DataSheet.es    


PDF S6E2G38 Data sheet ( Hoja de datos )

Número de pieza S6E2G38
Descripción Microcontroller
Fabricantes Cypress Semiconductor 
Logotipo Cypress Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de S6E2G38 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! S6E2G38 Hoja de datos, Descripción, Manual

S6E2G Series
32-bit ARM® Cortex®-M4F
FM4 Microcontroller
S6E2G Series are FM4 devices with up to 180 MHz CPU, 1MB flash, 192KB SRAM, 20x communication peripherals, 33x digital
peripherals and 3x analog peripherals. They are designed for industrial automation and metering applications.
Devices in the S6E2G Series are highly integrated 32-bit microcontrollers with high performance and competitive cost. This series is
based on the ARM Cortex-M4F processor with on-chip flash memory and SRAM. The series has peripherals such as motor control
timers, A/D converters, and communications interfaces (USB, CAN, UART, CSIO (SPI), I2C, LIN). The products that are described
in this data sheet are placed into TYPE5-M4 product categories in the "FM4 Family Peripheral Manual Main Part (002-04856).
32-bit ARM Cortex-M4F Core
Up to 180 MHz frequency operation
On-chip Memories
Flash memory: Up to 1024 Kbytes
SRAM memory:
SRAM0: up to 128 Kbytes
SRAM1: 32 Kbytes
SRAM2: 32 Kbytes
Direct Memory Access (DMA) Controller (Eight Channels)
Descriptor System Data Transfer Controller (DSTC);
256 channels
External Bus Interface
USB Interface (Max two channels): Host and Device
CAN Interface (Max one channel) Available on S6E2GM
and S6E2GH Devices Only
Multi-function Serial Interface (Max 10 Channels)
UART (Universal Asynchronous Receiver/Transmitter)
Clock Synchronous Serial Interface (CSIO (SPI))
Local Interconnect Network (LIN)
Inter-Integrated Circuit (I2C)
Inter-IC Sound (I2S)
Base Timer (Max 16 channels)
General Purpose I/O Port
Up to 121 high-speed general-purpose I/O ports in
144-pin package
Up to 153 high-speed general-purpose I/O ports in
176-pin package
Multi-function Timer (Max two units)
Real-Time Clock (RTC)
Analog to Digital Converter (ADC) (Max 32 Channels)
Dual Timer (32-/16-bit Down Counter)
Quadrature Position/Revolution Counter (QPRC; Max four
channels)
Watch Counter
External Interrupt Controller Unit
Watchdog Timer (Two channels)
Cyclic Redundancy Check (CRC) Accelerator
SD Card Interface Available on S6E2GM, S6E2GH, and
S6E2GK Devices Only
Ethernet-MAC Available on S6E2GM, S6E2GK, and
S6E2G2 Devices only
Smartcard Interface (Max 2 channels)
Five Clock Sources
Six Reset Sources
Clock Supervisor (CSV)
Low-Voltage Detector (LVD)
Six Low-power Consumption Modes
Sleep
Timer
RTC
Stop
Deep standby RTC
Deep standby stop
Peripheral Clock Gating System
Crypto Assist Function
Debug
Serial wire JTAG debug port (SWJ-DP)
Embedded trace macrocells (ETM) provide
comprehensive debug and trace facilities.
AHB trace macrocells (HTM)
41-bit Unique ID
Wide range voltage: VCC = 2.7 to 5.5 V
Cypress Semiconductor Corporation
Document Number: 001-98708 Rev *B
• 198 Champion Court • San Jose, CA 95134-1709
Revised March 29, 2016
• 408-943-2600

1 page




S6E2G38 pdf
S6E2G Series
2. Product Lineup
Memory Size
Memory Type
On-chip flash
memory
SRAM
SRAM0
On-chip
SRAM1
SRAM2
Product Name
S6E2GM6
S6E2GK6
S6E2GH6
S6E2G36
S6E2G26
S6E2GM8
S6E2GK8
S6E2GH8
S6E2G38
S6E2G28
512 Kbytes
1024 Kbytes
128 Kbytes
64 Kbytes
32 Kbytes
32 Kbytes
192 Kbytes
128 Kbytes
32 Kbytes
32 Kbytes
Function Availability by Part
Description
S6E2GM6
S6E2GM8
S6E2GK6
S6E2GK8
Product Name
S6E2GH6
S6E2GH8
S6E2G36
S6E2G38
CPU
Freq.
Cortex-M4F, MPU, NVIC 128 ch
180 MHz
Power supply
voltage range
2.7 V to 5.5 V
USB2.0
(Device/Host)
2 ch
Ethernet-MAC
1 ch. (Max)
MII: 1 ch /
RMII: 1 ch (Max)
N/A
CAN
1 ch (Max) N/A 1 ch (Max)
SD card interface
1 unit
DMAC
8 ch
DSTC
256 ch
S6E2G26
S6E2G28
1ch. (Max)
MII: 1 ch /
RMII: 1 ch (Max)
N/A
N/A
External bus
interface
Addr: 25-bit (Max),
Data: 8-/16-bit
CS: 9 (Max),
SRAM,
NOR flash
NAND flash
SDRAM
Multi-function serial
interface
(UART/CSIO(SPI)/
LIN/I2C/I2S)
10ch (Max)
ch 1, ch 4 to ch 7: FIFO,
ch 0, ch 2, ch3, ch 8 to ch 15: No FIFO
ch 1: I2S
Document Number: 001-98708 Rev *B
Page 5 of 190

5 Page





S6E2G38 arduino
S6E2G Series
Resets
Reset requests from INITX pin
Power on reset
Software reset
Watchdog timer reset
Low-voltage detector reset
Clock supervisor reset
Clock Supervisor (CSV)
Clocks generated by internal CR oscillators are used to
supervise abnormality of the external clocks.
External OSC clock failure (clock stop) is detected, reset is
asserted.
External OSC frequency anomaly is detected, interrupt or
reset is asserted.
Low-Voltage Detector (LVD)
This Series include two-stage monitoring of voltage on the
VCC pins. When the voltage falls below the voltage that has
been set, the low-voltage detector function generates an
interrupt or reset.
LVD1: error reporting via interrupt
LVD2: auto-reset operation
Low-power Consumption Mode
Six low power consumption modes are supported.
Sleep
Timer
RTC
Stop
Deep standby RTC (selectable from with/without RAM
retention)
Deep standby stop (selectable from with/without RAM
retention)
Peripheral Clock Gating
The system can reduce the current consumption of the total
system with gating the operation clocks of peripheral
functions not used.
Crypto Assist Function
These features are enabled for the crypto assist function.
The dedicated middleware is necessary for this calculator
operation.
PKA (Public Key Accelerator)
PKAPublic Key Acceleratoris modular exponentiation
calculation accelerator used of RSA Public Key crypto and
so on.
Available bit length: Up to 2048-bit
AES calculator
AES (Advanced Encryption Standard) calculator is a AES
common key crypto accelerator which is compliant with
FIPS (Federal Information Processing Standard
Publication)197.
Available key length: 128/192/256-bit
CBC mode and ECB mode support
External Bus Data Scramble
It enables to scramble input/output data of External Bus
Interface.
Debug
Serial wire JTAG debug port (SWJ-DP)
Embedded trace macrocells (ETM) provide comprehensive
debug and trace facilities.
AHB trace macrocells (HTM)
Unique ID
Unique value of the device (41-bit) is set.
Power Supply
Five power supplies
Wide range voltage: VCC = 2.7 V to 5.5 V
Power supply for USB ch 0 I/O: USBVCC0
= 3.0 V to 3.6 V (when USB is used)
= 2.7 V to 5.5 V (when GPIO is used)
Power supply for USB ch 1 I/O: USBVCC1
= 3.0 V to 3.6 V (when USB is used)
= 2.7 V to 5.5 V (when GPIO is used)
Power supply for Ethernet-MAC I/O: ETHVCC
= 3.0 V to 5.5 V (when Ethernet is used.)
Document Number: 001-98708 Rev *B
Page 11 of 190

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet S6E2G38.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
S6E2G36MicrocontrollerCypress Semiconductor
Cypress Semiconductor
S6E2G38MicrocontrollerCypress Semiconductor
Cypress Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar