DataSheet.es    


PDF NJL6401R-3 Data sheet ( Hoja de datos )

Número de pieza NJL6401R-3
Descripción COBP High Speed Photo Diode
Fabricantes New Japan Radio 
Logotipo New Japan Radio Logotipo



Hay una vista previa y un enlace de descarga de NJL6401R-3 (archivo pdf) en la parte inferior de esta página.


Total 7 Páginas

No Preview Available ! NJL6401R-3 Hoja de datos, Descripción, Manual

NJL6401R-3
COBP High Speed Photo Diode
GENERAL DESCRIPTION
The NJL6401R-3 is a high-speed PIN photodiode capable of detecting in a wide wavelength range of up to
infrared light from the blue-violet light.
The features are low wavelength dependence and fast fall-time.
An ultra-small and thin package of COBP is adopted, and providing high efficient space-saving.
.
FEATURES
Corresponding to three wavelength (=405nm/650nm/780nm)
Short rise-time, fall-time
2ns typ. (=405nm/650nm/780nm, VR=2.5V, 10-90%)
High speed
250MHz ( =780nm)
300MHz ( =650nm)
350MHz ( =405nm)
Miniature, thin package 1.2mmX1.7mmX0.8mm
Active area
0.7mmX0.7mm
APPLICATIONS
Laser monitor for Blu-ray, etc.
Monitor for RGB wavelength
Photoelectric switch, Space light transmitting, etc.
ABSOLUTE MAXIMUM RATINGS (Ta=25C)
PARAMETER
Reverse Voltage
Operating Temperature
Storage Temperature
Reflow Soldering Temperature
SYMBOL
VR
Topr
Tstg
Tsol
RATINGS
35
-30 to +85
-40 to +100
255
UNIT
V
C
C
C
ELECTRO-OPTICAL CHARACTERISTICS (Ta=25C)
PARAMETER
Dark Current
Forward Voltage
Capacitance
Peak Wavelength
Sensitivity
Rise time, Fall time
Cut off Frequency
SYMBOL
ID
VF
Ct
P
S
tr/tf
fc
TEST CONDITION
VR=10V
IF=1mA
VR=2.5V, f=1MHz
VR=2.5V, =780nm
VR=2.5V, =650nm
VR=2.5V, =405nm
VR=2.5V, =780nm, 10-90%, 1mW
VR=2.5V, =650nm, 10-90%, 1mW
VR=2.5V, =405nm, 10-90%, 1mW
VR=2.5V, =780nm, RL=50-3dB
VR=2.5V, =650nm, RL=50-3dB
VR=2.5V, =405nm, RL=50-3dB
MIN TYP MAX UNIT
— 0.1 2.0 nA
— — 1.0 V
— 4 — pF
— 800 — nm
0.37 0.47 — A/W
0.34 0.42 — A/W
0.22 0.28 — A/W
— 2 — ns
— 2 — ns
— 2 — ns
— 250 — MHz
— 300 — MHz
— 350 — MHz
20.June.2014 Rev.2.2
-1-

1 page




NJL6401R-3 pdf
NJL6401R-3
MOUNTING METHOD
NOTE
Mounting was evaluated with the following profiles in our company, so there was no problem.
However, confirm mounting by the condition of your company beforehand.
The exposure of device under higher temperature many affect to the reliability of the products, it is recommended
to complete soldering in the shortest time possible.
Mounting: Twice soldering is allowed.
INFRARED REFLOW SOLDERING METHOD
Recommended reflow soldering procedure
255C
230C
180C
150C
e
a : Temperature ramping rate
b : Pre-heating temperature
time
c : Temperature ramping rate
d : Mounting temperature
time
e : Peak temperature
f : Temperature ramping rate
: 1 to 4C/s
: 150 to 180C
: 60 to 120s
: 1 to 4C /s
: 230C
: 20 to 40s
: Lower than 255C
: 1 to 6C /s
The temperature indicates at the surface
of mold package
Room
Temp.
a
b
cd
f
(NOTE1) Using reflow furnace with short wave infrared radiation heater such as halogen lamp
Regarding temperature profile, please refer to those fo reflow furnace.
In this case the resin surface temperature may become higher than lead terminals due to endothermic ally of black colored
mold resin. Therefore, please avoid from direct exposure to mold resin.
(NOTE2) Other method
Such other methods of soldering as dipping the device into melted solder and vapor phase method (VPS) are not appropriate
because the body of device will be heated rapidly. Therefore, these are not recommended to apply.
(NOTE3) The resin gets softened right after soldering, so, the following care has to be taken
Not to contact the lens surface to anything.
Not to dip the device into water or any solvents.
FLOE SOLDERING METHOD
Flow soldering is not possible.
IRON SOLDERING METHOD
Iron soldering is not possible.
20.June.2014 Rev.2.2
-5-

5 Page










PáginasTotal 7 Páginas
PDF Descargar[ Datasheet NJL6401R-3.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
NJL6401R-3COBP High Speed Photo DiodeNew Japan Radio
New Japan Radio

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar