DataSheet.es    


PDF S6E1B36G0A Data sheet ( Hoja de datos )

Número de pieza S6E1B36G0A
Descripción Microcontroller
Fabricantes Cypress Semiconductor 
Logotipo Cypress Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de S6E1B36G0A (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! S6E1B36G0A Hoja de datos, Descripción, Manual

PRELIMINARY
S6E1B3 Series
32-bit ARM® Cortex®-M0+
FM0+ Microcontroller
The S6E1B3 Series is a series of highly integrated 32-bit microcontrollers designed for embedded controllers aiming at low power
consumption and low cost. This series has the ARM Cortex-M0+ Processor with on-chip Flash memory and SRAM, and consists of
peripheral functions such as various timers, ADC and communication interfaces (UART, CSIO (SPI), I2C, I2S, Smart Card, and USB).
The products which are described in this data sheet are placed into TYPE2-M0+ product categories in "FM0+ Family Peripheral
Manual".
Features
32-bit ARM Cortex-M0+ Core
Processor version: r0p1
Maximum operating frequency: 40.8 MHz
Nested Vectored Interrupt Controller (NVIC): 1 NMI
(non-maskable interrupt) and 24 peripheral interrupt with 4
selectable interrupt priority levels
24-bit System timer (Sys Tick): System timer for OS task
management
Bit Band Operation
Compatible with Cortex-M3 bit band operation.
On-Chip Memory
Flash memory
Up to 512 K+48 Kbytes
Dual bank
upper bank : 512 Kbytes(64 Kbytes x 8)
lower bank : 48 Kbytes(8K bytes x 6)
Read cycle: 0 wait-cycle
Security function for code protection
SRAM
The on-chip SRAM of this series has one independent SRAM .
Up to SRAM: 60 K+4 Kbytes
4Kbytes: can retain value in Deep standby Mode
USB Interface
USB interface is composed of Device and Host
PLL for USB is built-in, USB clock can be generated by
multiplication of Main clock.
USB Device
USB 2.0 Full-Speed supported
Max 6 EndPoint supported
EndPoint 0 is control transfer
EndPoint 1, 2 can be selected Bulk-transfer,
Interrupt-transfer or Isochronous-transfer
EndPoint 3 to 5 can select Bulk-transfer or
Interrupt-transfer
EndPoint 1 to 5 comprise Double Buffer
The size of each EndPoint is according to the follows
EndPoint 0, 2 to 5 : 64 bytes
EndPoint 1 : 256 bytes
USB host
USB 2.0 Full/Low-Speed supported
Bulk-transfer, Interrupt-transfer and Isochronous-transfer
support
USB Device connected/disconnected automatically detect
IN/OUT token handshake packet automatically
Max 256-byte packet-length supported
Wake-up function supported
Multi-Function Serial Interface (Max 8channels)
128 bytes with Tx/Rx FIFO in all channels (The number of
FIFO steps varies depending on the settings of the
communication mode or bit length.)
The operation mode of each channel can be selected from
one of the following.
UART
CSIO (CSIO is known to many customers as SPI)
I2C
UART
Full duplex double buffer
Parity can be enabled or disabled.
Built-in dedicated baud rate generator
External clock available as a serial clock
Various error detection functions (parity errors, framing
errors, and overrun errors)
CSIO (also known as SPI)
Full duplex double buffer
Built-in dedicated baud rate generator
Overrun error detection function
Serial chip select function (ch1 and ch3 only)
Data length: 5 to 16 bits
I2C
Standard-mode (Max: 100 kbps) supported / Fast-mode
(Max 400 kbps) supported.
I2S
Using CSIO (ch.5, ch.6) and I2S clock generator
Supports two transfer protocol
I2S
MSB-justified
Master mode only
Cypress Semiconductor Corporation
Document Number: 001-99224 Rev.**
• 198 Champion Court • San Jose, CA 95134-1709 • 408-943-2600
Revised August 31, 2015

1 page




S6E1B36G0A pdf
PRELIMINARY
S6E1B3 Series
Table of Contents
Features................................................................................................................................................................................... 1
1. Product Lineup............................................................................................................................................................... 7
2. Packages......................................................................................................................................................................... 8
3. Pin Assignment .............................................................................................................................................................. 9
4. List of Pin Functions.................................................................................................................................................... 12
5. I/O Circuit Type............................................................................................................................................................. 35
6. Handling Precautions .................................................................................................................................................. 40
6.1 Precautions for Product Design ................................................................................................................................... 40
6.2 Precautions for Package Mounting.............................................................................................................................. 41
6.3 Precautions for Use Environment ................................................................................................................................ 43
7. Handling Devices ......................................................................................................................................................... 44
8. Block Diagram .............................................................................................................................................................. 47
9. Memory Map ................................................................................................................................................................. 48
10. Pin Status in Each CPU State...................................................................................................................................... 51
11. Electrical Characteristics ............................................................................................................................................ 58
11.1 Absolute Maximum Ratings......................................................................................................................................... 58
11.2 Recommended Operating Conditions.......................................................................................................................... 59
11.3 DC Characteristics....................................................................................................................................................... 60
11.3.1 Current Rating.............................................................................................................................................................. 60
11.3.2 Pin Characteristics ....................................................................................................................................................... 65
11.4 AC Characteristics....................................................................................................................................................... 66
11.4.1 Main Clock Input Characteristics.................................................................................................................................. 66
11.4.2 Sub Clock Input Characteristics ................................................................................................................................... 67
11.4.3 Built-in CR Oscillation Characteristics.......................................................................................................................... 68
11.4.4 Operating Conditions of Main PLL (In the Case of Using the Main Clock as the Input Clock of the PLL) .................... 69
11.4.5 Operating Conditions of Main PLL (In the Case of Using the Built-in High-Speed CR Clock as the
Input Clock of the Main PLL) ........................................................................................................................................ 69
11.4.6 Reset Input Characteristics .......................................................................................................................................... 70
11.4.7 Power-on Reset Timing................................................................................................................................................ 70
11.4.8 Base Timer Input Timing .............................................................................................................................................. 71
11.4.9 CSIO/SPI/UART Timing ............................................................................................................................................... 72
11.4.10 External Input Timing................................................................................................................................................ 89
11.4.11 I2C Timing................................................................................................................................................................. 90
11.4.12 I2S Timing ................................................................................................................................................................. 91
11.4.13 Smart Card Interface Characteristics........................................................................................................................ 92
11.4.14 SW-DP Timing.......................................................................................................................................................... 93
11.5 12-bit A/D Converter.................................................................................................................................................... 94
11.6 USB Characteristics .................................................................................................................................................... 97
11.7 Low-Voltage Detection Characteristics...................................................................................................................... 102
11.7.1 Low-Voltage Detection Reset..................................................................................................................................... 102
11.7.2 Low-Voltage Detection Interrupt................................................................................................................................. 103
11.7.3 Low-Voltage Detection Interrupt 2.............................................................................................................................. 104
11.8 Flash Memory Write/Erase Characteristics ............................................................................................................... 105
11.9 Return Time from Low-Power Consumption Mode.................................................................................................... 106
11.9.1 Return Factor: Interrupt/WKUP .................................................................................................................................. 106
11.9.2 Return Factor: Reset.................................................................................................................................................. 108
Document Number: 001-99224 Rev.**
Page 5 of 115

5 Page





S6E1B36G0A arduino
FPT-120P-M21
PRELIMINARY
(TOP VIEW)
S6E1B3 Series
VCC
P50/INT00_0/SIN3_1
P51/INT01_0/SOT3_1
P52/INT02_0/SCK3_1
P53/SIN6_0/TIOA1_2/INT07_2
P54/SOT6_0/TIOB1_2/INT18_1
P55/SCK6_0/ADTG_1/INT19_1
P56/SIN1_0/INT08_2/MI2SMCK6_1/WKUP9/CEC1_1
P57/SOT1_0
P58/SCK1_0
P59/SIN7_0/INT16_1
P5A/SOT7_0/INT16_2
P5B/SCK7_0/INT17_2
P30/TIOB0_1/SCS60_1/INT03_2/MI2SWS6_1/WKUP4
P31/TIOB1_1/SCK6_1/MI2SCK6_1/INT04_2
P32/TIOB2_1/SOT6_1/MI2SDO6_1/INT05_2
P33/INT04_0/TIOB3_1/SIN6_1/MI2SDI6_1/ADTG_6
P34/SCS61_1/FRCK0_0/TIOB4_1
P35/SCS62_1/IC03_0/TIOB5_1/INT08_1
P36/IC02_0/SIN5_2/INT09_1/WKUP11
P37/IC01_0/SOT5_2/INT10_1
P38/IC00_0/SCK5_2/INT11_1
P39/DTTI0X_0/ADTG_2/TIOB4_0/INT06_0
P3A/RTO00_0/TIOA0_1/INT07_0/RTCCO_2/SUBOUT_2/IC1_CIN_0
P3B/RTO01_0/TIOA1_1/IC1_DATA_0
P3C/RTO02_0/TIOA2_1/INT18_2/IC1_RST_0
P3D/RTO03_0/TIOA3_1/IC1_VPEN_0
P3E/RTO04_0/TIOA4_1/INT19_2/IC1_VCC_0/WKUP8
P3F/RTO05_0/TIOA5_1/IC1_CLK_0
VSS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
LQFP - 120
90 VSS
89 P20/AN19/INT05_0/CROUT_0
88 P21/AN18/SIN0_0/INT06_1/WKUP2
87 P22/AN17/SOT0_0/TIOB7_1
86 P23/AN16/SCK0_0/TIOA7_1/RTO00_1
85 P24/SIN2_1/RTO01_1/INT17_1
84 P25/SOT2_1/RTO02_1
83 P26/SCK2_1/RTO03_1
82 P27/AN15/RTO04_1/TIOA6_2/INT02_2
81 P28/ADTG_4/RTO05_1/TIOB6_2
80 P1E/AN14/RTS4_1/ADTG_5/FRCK0_1/INT23_2
79 P1D/AN13/CTS4_1/DTTI0X_1/INT22_2
78 P1C/AN12/SCK4_1/IC03_1/INT21_2
77 P1B/AN11/SOT4_1/IC02_1/INT20_2
76 P1A/AN10/SIN4_1/IC01_1/INT05_1
75 P19/AN09/SCK2_2/IC00_1
74 P18/AN08/SOT2_2
73 AVRH
72 AVRL
71 AVSS
70 AVCC
69 P17/AN07/SIN2_2/INT04_1
68 P16/AN06/SCK0_1/INT15_0
67 P15/AN05/IC1_CIN_1/SOT0_1/IC03_2/INT14_0
66 P14/AN04/IC1_DATA_1/RTS1_1/SIN0_1/INT03_1/IC02_2
65 P13/AN03/IC1_RST_1/SCK1_1/RTCCO_1/IC01_2/SUBOUT_1
64 P12/AN02/IC1_VPEN_1/SOT1_1/IC00_2
63 P11/AN01/IC1_VCC_1/SIN1_1/INT02_1/FRCK0_2/WKUP1
62 P10/AN00/IC1_CLK_1/CTS1_1
61 VCC
Note:
The number after the underscore ("_") in a pin name such as XXX_1 and XXX_2 indicates the relocated port number. The
channel on such pin has multiple functions, each of which has its own pin name. Use the Extended Port Function Register
(EPFR) to select the pin to be used.
Document Number: 001-99224 Rev.**
Page 11 of 115

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet S6E1B36G0A.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
S6E1B36G0AMicrocontrollerCypress Semiconductor
Cypress Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar