of any Product outside of the prescribed
scope or not in accordance with the instruction manual.
The Products are not designed or manufactured to be used with any equipment, device or
system which requires an extremely high level of reliability the failure or malfunction of which
may result in a direct threat to human life or create a risk of human injury (such as a medical
instrument, transportation equipment, aerospace machinery, nuclear-reactor controller, fuel-
controller or other safety device). ROHM shall bear no responsibility in any way for use of any
of the Products for the above special purposes. If a Product is intended to be used for any
such special purpose, please contact a ROHM sales representative before purchasing.
If you intend to export or ship overseas any Product or technology specified herein that may
be controlled under the Foreign Exchange and the Foreign Trade Law, you will be required to
obtain a license or permit under the Law.
Thank you for your accessing to ROHM product informations.
More detail product informations and catalogs are available, please contact us.
ROHM Customer Support System
http://www.rohm.com/contact/
www.rohm.com
© 2010 ROHM Co., Ltd. All rights reserved.
R1010A

5 Page










PáginasTotal 5 Páginas
PDF Descargar[ Datasheet BH7645KS2.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
BH7645KS2Silicon Monolithic Integrated CircuitROHM Semiconductor
ROHM Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar