|
|
PDF XRA1202P Data sheet ( Hoja de datos )
| Número de pieza | XRA1202P | |
| Descripción | 8-BIT I2C/SMBUS GPIO EXPANDER | |
| Fabricantes | Exar | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de XRA1202P (archivo pdf) en la parte inferior de esta página. Total 16 Páginas | ||
|
No Preview Available !
XRA1202/1202P
8-BIT I2C/SMBUS GPIO EXPANDER WITH RESET
APRIL 2013
REV. 1.0.1
GENERAL DESCRIPTION
The XRA1202/1202P is an 8-bit GPIO expander with
an I2C/SMBus interface. After power-up, the
XRA1202 has internal 100K ohm pull-up resistors on
each I/O pin that can be individually enabled. The
XRA1202P has the internal pull-up resistors enabled
upon power-up in case it is necessary for the inputs
to be in a known state.
In addition, the GPIOs on the XRA1202/1202P can
individually be controlled and configured. As outputs,
the GPIOs can be outputs that are high, low or in
three-state mode. The three-state mode feature is
useful for applications where the power is removed
from the remote devices, but they may still be
connected to the GPIO expander.
As inputs, the internal pull-up resistors can be
enabled or disabled and the input polarity can be
inverted. The interrupt can be programmed for
different behaviors. The interrupts can be
programmed to generate an interrupt on the rising
edge, falling edge or on both edges. The interrupt
can be cleared if the input changes back to its original
state or by reading the current state of the inputs.
The XRA1202/1202P are enhanced versions of the
PCA9538. The XRA1202 is pin and software
compatible with the PCA9538 (note: software
registers are compatible to the PCA9538, but the I2C
slave address is different).
The XRA1202 is available in 16-pin QFN and 16-pin
TSSOP packages. The XRA1202P is available in the
16-pin QFN package.
FEATURES
• 1.65V to 3.6V operating voltage
• 8 General Purpose I/Os (GPIOs)
• 5V tolerant inputs
• Maximum stand-by current of 1uA at +1.8V
• I2C/SMBus bus interface
s I2C clock frequency up to 400kHz
s Noise filter on SDA and SCL inputs
s Up to 16 I2C Slave Addresses
• Individually programmable inputs
s Internal pull-up resistors
s Polarity inversion
s Individual interrupt enable
s Rising edge and/or Falling edge interrupt
s Input filter
• Individually programmable outputs
s Output Level Control
s Output Three-State Control
• Open-drain active low interrupt output
• Active-low reset input
• Pin and software compatible with PCA9538
• 3kV HBM ESD protection per JESD22-A114F
• 200mA latch-up performance per JESD78B
APPLICATIONS
• Personal Digital Assistants (PDA)
• Cellular Phones/Data Devices
• Battery-Operated Devices
• Global Positioning System (GPS)
• Bluetooth
Exar Corporation 48720 Kato Road, Fremont CA, 94538 • (510) 668-7000 • FAX (510) 668-7017 • www.exar.com
1 page  
REV. 1.0.1
1.1.1 I2C-bus Addressing
XRA1202/1202P
8-BIT I2C/SMBUS GPIO EXPANDER WITH RESET
There could be many devices on the I2C-bus. To distinguish itself from the other devices on the I2C-bus, the
XRA1202/1202P has up to 16 I2C slave addresses using the A1-A0 address lines. Table 1 below shows the
different addresses that can be selected.
TABLE 1: I2C ADDRESS MAP
A1
SCL
SCL
SDA
SDA
SCL
SCL
SDA
SDA
GND
GND
VCC
VCC
GND
GND
VCC
VCC
A0
GND
VCC
GND
VCC
SCL
SDA
SCL
SDA
GND
VCC
GND
VCC
SCL
SDA
SCL
SDA
I2C ADDRESS
0x20 (0010 000X)
0x22 (0010 001X)
0x24 (0010 010X)
0x26 (0010 011X)
0x30 (0011 000X)
0x32 (0011 001X)
0x34 (0011 010X)
0x36 (0011 011X)
0x40 (0100 000X)
0x42 (0100 001X)
0x44 (0100 010X)
0x46 (0100 011X)
0x50 (0101 000X)
0x52 (0101 001X)
0x54 (0101 010X)
0x56 (0101 011X)
5
5 Page 
REV. 1.0.1
XRA1202/1202P
8-BIT I2C/SMBUS GPIO EXPANDER WITH RESET
ELECTRICAL CHARACTERISTICS
DC ELECTRICAL CHARACTERISTICS
UNLESS OTHERWISE NOTED: TA = -40O TO +85OC, VCC IS 1.65V TO 3.6V
SYMBOL
PARAMETER
VIL Input Low Voltage
VIL Input Low Voltage
VIH Input High Voltage
VIH Input High Voltage
VOL Output Low Voltage
VOL Output Low Voltage
VOL Output Low Voltage
VOH Output High Voltage
IIL
IIH
ICC
ICC
ICCS
CIN
RGPIO
Input Low Leakage Current
Input High Leakage Current
Power Supply Current
Power Supply Current
Standby Current
Input Pin Capacitance
GPIO pull-up resistance
RRESET# Reset# pull-up resistance
LIMITS
1.8V ± 10%
MIN MAX
-0.3 0.3VCC
-0.3 0.2
1.3 VCC
1.4 5.5
0.4
0.5
0.4
1.2
±10
±10
50
150
1
5
60 140
35 85
LIMITS
2.5V ± 10%
MIN MAX
-0.3 0.3VCC
-0.3 0.5
1.8 VCC
1.8 5.5
0.4
0.5
0.4
1.8
±10
±10
100
250
2
5
60 140
35 85
LIMITS
3.3V ± 10%
MIN MAX
UNITS
CONDITIONS
-0.3 0.3VCC V Note 1
-0.3 0.8
V Note 2
2.3 VCC V Note 1
2.0 5.5 V Note 2
0.4 V IOL = 3 mA
V IOL = 3 mA
V IOL = 3 mA
Note 3
0.5 V IOL = 8 mA
Note 4
0.4 V IOL = 6 mA
V IOL = 4 mA
V IOL = 1.5 mA
Note 5
2.6 V IOH = -8 mA
V IOH = -8 mA
V IOH = -8 mA
Note 4
±10 uA
±10 uA
200 uA Test 1
500 uA Test 2
5 uA Test 3
5 pF
60 140 kΩ 100kΩ ± 40%
35 85 kΩ 60kΩ ± 40%
NOTES:
1. For I2C input signals (SDA, SCL);
2. For GPIOs, A0, A1 and A2 signals;
3. For I2C output signal SDA;
4. For GPIOs;
5. For IRQ# signal;
11
11 Page | ||
| Páginas | Total 16 Páginas | |
| PDF Descargar | [ Datasheet XRA1202P.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| XRA1202 | 8-BIT I2C/SMBUS GPIO EXPANDER | Exar |
| XRA1202P | 8-BIT I2C/SMBUS GPIO EXPANDER | Exar |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |