DataSheet.es    


PDF LC87F2K08A Data sheet ( Hoja de datos )

Número de pieza LC87F2K08A
Descripción 8-bit Microcontroller
Fabricantes ON Semiconductor 
Logotipo ON Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de LC87F2K08A (archivo pdf) en la parte inferior de esta página.


Total 24 Páginas

No Preview Available ! LC87F2K08A Hoja de datos, Descripción, Manual

Ordering number : EN*A2275
LC87F2K08A
Advance Information
CMOS LSI
8-bit Microcontroller
8K-Byte Flash ROM / 256-Byte RAM / 24-pin
http://onsemi.com
Overview
The LC87F2K08A is an 8-bit microcomputer that, centered around a CPU running at a minimum bus cycle time of
83.3ns, integrates on a single chip a number of hardware features such as 8K-byte flash ROM (onboard
programmable), 256-byte RAM, an on-chip debugger function, two sophisticated 16-bit timers/counters (may be
divided into 8-bit timers), an asynchronous/synchronous SIO interface, a 5-channel AD converter with 12/8-bit
resolution selector, eight analog comparators, two AMP circuits, an IGBT control circuit (PPG), a watchdog timer, an
internal reset circuit, a system clock frequency divider, and a 18-source 10-vector interrupt feature.
It is optimal for controlling the IH cooking heaters and other appliances.
Features
Flash ROM
8192 8 bits
Capable of on-board programming with a power voltage range of 4.5 to 5.5V
Block-erasable in 128 byte units
Writing in 2-byte units
ROM
256 9 bits
Package : DIP24S(300mil), Lead-free type
Minimum bus cycle time
83.3ns (12MHz)
Note : The bus cycle time here refers to the ROM read speed.
Minimum instruction cycle time
250ns (12MHz)
* This product is licensed from Silicon Storage Technology, Inc. (USA).
This document contains information on a new product. Specifications and information
herein are subject to change without notice.
ORDERING INFORMATION
See detailed ordering and shipping information on page 24 of this data sheet.
Semiconductor Components Industries, LLC, 2014
July, 2014 Ver. 1.03
DIP24S(300mil)
71514HK No.A2275-1/24

1 page




LC87F2K08A pdf
LC87F2K08A
Standby function
HALT mode: Halts instruction execution while allowing the peripheral circuits to continue operation.
1) Oscillation is not halted automatically.
2) There are three ways of releasing the HALT mode.
(1) Setting the reset pin to the low level
(2) System resetting by watchdog timer or low-voltage detection
(3) Occurrence of an interrupt
HOLD mode: Suspends instruction execution and the operation of the peripheral circuits.
1) The CF, RC, and crystal oscillators automatically stop operation.
2) There are four ways of releasing the HOLD mode.
(1) Setting the reset pin to the lower level.
(2) System resetting by watchdog timer or low-voltage detection
(3) Having an interrupt source established at either INT0, INT1, INT2, or INT4
* INT0 and INT1 HOLD mode release is available only when level detection is set.
On-chip debugger
Supports software debugging with the IC mounted on the target board.
Data security function
Protects the program data stored in flash memory from unauthorized read or copy.
Note: This data security function does not necessarily provide absolute data security.
Development tools
On-chip debugger: TCB87 Type C + LC87F2K08A
Programming board
Package
DIP24S
Programming board
W87F2KD
Flash ROM programmer
Maker
Single/Gang
ON Programmer
Semiconductor
Gang
Programmer
Model
SKK/SKK Type B
(SanyoFWS)
SKK-4G
(SanyoFWS)
Note : Be sure to check for the latest version.
Supported version
Application version:
1.05 or later
Chip data version:
2.24 or later
Device
LC87F2K08
No.A2275-5/24

5 Page





LC87F2K08A arduino
LC87F2K08A
Recommended Unused Pin Connections
Pin Name
P00 to P07
P30
Recommended Unused Pin Connections
Board
Software
Open
Output low
Open
Output low
On-chip Debugger pin connection requirements
The on-chip debugger pin (OWPO) must be pulled down (with 100 K) on the user's board.
It is also recommended that a connector be installed to cable with the debugger tool (TCB87 Type C).
The connector must have three connections, i.e., GND, OWPO, and VDD.
Note : Be sure to electrically short-circuit between the VSS1 and VSS2 pins.
No.A2275-11/24

11 Page







PáginasTotal 24 Páginas
PDF Descargar[ Datasheet LC87F2K08A.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
LC87F2K08A8-bit MicrocontrollerON Semiconductor
ON Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar