DataSheet.es    


PDF THNCF048MAA Data sheet ( Hoja de datos )

Número de pieza THNCF048MAA
Descripción Small Form Factor Card
Fabricantes Toshiba 
Logotipo Toshiba Logotipo



Hay una vista previa y un enlace de descarga de THNCF048MAA (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! THNCF048MAA Hoja de datos, Descripción, Manual

Preliminary version
THNCFxxxMAA Series
**THNCFxxxMAA Series
CompactFlash™ Card
OUTLINE
The THNCF***MAA series CompactFlashcard is a flash technology based with ATA interface flash memory card. It is
constructed with flash disk controller chip and NAND-type Toshibaflash memory device. The CompactFlashcard
operates in both 5-Volt and 3.3-Volt power supplies. It comes in capacity of 8, 16, 32, 48, 64, 96, 128, 160, 192, 256, 320,
384 and up to 512 MB unformatted for type-I card. Emulating IDE hard disk drives and being certified in accordance with the
CompactFlashCertification Plan it is a perfect choice of solid-state mass-storage cards for battery backup handheld
devices such as Digital Camera, Audio Player, PDA, or the applications which require high environment tolerance with high
performance sustained write speed.
FEATURES
CompactFlashCompatibility
Certified in accordance with the CompactFlashCertification Plan
Substantially compatible with PC Card standard and PC Card ATA
Support for CIS implemented with 256 bytes of attribute memory
ATA/IDE interface
ATA command set compatible
Support for 8- or 16-bit host transfers
Programmable and auto-wait-state generation for compatibility with any host speed using IORDY
High performance
Fast ATA host-to-buffer burst transfer rates up to 20 Mbytes/second
Supports PIO mode 4, both at 16.6 Mbytes/second
Buffer transfer rates to and from flash memory up to 12.5 Mbytes/second
Sustained write : up to 1.5 Mbytes/second (8MB~48MB), 3.2 Mbytes/second(64MB~512MB)
Sustained read : up to 5.6Mbytes/second
Card capacity of 8, 16, 32, 48, 64, 96, 128, 160, 192, 256, 320, 384 and up to 512 MB Mbytes available
Single +5 Volt or 3.3 Volt power supply and very low power consumption with automatic power management.
NOTES
CompactFlashis a trademark of SanDisk Corporation and is licensed royalty-free to the CFA, which in turn will license it
royal-free to CFA members.
CFA: CompactFlashAssociation.
TOSHIBA is continually working to improve the quality and the reliability of its products. Nevertheless, semiconductor
devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It
is the responsibility of the buyer, when utilizing TOSHIBA products, to observe standards of safety, and to avoid
situations in which a malfunction or failure of a TOSHIBA product could cause loss of human life, bodily injury or damage
to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating
ranges as set forth in the most recent products specifications. Also, please keep in mind the precautions and conditions
set forth in the TOSHIBA Semiconductor Reliability Handbook.
Please do not use this device in the following applications
- special applications such as military related equipment, nuclear reactor control, and aerospace.
- control devices for automotive vehicles, train, ship and traffic equipment
- safety system for disaster prevention and crime prevention
- medical related equipment including medical measurement devices.
TOSHIBA do not guarantee any liability for loss or damage caused by the use in these applications.
The products described in this document are subject to foreign exchange and foreign trade laws.
The information contained herein is presented only as a guide for the applications of our products. No responsibility is
assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other rights of the third parties
which may result from its use. No license is granted by implication or otherwise under any intellectual property or other
rights of TOSHIBA CORPORATION or others.
The information contained herein is subject to change without notice.
2001-09-05 1/52

1 page




THNCF048MAA pdf
Physical Specifications
1.60mm .05
( .063 in .002)
3.30mm .10
( .130 in .004 )
26
1
1.01mm 0.7
( .039 in .003)
Preliminary version
THNCFxxxMAA Series
50
25
1.01mm 0.7
( .039 in .003)
.99mm .05
(.039 in. . 002)
2.44mm .07
(.096 in. . 003)
TOP
2.15mm .07
(.085 in. . 003)
2X 3.00mm .07
(2X .118 in. . 003)
0.76mm .07
(0.30 in. . 003)
4XR 0.5mm .1
(4XR.020 in. . 004)
41.66mm .13(1.640 in. . 005)
42.80mm .10)
(1.685 in. . 004)
0.63mm .07
(.025 in. . 003)
Note: The optional notched configuration was shown in the CF Specification Rev.1.0. In
Specification Rev. 1.2. the notch was removed for ease of tooling. This optional
configuration can be used but it is not recommended.
Type I CompactFlash Storage Card and CF+ Card Dimensions
2001-09-05 5/52

5 Page





THNCF048MAA arduino
Preliminary version
THNCFxxxMAA Series
Signal Name
-OE
(PC Card Memory Mode)
-OE
(PC Card I/O Mode)
-ATA SEL
(True IDE Mode)
RDY/-BSY
(PC Card Memory Mode)
-IREQ
(PC Card I/O Mode)
INTRQ
(True IDE Mode)
-REG
(PC Card Memory Mode)
Attribute Memory Select
-REG
(PC Card I/O Mode)
-REG
(True IDE Mode)
RESET
(PC Card Memory Mode)
RESET
(PC Card I/O Mode)
-RESET
(True IDE Mode)
VCC
(PC Card Memory Mode)
VCC
(PC Card I/O Mode)
VCC
(True IDE Mode)
Dir. Pin
Description
I 9 This is an Output Enable strobe generated by the host interface. It is
used to read data from the CompactFlash Strage Card or CF+Card in
Memory Mode and to read the CIS and configuration registers.
In PC Card I/O Mode, this signal is used to read the CIS and configuration
registers.
To enable True IDE Mode this Input should be grounded by the host.
O 37 In Memory Mode this signal is set high when the CompactFlash Storage
Card or CF+Card is ready to accept a new data transfer operation and
held low when the card is busy. The Host memory card socket must
provide a pull-up resistor.
At power up and at Reset, the RDY/-BSY signal is held low(busy) until the
CompactFlash Storage Card or CF+Card has completed its power up or
reset function. No access of any type should be made to the
CompactFlash Storage Card or CF+Card during this time. The
RDY/-BSY signal is held high(disabled from being busy) whenever the
following condition is true: The CompactFlash Storage Card or CF+Card
has been powered up with +RESET continuously disconnected or
asserted.
I/O Operation –After the CompactFlash Storage Card or CF+Card has
been configured for I/O operation, this signal is used as
–Interrupt Request. This line is strobed low to generate a pulse mode
interrupt or held low for a level mode interrupt.
In True IDE Mode signal is the active high Interrupt Request to the host.
I 44 This signal is used during Memory Cycles to distinguish between Common
Memory and Register (Attribute) Memory accesses.
High for Common Memory, Low for Attribute Memory.
The signal must also be active (low) during I/O Cycles when the I/O
address is on the Bus.
In True IDE Mode this input signal is not used and should be connected to
VCC by the host.
I 41 When the pin is high, this signal Resets the CompactFlash Storage Card
or CF+Card. The CompactFlash Storage Card or CF+Card is Reset only
at power up if this pin is left high or open from power-up. The
CompactFlash Storage Card or CF+Card is also Reset when the Soft
Reset bit in the Card Configuration Option Register is set.
This signal is the same as the PC Card Memory Mode signal.
In the True IDE Mode this input pin is the active low hardware reset from
the host.
- 13,38 +5V, +3.3V power
This signal is the same for all modes.
This signal is the same for all modes.
2001-09-05 11/52

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet THNCF048MAA.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
THNCF048MAASmall Form Factor CardToshiba
Toshiba

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar